参数资料
| 型号： | AD9814JR |
| 厂商： | Analog Devices Inc |
| 文件页数： | 15/15页 |
| 文件大小： | 0K |
| 描述： | IC CCD SIGNAL PROC 14BIT 28-SOIC |
| 标准包装： | 27 |
| 类型： | CCD 信号处理器，14 位 |
| 输入类型： | 逻辑 |
| 输出类型： | 逻辑 |
| 接口： | 3 线串口 |
| 电流 - 电源： | 80mA |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC W |
| 包装： | 管件 |
REV. 0
AD9814
–9–
FUNCTIONAL DESCRIPTION
The AD9814 can be operated in four different modes: 3-Channel
CDS Mode, 3-Channel SHA Mode, 1-Channel CDS Mode,
and 1-Channel SHA Mode. Each mode is selected by program-
ming the Configuration Register through the serial interface.
For more detail on CDS or SHA mode operation, see the
Circuit Operation section.
3-Channel CDS Mode
In 3-Channel CDS Mode, the AD9814 simultaneously samples
the red, green and blue input voltages from the CCD outputs.
The sampling points for each Correlated Double Sampler (CDS)
are controlled by CDSCLK1 and CDSCLK2 (see Figures 8 and
9). CDSCLK1’s falling edge samples the reference level of the
CCD waveform. CDSCLK2’s falling edge samples the data
level of the CCD waveform. Each CDS amplifier outputs the
difference between the CCD’s reference and data levels. Next,
the output voltage of each CDS amplifier is level-shifted by an
Offset DAC. The voltages are then scaled by the three Program-
mable Gain Amplifiers before being multiplexed through the
14-bit ADC. The ADC sequentially samples the PGA outputs
on the falling edges of ADCCLK.
The offset and gain values for the red, green and blue channels
are programmed using the serial interface. The order in which
the channels are switched through the multiplexer is selected by
programming the MUX register.
Timing for this mode is shown in Figure 1. It is recommended
that the falling edge of CDSCLK2 occur coincident with or
before the rising edge of ADCCLK, although this is not re-
quired to satisfy the minimum timing constraints. The rising
edge of CDSCLK2 should not occur before the previous falling
edge of ADCCLK, as shown by tADC2. The output data latency
is three clock cycles.
3-Channel SHA Mode
In 3-Channel SHA Mode, the AD9814 simultaneously samples
the red, green and blue input voltages. The sampling point is
controlled by CDSCLK2. CDSCLK2’s falling edge samples the
input waveforms on each channel. The output voltages from the
three SHAs are modified by the offset DACs and then scaled by
the three PGAs. The outputs of the PGAs are then multiplexed
through the 14-bit ADC. The ADC sequentially samples the
PGA outputs on the falling edges of ADCCLK.
The input signal is sampled with respect to the voltage applied
to the OFFSET pin (see Figure 10). With the OFFSET pin
grounded, a zero volt input corresponds to the ADC’s zero-scale
output. The OFFSET pin may also be used as a coarse offset
adjust pin. A voltage applied to this pin will be subtracted from
the voltages applied to the red, green and blue inputs in the first
amplifier stage of the AD9814. The input clamp is disabled in this
mode. For more information, see the Circuit Operation section.
Timing for this mode is shown in Figure 2. CDSCLK1 should
be grounded in this mode. Although not required, it is recom-
mended that the falling edge of CDSCLK2 occur coincident
with or before the rising edge of ADCCLK. The rising edge of
CDSCLK2 should not occur before the previous falling edge of
ADCCLK, as shown by tADC2. The output data latency is three
ADCCLK cycles.
The offset and gain values for the red, green and blue channels
are programmed using the serial interface. The order in which
the channels are switched through the multiplexer is selected by
programming the MUX register.
1-Channel CDS Mode
This mode operates in the same way as the 3-Channel CDS
mode. The difference is that the multiplexer remains fixed in
this mode, so only the channel specified in the MUX register is
processed.
Timing for this mode is shown in Figure 3. Although not re-
quired, it is recommended that the falling edge of CDSCLK2
occur coincident with or before the rising edge of ADCCLK.
1-Channel SHA Mode
This mode operates in the same way as the 3-Channel SHA
mode, except that the multiplexer remains stationary. Only the
channel specified in the MUX register is processed.
The input signal is sampled with respect to the voltage applied
to the OFFSET pin. With the OFFSET pin grounded, a zero
volt input corresponds to the ADC’s zero scale output. The
OFFSET pin may also be used as a coarse offset adjust pin. A
voltage applied to this pin will be subtracted from the voltages
applied to the red, green and blue inputs in the first amplifier
stage of the AD9814. The input clamp is disabled in this mode.
For more information, see the Circuit Operation section.
Timing for this mode is shown in Figure 4. CDSCLK1 should
be grounded in this mode of operation. Although not required,
it is recommended that the falling edge of CDSCLK2 occur
coincident with or before the rising edge of ADCCLK.
相关PDF资料 |
PDF描述 |
|---|---|
| AD9823KRUZRL7 | IC CDS FOR DGTL CAMERA 14-TSSOP |
| AD9824KCPZRL | IC CCD SIGNAL PROC 14BIT 48LFCSP |
| AD9826KRSZRL | IC IMAGE SGNL PROC 16BIT 28-SSOP |
| AD9830ASTZ-REEL | IC DDS 10BIT 50MHZ CMOS 48TQFP |
| AD9832BRU-REEL | IC DDS 10BIT 25MHZ CMOS 16-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AD9814JRRL | 功能描述:IC CCD SIGNAL PROC 14BIT 28-SOIC RoHS:否 类别:集成电路 (IC) >> 接口 - 传感器和探测器接口 系列:- 其它有关文件:Automotive Product Guide 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:74 系列:- 类型:触控式传感器 输入类型:数字 输出类型:数字 接口:JTAG，串行 电流 - 电源:100µA 安装类型:表面贴装 封装/外壳:20-TSSOP（0.173"，4.40mm 宽） 供应商设备封装:20-TSSOP 包装:管件 |
| AD9814KR | 制造商:Analog Devices 功能描述:AFE Video 1ADC 14-Bit 5V 28-Pin SOIC W 制造商:Analog Devices 功能描述:14 BIT 6 MSPS SCANNER ANALOG FRONT END - Rail/Tube 制造商:Rochester Electronics LLC 功能描述:14 BIT 6 MSPS SCANNER ANALOG FRONT END - Bulk |
| AD9814KRRL | 制造商:Analog Devices 功能描述:AFE Video 1ADC 14-Bit 5V 28-Pin SOIC W 制造商:Analog Devices 功能描述:14 BIT 6 MSPS SCANNER ANALOG FRONT END - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:14 BIT 6 MSPS SCANNER ANALOG FRONT END - Bulk |
| AD9814S | 制造商:AD 制造商全称:Analog Devices 功能描述:14-Bit CCD/CIS Signal Processor |
| AD9816 | 制造商:AD 制造商全称:Analog Devices 功能描述:Complete 12-Bit 6 MSPS CCD/CIS Signal Processor |
发布紧急采购，3分钟左右您将得到回复。