- 您现在的位置：买卖IC网 > PDF目录375258 > ADM14196E (Analog Devices, Inc.) RS-232 Line Drivers/Receivers(±15kV ESD保护,RS-232线驱动器/接收器) PDF资料下载
参数资料
| 型号： | ADM14196E |
| 厂商： | Analog Devices, Inc. |
| 英文描述： | RS-232 Line Drivers/Receivers(±15kV ESD保护,RS-232线驱动器/接收器) |
| 中文描述： | RS - 232线驱动器/接收器（± 15kV的ESD保护和RS - 232线驱动器/接收器） |
| 文件页数： | 10/13页 |
| 文件大小： | 339K |
| 代理商： | ADM14196E |
ADM14196E
REV. 0
10
DATA
TECHNICAL
using unshielded cables and meet Classification 2. Data trans-
mission during the transient condition is corrupted but it may be
resumed immediately following the EFT event without user
intervention.
R
C
R
M
C
C
HIGH
VOLTAGE
SOURCE
L
Z
S
C
D
50
OUTPUT
Figure 25. IEC1000-4-4 Fast Transient Generator
IEC1000-4-3 RADIATED IMMUNITY
IEC1000-4-3 (previously IEC801-3) describes the mea-
surement method and defines the levels of immunity to
radiated electromagnetic fields. It was originally intended
to simulate the electromagnetic fields generated by
generates continuous wave radiated electromagnetic
energy. Its scope has since been broadened to include
spurious EM energy which can be radiated from fluores-
cent lights, thyristor drives, inductive loads, etc.
Testing for immunity involves irradiating the device with
an EM field. There are various methods of achieving this
including use of anechoic chamber, stripline cell, TEM
plates with an electric field developed between them. The
device under test is placed within the cell and exposed to
the electric field. There are three severity levels having
field strengths ranging from 1 V to 10 V/m. Results are
classified in a similar fashion to those for IEC1000-4-4.
1. Normal operation.
2. Temporary degradation or loss of function which is self-
recoverable when the interfering signal is removed.
3. Temporary degradation or loss of function which requires op-
erator intervention or system reset when the interfering signal
is removed.
4. Degradation or loss of function which is not recoverable due
to damage.
The ADM14196E easily meets Classification 1 at the most
stringent (Level 3) requirement. In fact field strengths up to 30 V/m
showed no performance degradation and error-free data
transmission continued even during irradiation.
Table VII. Test Severity Levels (IEC1000-4-3)
Field Strength
V/m
Level
1
2
3
1
3
10
EMISSIONS/INTERFERENCE
this arcing and its waveform is illustrated in Figure 24. It consists
of a burst of 2.5 kHz to 5 kHz transients repeating at
300 ms intervals. It is specified for both power and data lines.
300ms
15ms
t
V
5ns
0.2/0.4ms
50ns
V
t
Figure 24. IEC1000-4-4 Fast Transient Waveform
Table VI.
V Peak (kV)
V Peak
(kV)
Level
PSU
I-O
1
2
3
4
0.5
1
2
4
0.25
0.5
1
2
A simplified circuit diagram of the actual EFT generator
is illustrated in Figure 25.
The transients are coupled onto the signal lines using an
EFT coupling clamp. The clamp is 1 m long and it
completely surrounds the cable providing maximum
coupling capacitance
(50 pF to 200 pF typ) between the clamp and the cable. High en-
ergy transients are capacitively coupled onto the signal lines. Fast
rise times (5 ns) as specified by the standard result in very effec-
tive coupling. This test is very severe since high voltages are
coupled onto the signal lines. The repetitive transients can often
cause problems where single pulses dont. Destructive latch-up
may be induced due to the high energy content of the transients.
Note that this stress is applied while the interface products are
powered up and are transmitting data. The EFT test applies hun-
dreds of pulses with higher energy than ESD. Worst case tran-
sient current on an I-O line can be as high as 40A.
Test results are classified according to the following:
1. Normal performance within specification limits.
2. Temporary degradation or loss of performance which is self-
recoverable.
3. Temporary degradation or loss of function or performance
which requires operator intervention or system reset.
4. Degradation or loss of function which is not recoverable due
to damage.
The ADM14196E has been tested under worst case conditions
相关PDF资料 |
PDF描述 |
|---|---|
| ADM208E | RS-232 Line Drivers/Receivers(15kV ESD保护,RS-232线驱动器/接收器) |
| ADM209 | +5 V Powered CMOS RS-232 Drivers/Receivers(CMOS RS-232驱动器/接收器) |
| ADM213 | +5 V Powered CMOS RS-232 Drivers/Receivers(CMOS RS-232驱动器/接收器) |
| ADM223 | High Speed, CMOS RS-232 Drivers/Receivers(CMOS RS-232驱动器/接收器) |
| ADM230L | High Speed, CMOS RS-232 Drivers/Receivers(CMOS RS-232驱动器/接收器) |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADM1485 | 制造商:AD 制造商全称:Analog Devices 功能描述:+-5 V Low Power EIA RS-485 Transceiver |
| ADM1485_12 | 制造商:AD 制造商全称:Analog Devices 功能描述:5 V Low Power EIA RS-485 Transceiver |
| ADM1485AN | 制造商:Analog Devices 功能描述:Single Transmitter/Receiver RS-422/RS-485 8-Pin PDIP 制造商:Rochester Electronics LLC 功能描述:RS-485 HIGH SPEED I/F TX. - Bulk 制造商:Analog Devices 功能描述:Transceiver IC Transceiver Type:Differen |
| ADM1485ANZ | 功能描述:IC TXRX RS-485 HS 5V 8-DIP RoHS:是 类别:集成电路 (IC) >> 接口 - 驱动器，接收器，收发器 系列:- 产品培训模块:RS-232 & USB Transceiver 标准包装:2,000 系列:- 类型:收发器 驱动器/接收器数:1/1 规程:RS232 电源电压:3 V ~ 5.5 V 安装类型:表面贴装 封装/外壳:16-SSOP（0.209"，5.30mm 宽） 供应商设备封装:16-SSOP 包装:带卷 (TR) 其它名称:296-19849-2 |
| ADM1485AQ | 制造商:AD 制造商全称:Analog Devices 功能描述:+-5 V Low Power EIA RS-485 Transceiver |
发布紧急采购，3分钟左右您将得到回复。