- 您现在的位置：买卖IC网 > PDF目录17412 > ADP1879-0.3-EVALZ (Analog Devices Inc)BOARD EVAL FOR ADP1879-0.3 PDF资料下载
参数资料
| 型号： | ADP1879-0.3-EVALZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 22/40页 |
| 文件大小： | 0K |
| 描述： | BOARD EVAL FOR ADP1879-0.3 |
| 标准包装： | 1 |
| 系列： | * |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页当前第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页
ADP1878/ADP1879
ANOTHER t ON EDGE IS
TRIGGERED WHEN V OUT
FALLS BELOW REGULATION
Data Sheet
The t ON timer uses a feedforward technique that, when applied
to the constant on-time control loop, makes it a pseudo fixed
SW
LS
I LOAD
t ON
HS AND LS
IN IDLE MODE
ZERO-CROSS COMPARATOR
DETECTS 10mV OFFSET AND
TURNS OFF LS
frequency to a first-order approximation.
Second-order effects, such as dc losses in the external power
MOSFETs (see the Efficiency Consideration section), cause some
variation in frequency vs. load current and line voltage. These
effects are shown in Figure 23 to Figure 34. The variations in
frequency are much reduced compared with the variations
generated if the feedforward technique is not used.
The feedforward technique establishes the following relationship:
1
0A
10mV = R ON × I LOAD
Figure 76. 10 mV Offset to Ensure Prevention of Negative Inductor Current
The system remains in idle mode until the output voltage drops
below regulation. Next, a PWM pulse is produced, turning on the
high-side MOSFET to maintain system regulation. The ADP1879
does not have an internal clock; it switches purely as a hysteretic
controller, as described in this section.
TIMER OPERATION
The ADP1878 / ADP1879 employ a constant on-time architecture,
which provides a variety of benefits, including improved load
and line transient response when compared with a constant
(fixed) frequency current-mode control loop of comparable
loop design. The constant on-time timer, or t ON timer, senses
the high-side input voltage (V IN ) and the output voltage (V OUT )
using SW waveform information to produce an adjustable one
shot PWM pulse. The pulse varies the on-time of the high-side
MOSFET in response to dynamic changes in input voltage, output
voltage, and load current conditions to maintain output regula-
tion. The timer generates an on-time (t ON ) pulse that is inversely
proportional to V IN .
where K is a constant that is trimmed using an RC timer product
for the 300 kHz, 600 kHz, and 1.0 MHz frequency options.
where f SW is the controller switching frequency (300 kHz,
600 kHz, and 1.0 MHz).
The t ON timer senses V IN and V OUT to minimize frequency
variation as previously explained. This provides pseudo fixed
frequency as explained in the Pseudo Fixed Frequency section.
To allow headroom for V IN and V OUT sensing, adhere to the
following equations:
V REG ≥ V IN /8 + 1.5
V REG ≥ V OUT /4
For typical applications where V REG is 5 V, these equations are
not relevant; however, for lower V REG inputs, care may be required.
PSEUDO FIXED FREQUENCY
The ADP1878 / ADP1879 employ a constant on-time control
scheme. During steady state operation, the switching frequency
stays relatively constant, or pseudo fixed. This is due to the one
shot t ON timer that produces a high-side PWM pulse with a
fixed duration, given that external conditions such as input
voltage, output voltage, and load current are also at steady state.
During load transients, the frequency momentarily changes for
the duration of the transient event so that the output comes
back within regulation quicker than if the frequency were fixed,
or if it were to remain unchanged. After the transient event is
complete, the frequency returns to a pseudo fixed value.
To illustrate this feature more clearly, this section describes one
t ON
VREG
C
I
SW
INFORMATION
R (TRIMMED)
V IN
such load transient event—a positive load step—in detail. During
load transient events, the high-side driver output pulse width
stays relatively consistent from cycle to cycle; however, the off
time (DRVL on time) dynamically adjusts according to the
instantaneous changes in the external conditions mentioned.
When a positive load step occurs, the error amplifier (out of phase
with the output, V OUT ) produces new voltage information at its
output (COMP). In addition, the current sense amplifier senses
Figure 77. Constant On-Time Time
The constant on-time (t ON ) is not strictly constant because it
varies with V IN and V OUT . However, this variation occurs in such
a way as to keep the switching frequency virtually independent
of V IN and V OUT .
new inductor current information during this positive load
transient event. The output voltage reaction of the error amplifier is
compared with the new inductor current information that sets
the start of the next switching cycle. Because current information
is produced from valley current sensing, it is sensed at the down
ramp of the inductor current, whereas the voltage loop information
Rev. B | Page 22 of 40
相关PDF资料 |
PDF描述 |
|---|---|
| RCC10DCMS | CONN EDGECARD 20POS .100 WW |
| BYG21KHE3/TR3 | DIODE 1.5A 800V 120NS DO-214AC |
| A9BBA-0308F | FLEX CABLE - AFF03A/AF03/AFF03A |
| M7TTK-3606R | IDC CABLE - MDL36K/MC37M/MDL36K |
| M7TTK-5006R | IDC CABLE - MDL50K/MC50M/MDL50K |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADP1879-1.0-EVALZ | 功能描述:BOARD EVAL FOR ADP1879-1.0 RoHS:是 类别:编程器，开发系统 >> 评估板 - DC/DC 与 AC/DC（离线）SMPS 系列:* 标准包装:1 系列:- 主要目的:DC/DC，步降 输出及类型:1，非隔离 功率 - 输出:- 输出电压:3.3V 电流 - 输出:3A 输入电压:4.5 V ~ 28 V 稳压器拓扑结构:降压 频率 - 开关:250kHz 板类型:完全填充 已供物品:板 已用 IC / 零件:L7981 其它名称:497-12113STEVAL-ISA094V1-ND |
| ADP1879ACPZ-0.3-R7 | 功能描述:IC REG CTRLR BUCK PWM CM 14LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 特色产品:LM3753/54 Scalable 2-Phase Synchronous Buck Controllers 标准包装:1 系列:PowerWise® PWM 型:电压模式 输出数:1 频率 - 最大:1MHz 占空比:81% 电源电压:4.5 V ~ 18 V 降压:是 升压:无 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-5°C ~ 125°C 封装/外壳:32-WFQFN 裸露焊盘 包装:Digi-Reel® 产品目录页面:1303 (CN2011-ZH PDF) 其它名称:LM3754SQDKR |
| ADP1879ACPZ-0.6-R7 | 功能描述:IC REG CTRLR BUCK PWM CM 14LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| ADP1879ACPZ-1.0-R7 | 功能描述:IC REG CTRLR BUCK PWM CM 14LFCSP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 切换控制器 系列:- 标准包装:2,500 系列:- PWM 型:电流模式 输出数:1 频率 - 最大:500kHz 占空比:96% 电源电压:4 V ~ 36 V 降压:无 升压:是 回扫:无 反相:无 倍增器:无 除法器:无 Cuk:无 隔离:无 工作温度:-40°C ~ 125°C 封装/外壳:24-WQFN 裸露焊盘 包装:带卷 (TR) |
| ADP1880ACPZ-R7 | 制造商:Analog Devices 功能描述: |
发布紧急采购，3分钟左右您将得到回复。