参数资料
型号: ADP1713AUJZ-0.9-R7
厂商: Analog Devices Inc
文件页数: 11/16页
文件大小: 0K
描述: IC REG LDO 0.9V .3A TSOT-23-5
产品培训模块: Power Line Monitoring
标准包装: 1
稳压器拓扑结构: 正,固定式
输出电压: 0.9V
输入电压: 2.5 V ~ 5.5 V
稳压器数量: 1
电流 - 输出: 300mA(最小值)
电流 - 限制(最小): 380mA
工作温度: -40°C ~ 125°C
安装类型: 表面贴装
封装/外壳: SOT-23-5 细型,TSOT-23-5
供应商设备封装: TSOT-23-5
包装: 标准包装
其它名称: ADP1713AUJZ-0.9-R7DKR
ADP1712/ADP1713/ADP1714
ADJUSTABLE OUTPUT VOLTAGE
(ADP1712 ADJUSTABLE)
The ADP1712 adjustable version can have its output voltage
set over a 0.8 V to 5.0 V range. The output voltage is set by
connecting a resistive voltage divider from OUT to ADJ. The
output voltage is calculated using the equation
ENABLE FEATURE
The ADP1712/ADP1713/ADP1714 use the EN pin to enable
and disable the OUT pin under normal operating conditions.
As shown in Figure 29, when a rising voltage on EN crosses the
active threshold, OUT turns on. When a falling voltage on EN
crosses the inactive threshold, OUT turns off.
V OUT = 0.8 V (1 + R1 / R2 )
where:
R1 is the resistor from OUT to ADJ.
R2 is the resistor from ADJ to GND.
The maximum bias current into ADJ is 100 nA, so for less
(2)
EN
than 0.5% error due to the bias current, use values less than
60 kΩ for R2.
BYPASS CAPACITOR (ADP1713)
The ADP1713 allows for an external bypass capacitor to be
connected to the internal reference, which reduces output
voltage noise and improves power supply rejection. A low
leakage capacitor of 1 nF or greater (10 nF is recommended)
must be connected between the BYP and GND pins.
TRACK MODE (ADP1714)
The ADP1714 includes a tracking mode feature. As shown in
Figure 28, if the voltage applied at the TRK pin is less than the
nominal output voltage, OUT is equal to the voltage at TRK.
Otherwise, OUT regulates to its nominal output value.
For example, consider an ADP1714 with a nominal output
voltage of 3 V. If the voltage applied to its TRK pin is greater than
3 V, OUT maintains a nominal output voltage of 3 V. If the volt-
age applied to TRK is reduced below 3 V, OUT tracks this voltage.
OUT can track the TRK pin voltage from the nominal value all
OUT
1
V IN = 5V
V OUT = 1.6V
C OUT = 2.2 μ F
I LOAD = 10mA
TIME (4ms/DIV)
Figure 29. ADP1712 Adjustable Typical EN Pin Operation
As can be seen, the EN pin has hysteresis built in. This prevents
on/off oscillations that can occur due to noise on the EN pin as
it passes through the threshold points.
The EN pin active/inactive thresholds are derived from the IN
voltage. Therefore, these thresholds vary with changing input
voltage. Figure 30 shows typical EN active/inactive thresholds
when the input voltage varies from 2.5 V to 5.5 V.
1.4
1.3
1.2
the way down to 0 V. A voltage divider is present from TRK to the
error amplifier input with a divider ratio equal to the divider
from OUT to the error amplifier. This sets the output voltage
equal to the tracking voltage. Both divider ratios are set by post-
package trim, depending on the desired output voltage.
4
1.1
1.0
0.9
0.8
0.7
0.6
EN ACTIVE
EN INACTIVE
HYSTERESIS
3
0.5
2.50 2.75 3.00 3.25 3.50 3.75 4.00 4.25 4.50 4.75 5.00 5.25 5.50
V IN (V)
Figure 30. Typical EN Pin Thresholds vs. Input Voltage
2
UNDERVOLTAGE LOCKOUT (UVLO)
The ADP1712/ADP1713/ADP1714 have an undervoltage
1
lockout circuit, which monitors the voltage on the IN pin.
When the voltage on IN drops below 2 V (minimum), the
circuit activates, disabling the OUT pin.
0
0
1
2
3
4
5
V TRK (V)
Figure 28. ADP1714 Output Voltage vs. Tracking Voltage
with Nominal Output Voltage Set to 3 V
Rev. A | Page 11 of 16
相关PDF资料
PDF描述
ADP1715ARMZ-R7 IC REG LDO ADJ .5A 8MSOP
ADP1720ARMZ-R7 IC REG LDO ADJ 50MA 8-MSOP
ADP1720TRMZ-EP IC REG LDO ADJ 50MA 8-MSOP
ADP172ACBZ-2.9-R7 IC REG LDO 2.9V .3A 4WLCSP
ADP1740ACPZ-1.1-R7 IC REG LDO 1.1V 2A 16LFCSP
相关代理商/技术参数
参数描述
ADP1713AUJZ-09-R7 制造商:AD 制造商全称:Analog Devices 功能描述:300 mA, Low Dropout CMOS Linear Regulator
ADP1713AUJZ-1.05R7 功能描述:IC REG LDO 1.05V .3A TSOT-23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:45 系列:- 稳压器拓扑结构:正,固定式 输出电压:5V 输入电压:6 V ~ 30 V 电压 - 压降(标准):0.47V @ 250mA 稳压器数量:1 电流 - 输出:250mA 电流 - 限制(最小):- 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-220-3 供应商设备封装:TO-220-3 包装:管件 产品目录页面:1289 (CN2011-ZH PDF) 其它名称:*LP2954AIT*LP2954AIT/NOPBLP2954AIT
ADP1713AUJZ-1.05R71 制造商:AD 制造商全称:Analog Devices 功能描述:300 mA, Low Dropout CMOS Linear Regulator
ADP1713AUJZ-1.0-R7 功能描述:IC REG LDO 1V .3A TSOT-23-5 RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:45 系列:- 稳压器拓扑结构:正,固定式 输出电压:5V 输入电压:6 V ~ 30 V 电压 - 压降(标准):0.47V @ 250mA 稳压器数量:1 电流 - 输出:250mA 电流 - 限制(最小):- 工作温度:-40°C ~ 125°C 安装类型:通孔 封装/外壳:TO-220-3 供应商设备封装:TO-220-3 包装:管件 产品目录页面:1289 (CN2011-ZH PDF) 其它名称:*LP2954AIT*LP2954AIT/NOPBLP2954AIT
ADP1713AUJZ-1.0-R71 制造商:AD 制造商全称:Analog Devices 功能描述:300 mA, Low Dropout CMOS Linear Regulator