- 您现在的位置：买卖IC网 > PDF目录20633 > ADE7762ARWZ (Analog Devices Inc)IC ENERGY METERING 3PHASE 28SOIC PDF资料下载
参数资料
| 型号： | ADE7762ARWZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 23/28页 |
| 文件大小： | 0K |
| 描述： | IC ENERGY METERING 3PHASE 28SOIC |
| 标准包装： | 27 |
| 输入阻抗： | 410 千欧 |
| 测量误差： | 0.1% |
| 电压 - 高输入/输出： | 2.4V |
| 电压 - 低输入/输出： | 0.8V |
| 电流 - 电源： | 8.5mA |
| 电源电压： | 4.75 V ~ 5.25 V |
| 测量仪表类型： | 3 相 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 28-SOIC（0.295"，7.50mm 宽） |
| 供应商设备封装： | 28-SOIC W |
| 包装： | 管件 |
| 配用： | EVAL-ADE7762EBZ-ND - BOARD EVALUATION FOR ADE7762 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页当前第23页第24页第25页第26页第27页第28页
ADE7762
TRANSFER FUNCTION
FREQUENCY OUTPUTS F1 AND F2
The ADE7762 calculates the product of six voltage signals (on
current channel and voltage channel) and then low-pass filters
this product to extract active power information. This active
power information is then converted to a frequency. The
Example 1
In this example, with ac voltages of ±500 mV peak applied to
the voltage channels and current channels, the expected output
frequency is calculated as follows:
f 1 to 7 = 0 . 56 Hz , SCF = S0 = S1 = 1
= 500 mV peak ac =
V REF = 2 . 4 V ( nominal reference value )
frequency information is output on F1 and F2 in the form of
active high pulses. The pulse rate at these outputs is relatively
low, for example, 2.09 Hz maximum for ac signals with SCF =
S0 = 0; S1 = 1 (see Table 6). This means that the frequency at
these outputs is generated from active power information
V AN = V BN = V CN = IA = IB = IC
0 . 5
V rms
2
(13)
6 . 313 × ( V AN × I A + V BN × I B + V CN × I C ) × f 1 to 7
Freq =
V REF
accumulated over a relatively long period. The result is an
output frequency that is proportional to the average active
power. The averaging of the active power signal is implicit to
the digital-to-frequency conversion. The output frequency or
pulse rate is related to the input voltage signals by the following
equation:
2
(12)
where:
Freq is the output frequency on F1 and F2 (Hz).
V AN , V BN , and V CN are the differential rms voltage signal on
voltage channels (V).
I A , I B , and I C are the differential rms voltage signal on current
channels (V).
V REF is the reference voltage (2.4 V ± 8%) (V).
f 1 to 7 is one of seven possible frequencies selected by using the
logic inputs SCF, S0, and S1 (see Table 5).
Note that if the on-chip reference is used, actual output fre-
quencies can vary from device to device due to a reference
tolerance of ±8%.
6 . 313 × 0 . 5 × 0 . 5 × 0 . 58
Freq = 3 × = 0 . 230 Hz (14)
2 × 2 × 2 . 4 2
As can be seen from these two example calculations, the maximum
output frequency for ac inputs is always half of that for dc input
signals. The maximum frequency also depends on the number
of phases connected to the ADE7762. In a 3-phase, 3-wire delta
service, the maximum output frequency is different from the maxi-
mum output frequency in a 3-phase, 4-wire Wye service. The
reason is that there are only two phases connected to the analog
inputs, but also that in a delta service, the current channel input
and voltage channel input of the same phase are not in phase in
normal operation.
Example 2
In this example, the ADE7762 is connected to a 3-phase, 3-wire
delta service as shown in Figure 18. The total active energy
calculation processed in the ADE7762 can be expressed as
Table 5. f 1 to 7 Frequency Selection 1
Total Active Power = ( V A ? V C ) × I A + ( V B ? V C ) × I B
(15)
SCF
0
1
0
1
0
1
0
S1
0
0
0
0
1
1
1
S0
0
0
1
1
0
0
1
f 1 to 7 (Hz)
2.24
4.49
1.12
4.49
5.09
1.12
0.56
where:
V A , V B , and V C represent the voltage on Phase A, Phase B, and
Phase C, respectively.
I A and I B represent the current on Phase A and Phase B,
respectively.
With respect to the voltage and current inputs in Equation 7
and Equation 8, the total active power (P) is
P = ( V A ? V C ) × ( I AP ? I AN ) + ( V B ? V C ) × ( I BP ? I BN )
P = ? 2 × V A × cos ( ω l t ) ? 2 × V C × cos ? ? ω l t +
? ? ×
1
1 1 1 0.56
f 1 to 7 is a fraction of the master clock and therefore varies if the specified
CLKIN frequency is altered.
?
2 × I A × cos ( ω l t ) +
? ?
4 π ? ?
3 ? ?
? 2 × V B × cos ? ω l t +
? ? v 2 × V C × cos ? ω l t +
4 π ? ?
? ? ×
? ?
? ?
2 π ? ?
3 ? ?
3 ? ?
2 × I B × cos ? ? ω l t +
2 π ?
3 ?
?
?
(16)
Rev. 0 | Page 23 of 28
相关PDF资料 |
PDF描述 |
|---|---|
| GEM24DTMD | CONN EDGECARD 48POS R/A .156 SLD |
| SS1P5L-E3/85A | DIODE SCHOTTKY 1A 50V SMP |
| ESA50DTBD-S664 | CONN EDGECARD 100PS R/A .125 SLD |
| ADE7769ARZ | IC ENERGY METERING 1PHASE 16SOIC |
| MBRB60H100CTT4G | DIODE SCHOTTKY 100V 30A H D2PAK |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADE7762ARWZ-RL | 功能描述:IC ENERGY METERING 3PHASE 28SOIC RoHS:是 类别:集成电路 (IC) >> PMIC - 能量测量 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:2,500 系列:* |
| ADE7763 | 制造商:AD 制造商全称:Analog Devices 功能描述:Single-Phase Active and Apparent Energy Metering IC |
| ADE7763_13 | 制造商:AD 制造商全称:Analog Devices 功能描述:Single-Phase Active and Apparent Energy Metering IC |
| ADE7763ARS | 制造商:Analog Devices 功能描述:Energy Measurement 20-Pin SSOP 制造商:Rochester Electronics LLC 功能描述:1 PHASE ACTIVE AND APPARENT ENERGY IC - Bulk |
| ADE7763ARSRL | 制造商:Analog Devices 功能描述:Energy Measurement 20-Pin SSOP T/R |
发布紧急采购，3分钟左右您将得到回复。