- 您现在的位置：买卖IC网 > PDF目录11203 > ADUC814ARU (Analog Devices Inc)IC ADC 12BIT W/FLASH MCU 28TSSOP PDF资料下载
参数资料
| 型号： | ADUC814ARU |
| 厂商： | Analog Devices Inc |
| 文件页数： | 25/72页 |
| 文件大小： | 0K |
| 描述： | IC ADC 12BIT W/FLASH MCU 28TSSOP |
| 标准包装： | 50 |
| 系列： | MicroConverter® ADuC8xx |
| 核心处理器： | 8052 |
| 芯体尺寸： | 8-位 |
| 速度： | 16.78MHz |
| 连通性： | I²C，SPI，UART/USART |
| 外围设备： | POR，PSM，温度传感器，WDT |
| 输入/输出数： | 17 |
| 程序存储器容量： | 8KB（8K x 8） |
| 程序存储器类型： | 闪存 |
| EEPROM 大小： | 640 x 8 |
| RAM 容量： | 256 x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 数据转换器： | A/D 6x12b; D/A 2x12b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 125°C |
| 封装/外壳： | 28-TSSOP（0.173"，4.40mm 宽） |
| 包装： | 管件 |
| 配用： | EVAL-ADUC814QSZ-ND - KIT DEV FOR ADUC814 MICROCONVRTR |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页当前第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页
ADuC814
Rev. A | Page 31 of 72
USING FLASH/EE PROGRAM MEMORY
The Flash/EE program memory array can be programmed in
one of two modes: serial downloading and parallel
programming.
Serial Downloading (In-Circuit Programming)
As part of its factory boot code, the ADuC814 facilitates code
download via the standard UART serial port. Serial download
mode is automatically entered on power-up or during a
hardware RESET operation if the external DLOAD pin is pulled
high through an external resistor, as shown in Figure 34. Once
in this mode, the user can download code to the program
memory array while the device is sited in its target application
hardware. A PC serial download executable is provided as part
of the ADuC814 QuickStart development system. The Serial
Download protocol is detailed in a MicroConverter Applications
Note uC004 available from the ADI MicroConverter website at
DLOAD
ADuC814
PULL DLOAD HIGH VIA
1k
RESISTOR DURING
RESET TO CONFIGURE
THE ADuC814 FOR
SERIAL DOWNLOAD MODE
1k
DVDD
02748-A
-040
Figure 34. Flash/EE Memory Serial Download Mode Programming
Parallel Programming
The parallel programming mode is fully compatible with
conventional third-party Flash or EEPROM device program-
mers. A block diagram of the external pin configuration
required to support parallel programming is shown in Figure 35.
The high voltage (12 V) supply required for Flash/EE
programming is generated using on-chip charge pumps to
supply the high voltage program lines.
VDD
GND
P1.1–P1.4
DLOAD
RESET
P3
P1.0
ADuC814
5V
COMMAND
TIMING
GND
P1.5–P1.7
VDD
DATA
ENABLE
02748-A
-041
Figure 35. Flash/EE Memory Parallel Programming
FLASH/EE PROGRAM MEMORY SECURITY
The ADuC814 facilitates three modes of Flash/EE program
memory security, which are described in the following sections.
These modes can be independently activated, restricting access
to the internal code space. These security modes can be enabled
as part of the user interface available on all ADuC814 serial or
parallel programming tools referenced on the MicroConverter
website at www.analog.com/microconverter.
Lock Mode
This mode locks code in memory, disabling parallel program-
ming of the program memory, although reading the memory in
parallel mode is still allowed. This mode is deactivated by
initiating a CODE-ERASE command in serial download or
parallel programming modes.
Secure Mode
This mode locks code in memory, disabling parallel program-
ming (program and VERIFY/READ commands). This mode is
deactivated by initiating a CODE-ERASE command in serial
download or parallel programming modes.
Serial Safe Mode
This mode disables serial download capability on the device. If
serial safe mode is activated and an attempt is made to reset the
part into serial download mode, i.e., RESET asserted and de-
asserted with DLOAD high, the part interprets the serial
download reset as a normal reset only. It therefore does not
enter serial download mode but only executes a normal reset
sequence. Serial safe mode can be disabled only by initiating a
CODE-ERASE command in parallel programming mode.
相关PDF资料 |
PDF描述 |
|---|---|
| VI-BTK-IX | CONVERTER MOD DC/DC 40V 75W |
| VI-BTK-IW | CONVERTER MOD DC/DC 40V 100W |
| ADUC7128BSTZ126-RL | IC DAS MCU ARM7 ADC/DDS 64-LQFP |
| VI-BTJ-IX | CONVERTER MOD DC/DC 36V 75W |
| VI-BTJ-IW | CONVERTER MOD DC/DC 36V 100W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADUC814ARU-D2 | 制造商:Analog Devices 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Bulk |
| ADUC814ARU-REEL | 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 8KB Flash 3V/5V 28-Pin TSSOP T/R 制造商:Analog Devices 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel |
| ADUC814ARU-REEL7 | 制造商:Analog Devices 功能描述:MCU 8-Bit ADuC8xx 8052 CISC 8KB Flash 3V/5V 28-Pin TSSOP T/R 制造商:Analog Devices 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel 制造商:Rochester Electronics LLC 功能描述:12 BIT ADC WITH EMBEDDED 8-BIT MICRO I.C - Tape and Reel |
| ADUC814ARUZ | 功能描述:IC ADC 12BIT W/FLASH MCU 28TSSOP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 产品培训模块:MCU Product Line Introduction XMEGA Introduction AVR XMEGA USB Connectivity 标准包装:90 系列:AVR® XMEGA 核心处理器:AVR 芯体尺寸:8/16-位 速度:32MHz 连通性:I²C，IrDA，SPI，UART/USART 外围设备:欠压检测/复位，DMA，POR，PWM，WDT 输入/输出数:50 程序存储器容量:192KB（96K x 16） 程序存储器类型:闪存 EEPROM 大小:4K x 8 RAM 容量:16K x 8 电压 - 电源 (Vcc/Vdd):1.6 V ~ 3.6 V 数据转换器:A/D 16x12b; D/A 2x12b 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:64-TQFP 包装:托盘 配用:ATSTK600-RC14-ND - STK600 SOCKET/ADAPTER 64TQFPATSTK600-TQFP64-ND - STK600 SOCKET/ADAPTER 64-TQFPATAVRONEKIT-ND - KIT AVR/AVR32 DEBUGGER/PROGRMMRATAVRISP2-ND - PROGRAMMER AVR IN SYSTEM |
| ADUC814ARUZ-REEL | 功能描述:IC MCU FLASH 12BIT ADC 28TSSOP RoHS:是 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:MicroConverter® ADuC8xx 标准包装:38 系列:Encore!® XP® 核心处理器:eZ8 芯体尺寸:8-位 速度:5MHz 连通性:IrDA，UART/USART 外围设备:欠压检测/复位，LED，POR，PWM，WDT 输入/输出数:16 程序存储器容量:4KB（4K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:1K x 8 电压 - 电源 (Vcc/Vdd):2.7 V ~ 3.6 V 数据转换器:- 振荡器型:内部 工作温度:-40°C ~ 105°C 封装/外壳:20-SOIC（0.295"，7.50mm 宽） 包装:管件 其它名称:269-4116Z8F0413SH005EG-ND |
发布紧急采购，3分钟左右您将得到回复。