参数资料
型号: ADM660ARZ-REEL7
厂商: Analog Devices Inc
文件页数: 9/11页
文件大小: 0K
描述: IC REG MULTI CONFIG ADJ 8SOIC
标准包装: 1,000
类型: 升压(升压),切换电容(充电泵),倍增器,反相
输出类型: 可调式
输出数: 1
输出电压: -1.5 V ~ -7 V,3 V ~ 14 V
输入电压: 1.5 V ~ 7 V
频率 - 开关: 25kHz,120kHz
电流 - 输出: 100mA
同步整流器:
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
包装: 带卷 (TR)
供应商设备封装: 8-SO
ADM660/ADM8660
current levels. The ADM660/ADM8660 is tested using low
ESR, 10 μ F, capacitors for both C1 and C2. Smaller values of
C1 increase the output resistance, while increasing C1 will
reduce the output resistance. The output resistance is also depen-
dent on the internal switches on resistance as well as the
capacitors ESR, so the effect of increasing C1 becomes negligible
past a certain point.
Figure 9 shows how the output resistance varies with oscillator
frequency for three different capacitor values. At low oscillator
Capacitor C2
The output capacitor size C2 affects the output ripple. Increas-
ing the capacitor size reduces the peak-to-peak ripple. The ESR
affects both the output impedance and the output ripple.
Reducing the ESR reduces the output impedance and ripple.
For convenience it is recommended that both C1 and C2 be the
same value.
Table III. Capacitor Selection
frequencies, the output impedance is dominated by the 1/f C
term. This explains why the output impedance is higher for
smaller capacitance values. At high oscillator frequencies, the
1/f C term becomes insignificant and the output impedance is
dominated by the internal switches on resistance. From an out-
Charge-Pump
Frequency
25 kHz
120 kHz
Capacitor
C1, C2
10 μ F
2.2 μ F
put impedance viewpoint, therefore, there is no benefit to be
gained from using excessively large capacitors.
Power Efficiency and Oscillator Frequency Trade-Off
While higher switching frequencies allow smaller capacitors to
be used for equivalent performance, or improved performance
500
400
C1 = C2 = 2.2 F
with the same capacitors, there is a trade-off to consider. As the
oscillator frequency is increased, the quiescent current increases.
This happens as a result of a finite charge being lost at each
switching cycle. The charge loss per unit cycle at very high
frequencies can be significant, thereby reducing the power effi-
300
200
C1 = C2 = 1 F
ciency. Since the power efficiency is also degraded at low oscillator
frequencies due to an increase in output impedance, this means
that there is an optimum frequency band for maximum power
transfer. Refer to the Typical Performance Characteristics section.
100
C1 = C2 = 10 F
Bypass Capacitor
The ac impedance of the ADM660/ADM8660 may be reduced
by using a bypass capacitor on the input supply. This capacitor
0
0.1
1 10
OSCILLATOR FREQUENCY – kHz
100
should be connected between the input supply and GND. It
will provide instantaneous current surges as required. Suitable
Figure 9. Output Impedance vs. Oscillator Frequency
REV. C
–9 –
capacitors of 0.1 μ F or greater may be used.
相关PDF资料
PDF描述
MAX6867UK32D3S+T IC MPU SUPERVISOR SOT23-5
LQR2V103MSEJ CAP ALUM 10000UF 350V 20% SCREW
MAX6867UK34D2L+T IC MPU SUPERVISOR SOT23-5
LT3502EDC#TRPBF IC REG BUCK ADJ 0.5A 8DFN
MAX6867UK34D3L+T IC MPU SUPERVISOR SOT23-5
相关代理商/技术参数
参数描述
ADM663 制造商:AD 制造商全称:Analog Devices 功能描述:Tri-Mode: +3.3 V, +5 V, Adjustable Micropower Linear Voltage Regulators
ADM663A 制造商:AD 制造商全称:Analog Devices 功能描述:Tri-Mode: +3.3 V, +5 V, Adjustable Micropower Linear Voltage Regulators
ADM663AAN 制造商:Rochester Electronics LLC 功能描述:
ADM663AAR 制造商:Analog Devices 功能描述:
ADM663AN 制造商:Rochester Electronics LLC 功能描述:LINEAR REG.I/F APP.-IC - Bulk 制造商:Analog Devices 功能描述:IC V REG ADJ +2/16.5V DIP8 663