- 您现在的位置：买卖IC网 > PDF目录15309 > ADM1065ACPZ (Analog Devices Inc)IC SEQUENCER/SUPERVISOR 40-LFCSP PDF资料下载
参数资料
| 型号： | ADM1065ACPZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 11/28页 |
| 文件大小： | 0K |
| 描述： | IC SEQUENCER/SUPERVISOR 40-LFCSP |
| 标准包装： | 1 |
| 系列： | Super Sequencer® |
| 类型： | 序列发生器 |
| 监视电压数目： | 10 |
| 输出： | 可编程 |
| 电压 - 阀值： | 可调节/可选择 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 40-VFQFN 裸露焊盘，CSP |
| 供应商设备封装： | 40-LFCSP-VQ（6x6） |
| 包装： | 托盘 |
| 配用： | EVAL-ADM1065TQEBZ-ND - BOARD EVALUATION FOR ADM1065TQ |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
ADM1065
POWERING THE ADM1065
The ADM1065 is powered from the highest voltage input on either
the positive-only supply inputs (VPx) or the high voltage supply
input (VH). This technique offers improved redundancy because
the device is not dependent on any particular voltage rail to keep it
operational. The same pins are used for supply fault detection
(see the Supply Supervision section). A V DD arbitrator on the
device chooses which supply to use. The arbitrator can be
When two or more supplies are within 100 mV of each other,
the supply that first takes control of V DD keeps control. For
example, if VP1 is connected to a 3.3 V supply, V DD powers up
to approximately 3.1 V through VP1. If VP2 is then connected
to another 3.3 V supply, VP1 still powers the device unless VP2
goes 100 mV higher than VP1.
VDDCAP
considered an OR’ing of five low dropout regulators (LDOs)
together. A supply comparator chooses the highest input to
provide the on-chip supply. There is minimal switching loss with
this architecture (~0.2 V), resulting in the ability to power the
ADM1065 from a supply as low as 3.0 V. Note that the supply on
the VXx pins cannot be used to power the device.
VP1
VP2
VP3
IN
EN
IN
EN
IN
OUT
4.75V
LDO
OUT
4.75V
LDO
OUT
An external capacitor to GND is required to decouple the on-chip
supply from noise. This capacitor should be connected to the
EN
4.75V
LDO
VDDCAP pin, as shown in Figure 15. The capacitor has another
VP4
IN
OUT
4.75V
use during brownouts (momentary loss of power). Under these
conditions, when the input supply (VPx or VH) dips transiently
below V DD , the synchronous rectifier switch immediately turns
off so that it does not pull V DD down. The V DD capacitor can
VH
EN
IN
EN
LDO
OUT
4.75V
LDO
INTERNAL
DEVICE
SUPPLY
then act as a reservoir to keep the device active until the next
highest supply takes over the powering of the device. A 10 μF
capacitor is recommended for this reservoir/decoupling function.
The VH input pin can accommodate supplies up to 14.4 V, which
allows the ADM1065 to be powered using a 12 V backplane supply.
In cases where this 12 V supply is hot swapped, it is recommended
that the ADM1065 not be connected directly to the supply. Suitable
precautions, such as the use of a hot swap controller, should be
taken to protect the device from transients that could cause
damage during hot swap events.
Rev. D | Page 11 of 28
SUPPLY
COMPARATOR
Figure 15. V DD Arbitrator Operation
相关PDF资料 |
PDF描述 |
|---|---|
| EEC49DRTN-S93 | CONN EDGECARD 98POS DIP .100 SLD |
| VI-2WK-EW-F1 | CONVERTER MOD DC/DC 40V 100W |
| VI-2WJ-EW-F4 | CONVERTER MOD DC/DC 36V 100W |
| VI-2WJ-EW-F3 | CONVERTER MOD DC/DC 36V 100W |
| IMC1210BN27NJ | INDUCTOR WW 27NH 5% 1210 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADM1065ASU | 制造商:AD 制造商全称:Analog Devices 功能描述:Super Sequencer-TM and Monitor |
| ADM1065ASU-REEL | 制造商:AD 制造商全称:Analog Devices 功能描述:Super Sequencer-TM and Monitor |
| ADM1065ASU-REEL7 | 制造商:AD 制造商全称:Analog Devices 功能描述:Super Sequencer-TM and Monitor |
| ADM1065ASUZ | 功能描述:IC SEQUENCER/MONITOR 48-TQFP RoHS:是 类别:集成电路 (IC) >> PMIC - 监控器 系列:Super Sequencer® 标准包装:1 系列:- 类型:简单复位/加电复位 监视电压数目:1 输出:开路漏极或开路集电极 复位:高有效 复位超时:- 电压 - 阀值:1.8V 工作温度:-40°C ~ 125°C 安装类型:表面贴装 封装/外壳:6-TSOP（0.059"，1.50mm 宽）5 引线 供应商设备封装:5-TSOP 包装:剪切带 (CT) 其它名称:NCP301HSN18T1GOSCT |
| ADM1065ASUZ-RL7 | 功能描述:IC SEQUENCER/MONITOR 48-TQFP 制造商:analog devices inc. 系列:Super Sequencer? 包装:剪切带（CT） 零件状态:在售 类型:序列发生器 受监控电压数:10 输出:可编程 复位:- 复位超时:- 电压 - 阈值:可调节/可选择 工作温度:-40°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:48-TQFP 供应商器件封装:48-TQFP（7x7） 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。