参数资料
| 型号： | ADV7183BBSTZ |
| 厂商： | Analog Devices Inc |
| 文件页数： | 21/100页 |
| 文件大小： | 0K |
| 描述： | IC VIDEO DECODER NTSC 80-LQFP |
| 产品培训模块： | Interfacing AV Converters to Blackfin Processors |
| 标准包装： | 1 |
| 类型： | 视频解码器 |
| 应用： | 投影仪，录音机，安全 |
| 电压 - 电源，模拟： | 3.15 V ~ 3.45 V |
| 电压 - 电源，数字： | 1.65 V ~ 2 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 80-LQFP |
| 供应商设备封装： | 80-LQFP（14x14） |
| 包装： | 托盘 |
| 产品目录页面： | 788 (CN2011-ZH PDF) |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页当前第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页
ADV7183B
Rev. B | Page 27 of 100
Y-Shaping Filter
For input signals in CVBS format, the luma shaping filters play
an essential role in removing the chroma component from a
composite signal. Y/C separation must aim for best possible
crosstalk reduction while still retaining as much bandwidth
(especially on the luma component) as possible. High quality
Y/C separation can be achieved by using the internal comb
filters of the ADV7183B. Comb filtering, however, relies on the
frequency relationship of the luma component (multiples of the
video line rate) and the color subcarrier (FSC). For good quality
CVBS signals, this relationship is known; the comb filter
algorithms can be used to separate out luma and chroma with
high accuracy.
For nonstandard video signals, the frequency relationship may
be disturbed, and the comb filters may not be able to optimally
remove all crosstalk artifacts without the assistance of the
shaping filter block.
An automatic mode is provided. The ADV7183B evaluates the
quality of the incoming video signal and selects the filter
responses in accordance with the signal quality and video
standard. YFSM, WYSFMOVR, and WYSFM allow the user to
manually override the automatic decisions in part or in full.
The luma shaping filter has three control registers:
YSFM[4:0] allows the user to manually select a shaping
filter mode (applied to all video signals) or to enable an
automatic selection (dependent on video quality and video
standard).
WYSFMOVR allows the user to manually override the
WYSFM decision.
WYSFM[4:0] allows the user to select a different shaping
filter mode for good quality CVBS, component (YPrPb),
and S-VHS (Y/C) input signals.
In automatic mode, the system preserves the maximum possible
bandwidth for good CVBS sources, since they can successfully
be combed, as well as for luma components of YPrPb and Y/C
sources, since they need not be combed. For poor quality
signals, the system selects from a set of proprietary shaping
filter responses that complements comb filter operation to
reduce visual artifacts.
The decisions of the control logic are shown in
176H
Figure 11.
YSFM[4:0] Y-Shaping Filter Mode, Address 0x17[4:0]
The Y shaping filter mode bits allow the user to select from a
wide range of low-pass and notch filters. When switched in
automatic mode, the filter is selected based on other register
selections (for example, detected video standard) as well as
properties extracted from the incoming video itself (for
example, quality, time-base stability). The automatic selection
always selects the widest possible bandwidth for the video input
encountered.
If the YSFM settings specify a filter (where YSFM is set to values
other than 00000 or 00001), the chosen filter is applied to all
video, regardless of its quality.
In automatic selection mode, the notch filters are used only for
bad quality video signals. For all other video signals, wideband
filters are used.
WYSFMOVR Wideband Y-Shaping Filter Override,
Address 0x18[7]
Setting the WYSFMOVR bit enables the use of the
WYSFM[4:0] settings for good quality video signals. For more
information, refer to the general discussion of the luma shaping
filters in the
177H
Y-Shaping Filter section and the flowchart shown
in
178H
Figure 11.
When WYSFMOVR is 0, the shaping filter for good quality
video signals is selected automatically.
Setting WYSFMOVR to 1 enables manual override via
WYSFM[4:0] (default).
相关PDF资料 |
PDF描述 |
|---|---|
| ADV7184BSTZ | IC DECODER VID SDTV MULTI 80LQFP |
| ADV7188BSTZ | IC DECODER VID MULTIFORM 80LQFP |
| ADV7189BBSTZ | IC VIDEO DECODER SDTV 80-LQFP |
| ADV7194KSTZ | IC ENCODER VIDEO EXT-10 80-LQFP |
| ADV7202KSTZ | IC CODEC VIDEO 10BIT 64LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ADV7183BKST | 制造商:Analog Devices 功能描述:MULTIFORMAT SDTV VID DECODER 80LQFP - Bulk |
| ADV7183BKSTZ | 功能描述:IC VIDEO DECODER NTSC 80-LQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 编码器，解码器，转换器 系列:- 产品变化通告:Development Systems Discontinuation 26/Apr/2011 标准包装:1 系列:- 类型:编码器 应用:DVB-S.2 系统 电压 - 电源，模拟:- 电压 - 电源，数字:- 安装类型:- 封装/外壳:模块 供应商设备封装:模块 包装:散装 其它名称:Q4645799 |
| ADV7183KST | 制造商:Analog Devices 功能描述:Video Decoder 2ADC 10-Bit 80-Pin LQFP 制造商:Rochester Electronics LLC 功能描述:VIDEO DECODER I.C. - Bulk |
| ADV7184 | 制造商:AD 制造商全称:Analog Devices 功能描述:Multiformat SDTV Video Decoder with Fast Switch Overlay Support |
| ADV7184BSTZ | 功能描述:IC DECODER VID SDTV MULTI 80LQFP RoHS:是 类别:集成电路 (IC) >> 接口 - 编码器，解码器，转换器 系列:- 产品变化通告:Development Systems Discontinuation 26/Apr/2011 标准包装:1 系列:- 类型:编码器 应用:DVB-S.2 系统 电压 - 电源，模拟:- 电压 - 电源，数字:- 安装类型:- 封装/外壳:模块 供应商设备封装:模块 包装:散装 其它名称:Q4645799 |
发布紧急采购，3分钟左右您将得到回复。