参数资料
| 型号： | ADG715BRU |
| 厂商： | Analog Devices Inc |
| 文件页数： | 4/16页 |
| 文件大小： | 0K |
| 描述： | IC SWITCH OCTAL SPST 24TSSOP |
| 产品培训模块： | Switch Fundamentals |
| 标准包装： | 62 |
| 功能： | 开关 |
| 电路： | 8 x SPST - NO |
| 导通状态电阻： | 4.5 欧姆 |
| 电压电源： | 单/双电源 |
| 电压 - 电源，单路/双路(±)： | 2.7 V ~ 5.5 V，±2.5V |
| 电流 - 电源： | 10µA |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 24-TSSOP |
| 包装： | 管件 |
ADG714/ADG715
–12–
REV.
FREQUENCY – Hz
30k
ATTENUATION
–
dB
–90
–80
–60
–40
100k
1M
10M
100M
VDD = 5V
TA = 25 C
–100
–70
–50
TPC 13. Crosstalk vs. Frequency
VOLTAGE – V
–3
TA = 25 C
10
0
–20
Q
INJ
–
pC
VDD = +2.5V
VSS = –2.5V
VDD = +3.3V
VSS = GND
–15
–10
–5
5
–2
–1
0
1
2
3
4
5
VDD = +5V
VSS = GND
TPC 14. Charge Injection vs. Source/Drain Voltage
TEMPERATURE – C
TIME
–
ns
10
20
30
70
40
45
40
60
50
VSS = GND
80
35
30
25
20
15
10
5
0
TON, VDD = 5V
TOFF, VDD = 3V
TOFF, VDD = 5V
TON, VDD = 3V
TPC 15. TON/TOFF Times vs. Temperature for ADG714
GENERAL DESCRIPTION
The ADG714 and ADG715 are serially controlled, octal SPST
switches, controlled by either a 2- or 3-wire interface. Each bit
of the 8-bit serial word corresponds to one switch of the part. A
Logic 1 in the particular bit position turns on the switch, while a
Logic 0 turns the switch off. Because each switch is independently
controlled by an individual bit, this provides the option of having
any, all, or none of the switches ON.
When changing the switch conditions, a new 8-bit word is writ-
ten to the input shift register. Some of the bits may be the same
as the previous write cycle, as the user may not wish to change
the state of some switches. To minimize glitches on the output
of these switches, the part cleverly compares the state of switches
from the previous write cycle. If the switch is already in the
ON condition, and is required to stay ON, there will be minimal
glitches on the output of the switch.
POWER-ON RESET
On power-up of the device, all switches will be in the OFF con-
dition and the internal shift register is lled with zeros and will
remain so until a valid write takes place.
SERIAL INTERFACE
3-Wire Serial Interface
The ADG714 has a 3-wire serial interface (
SYNC, SCLK, and
DIN), that is compatible with SPI, QSPI, MICROWIRE
interface standards and most DSPs. Figure 1 shows the tim-
ing diagram of a typical write sequence.
Data is written to the 8-bit shift register via DIN under the con-
trol of the
SYNC and SCLK signals. Data may be written to
the shift register in more or less than eight bits. In each case
the shift register retains the last eight bits that were written.
When
SYNC goes low, the input shift register is enabled. Data
from DIN is clocked into the shift register on the falling edge of
SCLK. Each bit of the 8-bit word corresponds to one of the eight
switches. Figure 3 shows the contents of the input shift register.
Data appears on the DOUT pin on the rising edge of SCLK
suitable for daisy chaining, delayed of course by eight bits. When
all eight bits have been written into the shift register, the
SYNC
line is brought high again. The switches are updated with the
new conguration and the input shift register is disabled. With
SYNC held high, the input shift register is disabled, so further data
or noise on the DIN line will have no effect on the shift register.
S8
S7
S6
S5
S4
S3
S2
S1
DB7 (MSB)
DB0 (LSB)
DATA BITS
Figure 3. Input Shift Register Contents
SERIAL INTERFACE
2-Wire Serial Interface
The ADG715 is controlled via an I
2C-compatible serial bus.
This device is connected to the bus as a slave device (no clock is
generated by the switch).
The ADG715 has a 7-bit slave address. The ve MSBs are 10010
and the two LSBs are determined by the state of the A0 and
A1 pins.
C
相关PDF资料 |
PDF描述 |
|---|---|
| ADG719SRJZ-EP-R2 | IC SW/MUX 2:1 SPDT CMOS |
| ADG719SRJZ-EP-RL7 | IC SWITCH MONOLITHIC CMOS SPDT |
| ADG723BRM-REEL | IC SWITCH DUAL SPST 8MSOP |
| ADG725BSUZ | IC MULTIPLEXER DUAL 16X1 48TQFP |
| ADG728BRUZ-REEL | IC MUX/DEMUX 8X1 16TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADG715BRU-REEL | 功能描述:IC SWITCH OCTAL SPST 24TSSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 标准包装:1,000 系列:- 功能:多路复用器 电路:1 x 4:1 导通状态电阻:- 电压电源:双电源 电压 - 电源，单路/双路(±):±5V 电流 - 电源:7mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| ADG715BRU-REEL7 | 功能描述:IC SWITCH OCTAL SPST 24TSSOP RoHS:否 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 标准包装:1,000 系列:- 功能:多路复用器 电路:1 x 4:1 导通状态电阻:- 电压电源:双电源 电压 - 电源，单路/双路(±):±5V 电流 - 电源:7mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| ADG715BRUZ | 功能描述:IC SWITCH OCTAL SPST 24TSSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 特色产品:MicroPak? 标准包装:1 系列:- 功能:开关 电路:2 x SPST - NC 导通状态电阻:500 毫欧 电压电源:单电源 电压 - 电源，单路/双路(±):1.4 V ~ 4.3 V 电流 - 电源:150nA 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:8-XFDFN 供应商设备封装:8-XSON，SOT833-1 （1.95x1） 包装:Digi-Reel® 其它名称:568-5557-6 |
| ADG715BRUZ-REEL | 功能描述:IC SWITCH OCTAL SPST 24TSSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 标准包装:1,000 系列:- 功能:多路复用器 电路:1 x 4:1 导通状态电阻:- 电压电源:双电源 电压 - 电源，单路/双路(±):±5V 电流 - 电源:7mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
| ADG715BRUZ-REEL7 | 功能描述:IC SWITCH OCTAL SPST 24TSSOP RoHS:是 类别:集成电路 (IC) >> 接口 - 模拟开关，多路复用器，多路分解器 系列:- 标准包装:1,000 系列:- 功能:多路复用器 电路:1 x 4:1 导通状态电阻:- 电压电源:双电源 电压 - 电源，单路/双路(±):±5V 电流 - 电源:7mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:16-SOIC（0.154"，3.90mm 宽） 供应商设备封装:16-SOIC 包装:带卷 (TR) |
发布紧急采购，3分钟左右您将得到回复。