- 您现在的位置：买卖IC网 > Datasheet目录307 > ADD5205ACPZ-RL (Analog Devices Inc)IC LED DVR WHITE BCKLGT 12LFCSP Datasheet资料下载
参数资料
| 型号： | ADD5205ACPZ-RL |
| 厂商： | Analog Devices Inc |
| 文件页数： | 10/16页 |
| 文件大小： | 0K |
| 描述： | IC LED DVR WHITE BCKLGT 12LFCSP |
| 标准包装： | 1 |
| 恒定电流： | 是 |
| 拓扑： | PWM，升压（升压） |
| 输出数： | 4 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 1MHz |
| 电源电压： | 2.8 V ~ 18 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 12-LFCSP-WQ（3x3） |
| 包装： | 标准包装 |
| 工作温度： | -25°C ~ 85°C |
| 其它名称： | ADD5205ACPZ-RLDKR |
ADD5205
THEORY OF OPERATION
CURRENT MODE, STEPUP SWITCHING
REGULATOR OPERATION
The ADD5205 uses a current mode PWM boost regulator to
provide the minimal voltage needed to enable the LED string at
the programmed LED current. The current mode regulation
system allows fast transient response while maintaining a stable
output voltage. The regulator response can be optimized for a
wide range of input voltages, output voltages, and load conditions.
The ADD5205 can provide a 28 V fixed overvoltage protection
voltage and drive up to 6 LEDs (3.4 V/20 mA type of LEDs) for
Data Sheet
PWM DIMMING MODE
The ADD5205 supports PWM input. The internal resistor and
external capacitor change the PWM input duty to analog level,
and the low-pass filter output adjusts each current source sink
current level.
DC Current Dimming
In this mode, the maximum LED current is set by the value of R SET .
Once the maximum LED current is set, the LED current can be
changed through PWM input.
four channels from a supply of 3 V or up to 7 LEDs (3.4 V/20 mA
DUTY = 80%
DUTY = 60%
DUTY = 40%
DUTY = 20%
type of LEDs) for four channels from a supply of 5 V to 18 V.
PWMI
CURRENT SOURCE
The ADD5205 contains four current sources to provide accurate
current sinking for each LED string. String-to-string tolerance
I LED MAX
I LED
0.8 × I LED MAX
0.6 × I LED MAX
0.4 × I LED MAX
0.2 × I LED MAX
is kept within ±2% at 20 mA. Each LED string current is adjusted
up to 25 mA by an external resistor.
The ADD5205 contains an LED open fault protection circuit for
each channel. The ADD5205 recognizes that the current source
has an open load fault for the current source, and the current
source is disabled.
Programming the LED Current
As shown in Figure 2, the ADD5205 has an LED current set pin
(ISET). A resistor (R SET ) from this pin to ground adjusts the
LED current up to 25 mA (see Figure 15). LED current level can
be set by
0A
Figure 14. DC Current Dimming Timing
SAFETY FEATURES
The ADD5205 contains several safety features to provide stable
operation, such as soft start, open load protection (OLP), under-
voltage lockout (UVLO), and thermal protection.
Soft Start
The ADD5205 contains an internal soft start function to reduce
inrush current at startup. The soft start time is typically 1.5 ms.
OLP
I LED =
2600
R SET
( A )
The ADD5205 contains a headroom control circuit to minimize
power loss at each current source. Therefore, the minimum feed-
back voltage is achieved by regulating the output voltage of the
boost converter. If any LED string is open during normal operation,
the current source headroom voltage (V HR ) is pulled to GND. In
this condition, OLP is activated.
UVLO
An undervoltage lockout circuit is included with built-in hysteresis.
The ADD5205 turns on when V IN rises above 2.5 V (typical) and
shuts down when V IN falls below 2 V (typical).
Thermal Protection
Thermal overload protection prevents excessive power dissipation
from overheating the ADD5205 . When the junction temperature
(T J ) exceeds 160°C, a thermal sensor immediately activates the
fault protection, which shuts down the device, allowing the IC to
cool. The device self starts when the T J of the die falls below 130°C.
Rev. 0 | Page 10 of 16
相关PDF资料 |
PDF描述 |
|---|---|
| ADE5566ASTZF62-RL | IC ENERGY METERING 1PHASE 64LQFP |
| ADE7156ASTZF16 | IC ENERGY METER 64-LQFP |
| ADE7156ASTZF8-RL | IC ENERGY METER 64-LQFP |
| ADE7518ASTZF8-RL | IC ENERGY METER MCU 8K 64LQFP |
| ADE7569ASTZF16 | IC ENERGY METER MCU 16K 64LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADD5207 | 制造商:AD 制造商全称:Analog Devices 功能描述:Four-String, White LED Driver |
| ADD52070001CPZR | 功能描述:IC LED DRIVER REGULATOR DIM 制造商:analog devices inc. 系列:* 零件状态:上次购买时间 标准包装:1 |
| ADD5207ACPZ | 制造商:Analog Devices 功能描述:DRIVER LED 1MHZ 36V 14LFCSP 制造商:Analog Devices 功能描述:DRIVER, LED, 1MHZ, 36V, 14LFCSP 制造商:Analog Devices 功能描述:DRIVER, LED, 1MHZ, 36V, 14LFCSP, Topology:Boost (Step Up), No. of Outputs:1, Out 制造商:Analog Devices 功能描述:DRIVER, LED, 1MHZ, 36V, 14LFCSP, Topology:Boost (Step Up), No. of Outputs:1, Output Voltage:36V, Driver Case Style:LFCSP, Input Voltage Min:6V, Input Voltage Max:21V, Dimming Control Type:PWM, Switching Frequency:1MHz, Operating , RoHS Compliant: Yes |
| ADD5207ACPZ-RL | 功能描述:IC LED DVR PHASE SHIFT 14LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND |
| ADD5207XCPZ-RL | 功能描述:IC LED DRIVER REGULATOR DIM 制造商:analog devices inc. 系列:* 零件状态:上次购买时间 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。