- 您现在的位置：买卖IC网 > PDF目录16945 > ADP1741-EVALZ (Analog Devices Inc)BOARD EVAL 2A ADP1741 PDF资料下载
参数资料
| 型号： | ADP1741-EVALZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 12/20页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL 2A ADP1741 |
| 标准包装： | 1 |
| 每 IC 通道数： | 1 - 单 |
| 输出电压： | 0.75 ~ 3V |
| 电流 - 输出： | 2A |
| 输入电压： | 1.6 ~ 3.6V |
| 稳压器类型： | 正，可调式 |
| 工作温度： | -40°C ~ 125°C |
| 板类型： | 完全填充 |
| 已供物品： | 板 |
| 已用 IC / 零件： | ADP1741 |
| 产品目录页面： | 794 (CN2011-ZH PDF) |
| 相关产品： | ADP1741ACPZ-R7DKR-ND - IC REG LDO ADJ 2A 16LFCSP ADP1741ACPZ-R7CT-ND - IC REG LDO ADJ 2A 16LFCSP ADP1741ACPZ-R7TR-ND - IC REG LDO ADJ 2A 16LFCSP |
ADP1740/ADP1741
Data Sheet
1
T
EN
The EN pin active/inactive thresholds are derived from the VIN
voltage. Therefore, these thresholds vary with changing input
voltage. Figure 29 shows typical EN active/inactive thresholds
when the input voltage varies from 1.6 V to 3.6 V.
1.1
1.0
V OUT
0.9
EN ACTIVE
2
500mV/DIV
V OUT = 1.5V
C IN = C OUT = 4.7μF
0.8
EN INACTIVE
CH1 2.0V BW
CH2 500mV BW M40μs
A CH1
920mV
0.7
T 9.8%
Figure 27. V OUT Ramp-Up with Internal Soft Start
ADJUSTABLE OUTPUT VOLTAGE (ADP1741)
0.6
The output voltage of the ADP1741 can be set over a 0.75 V to
0.5
1.6
1.8
2.0
2.2
2.4
2.6
2.8
3.0
3.2
3.4
3.6
3.3 V range. The output voltage is set by connecting a resistive
voltage divider from VOUT to ADJ. The output voltage is calcu-
lated using the following equation:
INPUT VOLTAGE (V)
Figure 29. Typical EN Pin Thresholds vs. Input Voltage
POWER-GOOD FEATURE
V OUT = 0.5 V × (1 + R1 / R2 )
(2)
The ADP1740/ADP1741 provide a power-good pin, PG, to
where:
R1 is the resistor from VOUT to ADJ.
R2 is the resistor from ADJ to GND.
The maximum bias current into ADJ is 150 nA, so to achieve less
than 0.5% error due to the bias current, use values less than
60 kΩ for R2.
ENABLE FEATURE
The ADP1740/ADP1741 use the EN pin to enable and disable
the VOUT pins under normal operating conditions. As shown
in Figure 28, when a rising voltage on EN crosses the active
threshold, VOUT turns on. When a falling voltage on EN
crosses the inactive threshold, VOUT turns off.
T
EN
indicate the status of the output. This open-drain output
requires an external pull-up resistor to VIN. If the part is in
shutdown mode, current-limit mode, or thermal shutdown, or
if it falls below 90% of the nominal output voltage, the power-
good pin (PG) immediately transitions low. During soft start,
the rising threshold of the power-good signal is 93.5% of the
nominal output voltage.
The open-drain output is held low when the ADP1740/ADP1741
have sufficient input voltage to turn on the internal PG transistor.
An optional soft start delay can be detected. The PG transistor
is terminated via a pull-up resistor to VOUT or VIN.
Power-good accuracy is 93.5% of the nominal regulator output
voltage when this voltage is rising, with a 90% trip point when
this voltage is falling. Regulator input voltage brownouts or
glitches trigger power no-good if V OUT falls below 90%.
A normal power-down triggers power no-good when V OUT
drops below 90%.
V OUT
2 1
500mV/DIV
V OUT = 1.5V
C IN = C OUT = 4.7μF
CH1 500mV BW CH2 500mV BW M2.0ms
A CH1
1.05V
T 29.6%
Figure 28. Typical EN Pin Operation
As shown in Figure 28, the EN pin has hysteresis built in. This
hysteresis prevents on/off oscillations that can occur due to
noise on the EN pin as it passes through the threshold points.
Rev. F | Page 12 of 20
相关PDF资料 |
PDF描述 |
|---|---|
| ADP170-1.8-EVALZ | BOARD EVAL ADP170 1.8V |
| ADP171-EVALZ | BOARD EVAL ADP171 1V |
| VE-JVM-EY | CONVERTER MOD DC/DC 10V 50W |
| VI-24L-EY | CONVERTER MOD DC/DC 28V 50W |
| CBC2012T220M | INDUCTOR 22UH 20% 0805 SMD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP1752 | 制造商:AD 制造商全称:Analog Devices 功能描述:0.8 A, Low VIN, Low Dropout Linear Regulator |
| ADP1752-1.5-EVALZ | 功能描述:BOARD EVAL AD1752 1.5V RoHS:是 类别:编程器，开发系统 >> 评估板 - 线性稳压器 (LDO) 系列:- 产品变化通告:1Q2012 Discontinuation 30/Mar/2012 设计资源:NCP590MNDPTAGEVB Gerber Files 标准包装:1 系列:- 每 IC 通道数:2 - 双 输出电压:1.8V，2.8V 电流 - 输出:300mA 输入电压:2.1 ~ 5.5 V 稳压器类型:正，固定式 工作温度:-40°C ~ 85°C 板类型:完全填充 已供物品:板 已用 IC / 零件:NCP590MNDP 其它名称:NCP590MNDPTAGEVB-NDNCP590MNDPTAGEVBOS |
| ADP1752ACPZ-0.75R7 | 功能描述:IC REG LDO 0.75V .8A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| ADP1752ACPZ-1.0-R7 | 功能描述:IC REG LDO 1V .8A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
| ADP1752ACPZ-1.1-R7 | 功能描述:IC REG LDO 1.1V .8A 16LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - 线性 系列:- 标准包装:1 系列:- 稳压器拓扑结构:正，固定式 输出电压:3.3V 输入电压:2.5 V ~ 5.5 V 电压 - 压降（标准）:0.1V @ 200mA 稳压器数量:2 电流 - 输出:300mA 电流 - 限制（最小）:350mA 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-UFQFN 供应商设备封装:8-MLPQ-UT（1.5x1.5） 包装:剪切带 (CT) 产品目录页面:1358 (CN2011-ZH PDF) 其它名称:SC560HULCT |
发布紧急采购，3分钟左右您将得到回复。