参数资料
| 型号： | ADA4433-1BCPZ-R7 |
| 厂商： | Analog Devices Inc |
| 文件页数： | 3/16页 |
| 文件大小： | 0K |
| 描述： | IC SD VIDEO FILTER 8LFCSP |
| 标准包装： | 1 |
| 应用： | 重构滤波器 |
| 输出类型： | 差分 |
| 电路数： | 1 |
| -3db带宽： | 9.9MHz |
| 电流 - 电源： | 13.2mA |
| 电流 - 输出 / 通道： | 29mA |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 3.6 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-WFDFN 裸露焊盘，CSP |
| 供应商设备封装： | 8-LFCSP-VD（3x3） |
| 包装： | 标准包装 |
| 其它名称： | ADA4433-1BCPZ-R7DKR |
Data Sheet
ADA4433-1
Rev. 0 | Page 11 of 16
ESD PROTECTION
All pins on the ADA4433-1 are protected with internal ESD
protection structures connected to the power supply pins (+VS
and GND). These structures provide protection during the
handling and manufacturing process.
The outputs (+OUT and OUT) can be exposed to dc voltages
well above the supply voltage in an overvoltage event; therefore,
conventional ESD structure protection cannot be used. Instead,
the outputs are protected by Analog Devices proprietary ESD
devices, which allow protection and recovery from an overvoltage
event while providing ESD protection well beyond the handling
and manufacturing requirements.
ENABLE/DISABLE MODES (ENA PIN)
The power-down or enable/disable (ENA) pin is internally pulled
up to +VS through a 250 k resistor. When the voltage on this
pin is high, the amplifier is enabled; pulling ENA low disables
the ADA4433-1, reducing the supply current to a very low 13.5 A.
With no external connection, this pin floats high, enabling the
amplifier.
Table 6. ENA Pin Function
ENA Pin Input
Device State
High (Logic 1)
Enabled
Low (Logic 0)
Disabled
High-Z (Floating)
Enabled
OPERATING SUPPLY VOLTAGE RANGE
The ADA4433-1 is specified over an operating supply voltage
range of 2.7 V to 3.6 V. This range establishes the nominal
utilization voltage at which the device performs in conformance
with its specifications. The operating supply voltage refers to
sustained voltage levels and not to a momentary voltage
excursion that can occur due to variation in the output of the
supply regulator. When the device is operating at the limits of the
operating supply voltage range (2.7 V and 3.6 V), excursions
lower than the minimum of 2.7 V and higher the maximum of
3.6 V must be no greater than 4%. Supply voltage excursions
greater than 4% (but less than the absolute maximum) can lead
to some performance degradation; however, they do not damage
the device.
相关PDF资料 |
PDF描述 |
|---|---|
| ADA4853-2YCPZ-R2 | IC OPAMP VIDEO DUAL 16-LFCSP |
| ADA4856-3YCPZ-R2 | IC AMP 3CH RRO VFB G=+2 16LFCSP |
| ADA4859-3ACPZ-RL | IC AMP 3CH CFB G=2 W/CP 16LFCSP |
| ADA4922-1ACPZ-R2 | IC ADC DRIVER 18BIT DIFF 8-LFCSP |
| ADA4937-2YCPZ-RL | IC ADC DRIVER DUAL DIFF 24LFCSP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADA4433-1WBCPZ-R7 | 制造商:AD 制造商全称:Analog Devices 功能描述:SD Video Filter Amplifiers |
| ADA4500-2 | 制造商:AD 制造商全称:Analog Devices 功能描述:8.7MHz, 15nV/√Hz, Rail-to-Rail I/O |
| ADA4500-2_12 | 制造商:AD 制造商全称:Analog Devices 功能描述:10 MHz, 14.5 nV/a??Hz, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier |
| ADA4500-2_13 | 制造商:AD 制造商全称:Analog Devices 功能描述:10 MHz, 14.5 nV/a??Hz, Rail-to-Rail I/O, Zero Input Crossover Distortion Amplifier |
| ADA4500-2ACPZ-R7 | 制造商:Analog Devices 功能描述:DUAL HIGH PERFORMANCE ZCO OP AMP - Tape and Reel 制造商:Analog Devices 功能描述:IC OPAMP GP 10MHZ RRO 8LFCSP 制造商:Analog Devices 功能描述:DUAL High Performance ZCO Op Amp |
发布紧急采购，3分钟左右您将得到回复。