- 您现在的位置：买卖IC网 > PDF目录5694 > AD8620BRZ-REEL (Analog Devices Inc)IC OPAMP JFET 25MHZ DUAL 8SOIC PDF资料下载
参数资料
| 型号： | AD8620BRZ-REEL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 13/24页 |
| 文件大小： | 0K |
| 描述： | IC OPAMP JFET 25MHZ DUAL 8SOIC |
| 设计资源： | Using AD7328 in Appls with Single-Ended Industrial-Level Signals (CN0047) |
| 标准包装： | 2,500 |
| 放大器类型： | J-FET |
| 电路数： | 2 |
| 转换速率： | 60 V/µs |
| 增益带宽积： | 25MHz |
| 电流 - 输入偏压： | 3pA |
| 电压 - 输入偏移： | 45µV |
| 电流 - 电源： | 3mA |
| 电流 - 输出 / 通道： | 45mA |
| 电压 - 电源，单路/双路(±)： | ±5 V ~ 13 V |
| 工作温度： | -40°C ~ 125°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SO |
| 包装： | 带卷 (TR) |
AD8610/AD8620
Rev. F | Page 20 of 24
High Speed Instrumentation Amplifier
The 3-op-amp instrumentation amplifiers shown in Figure 68 can
provide a range of gains from unity up to 1000 or higher. The
instrumentation amplifier configuration features high common-
mode rejection, balanced differential inputs, and stable, accurately
defined gain. Low input bias currents and fast settling are achieved
with the JFET input AD8610/AD8620. Most instrumentation
amplifiers cannot match the high frequency performance of this
circuit. The circuit bandwidth is 25 MHz at a gain of 1, and close to
5 MHz at a gain of 10. Settling time for the entire circuit is 550 ns to
0.01% for a 10 V step (gain = 10). Note that the resistors around
the input pins need to be small enough in value so that the RC
time constant they form in combination with stray circuit capaci-
tance does not reduce circuit bandwidth.
02
73
0-
0
68
1/2 AD8620
+INB
R2
1k
C2
10pF
R4
2k
C4
15pF
VOUT
R8
2k
R7
2k
R1
1k
C5
10pF
V–
V+
AD8610
U2
C3
15pF
R5
2k
R6
2k
+INA
V–
V+
1/2 AD8620
U1
RG
5
6
7
U1
7
4
6
3
2
8
4
1
3
2
Figure 68. High Speed Instrumentation Amplifier
High Speed Filters
The four most popular configurations are Butterworth, Elliptical,
Bessel (Thompson), and Chebyshev. Each type has a response
that is optimized for a given characteristic, as shown in Table 6.
In active filter applications using operational amplifiers, the dc
accuracy of the amplifier is critical to optimal filter performance.
The offset voltage and bias current of the amplifier contribute to
output error. Input offset voltage is passed by the filter and can
be amplified to produce excessive output offset. For low frequency
applications requiring large value input resistors, bias and offset
currents flowing through these resistors also generate an offset
voltage.
At higher frequencies, the dynamic response of the amplifier
must be carefully considered. In this case, slew rate, bandwidth,
and open-loop gain play a major role in amplifier selection.
The slew rate must be both fast and symmetrical to minimize
distortion. The bandwidth of the amplifier, in conjunction with the
gain of the filter, dictates the frequency response of the filter. The
use of high performance amplifiers, such as the AD8610/AD8620,
minimizes both dc and ac errors in all active filter applications.
Second-Order, Low-Pass Filter
Figure 69 shows the AD8610 configured as a second-order,
Butterworth, low-pass filter. With the values as shown, the
design corner was 1 MHz, and the bench measurement was
974 kHz. The wide bandwidth of the AD8610/AD8620 allows
corner frequencies into the megahertz range, but the input
capacitances should be taken into account by making C1 and
C2 smaller than the calculated values. The following equations
can be used for component selection:
R1 = R2 = User Selected (Typical Values = 10 kΩ to 100 kΩ)
()
()()
R1
f
C1
CUTOFF
π
2
414
.
1
=
()
()()
R1
f
C2
CUTOFF
π
2
707
.
0
=
where C1 and C2 are in farads.
VIN
VOUT
AD8610
7
4
6
1
5
2
3
+13V
–13V
C2
110pF
C1
220pF
027
30
-06
9
R2
1020
R1
1020
U1
Figure 69. Second-Order, Low-Pass Filter
Table 6. Filter Types
Type
Sensitivity
Overshoot
Phase
Amplitude (Pass Band)
Butterworth
Moderate
Good
Maximum flat
Chebyshev
Good
Moderate
Nonlinear
Equal ripple
Elliptical
Best
Poor
Equal ripple
Bessel (Thompson)
Poor
Best
Linear
相关PDF资料 |
PDF描述 |
|---|---|
| 9208BLK | LUG SPADE .250" ISULATED BLACK |
| TV04A600JB-HF | TVS 400W 60V BIDIRECT 5% SMA |
| TV04A5V0JB-HF | TVS 400W 5V BIDIRECT 5% SMA |
| OP37EZ | IC OPAMP GP 63MHZ LN PREC 8DIP |
| TV04A580JB-HF | TVS 400W 58V BIDIRECT 5% SMA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD8620BRZ-REEL7 | 功能描述:IC OPAMP JFET 25MHZ DUAL 8SOIC RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:Excalibur™ 放大器类型:J-FET 电路数:1 输出类型:- 转换速率:45 V/µs 增益带宽积:10MHz -3db带宽:- 电流 - 输入偏压:20pA 电压 - 输入偏移:490µV 电流 - 电源:1.7mA 电流 - 输出 / 通道:48mA 电压 - 电源，单路/双路(±):4.5 V ~ 38 V，±2.25 V ~ 19 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商设备封装:8-SOIC 包装:带卷 (TR) |
| AD8622 | 制造商:AD 制造商全称:Analog Devices 功能描述:Dual, Low Power, Low Noise, Low Bias Current Precision Rail-to-Rail Output Op Amp |
| AD8622_09 | 制造商:AD 制造商全称:Analog Devices 功能描述:Dual, Low Power, Precision Rail-to-Rail Output Op Amp |
| AD8622ARMZ | 功能描述:IC OPAMP GP R-R 540KHZ LP 8MSOP RoHS:是 类别:集成电路 (IC) >> Linear - Amplifiers - Instrumentation 系列:- 标准包装:2,500 系列:- 放大器类型:通用 电路数:4 输出类型:- 转换速率:0.6 V/µs 增益带宽积:1MHz -3db带宽:- 电流 - 输入偏压:45nA 电压 - 输入偏移:2000µV 电流 - 电源:1.4mA 电流 - 输出 / 通道:40mA 电压 - 电源，单路/双路(±):3 V ~ 32 V，±1.5 V ~ 16 V 工作温度:0°C ~ 70°C 安装类型:表面贴装 封装/外壳:14-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:14-TSSOP 包装:带卷 (TR) 其它名称:LM324ADTBR2G-NDLM324ADTBR2GOSTR |
| AD8622ARMZ | 制造商:Analog Devices 功能描述:OP-AMP, PRECISION, 560KHZ, 0.48V/us, MSO |
发布紧急采购，3分钟左右您将得到回复。