- 您现在的位置：买卖IC网 > PDF目录1779 > AOZ1341EI-1 (Alpha & Omega Semiconductor Inc)IC PWR DIST SW USB 2CH 8MSOP PDF资料下载
参数资料
| 型号： | AOZ1341EI-1 |
| 厂商： | Alpha & Omega Semiconductor Inc |
| 文件页数： | 10/16页 |
| 文件大小： | 0K |
| 描述： | IC PWR DIST SW USB 2CH 8MSOP |
| 标准包装： | 3,000 |
| 系列： | EZPower™ |
| 类型： | USB 开关 |
| 输出数： | 2 |
| Rds（开）： | 135 毫欧 |
| 内部开关： | 是 |
| 电流限制： | 1A |
| 输入电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽） |
| 供应商设备封装： | 8-MSOP-EP |
| 包装： | 带卷 (TR) |
AOZ1341
Applications Information
Input Capacitor Selection
The input capacitor prevents large voltage transients
from appearing at the input, and provides the
instantaneous current needed each time the switch turns
on and also to limit input voltage drop. The input
capacitor t also prevents high-frequency noise on the
power line from passing through the output of the power
side. The choice of the input capacitor is based on its
ripple current and voltage ratings rather than its capacitor
value. The input capacitor should be located as close to
the VIN pin as possible. A 0.1 μ F ceramic cap is
recommended but higher capacitor values will further
reduce the voltage drop at the input.
Output Capacitor Selection
The output capacitor acts in a similar way. A small 0.1 μ F
capacitor prevents high-frequency noise from going into
the system. Also, the output capacitor has to supply
enough current for a large load that it may encounter
during system transients. This bulk capacitor must be
large enough to supply fast transient load in order to
prevent the output voltage from dropping.
Power Dissipation Calculation
Calculate the power dissipation for normal load condition
using the following equation:
P D = R ON x (I OUT ) 2
The worst case power dissipation occurs when the load
current hits the current limit due to over-current or short
circuit faults. The power dissipation under these
conditions can be calculated using the following
equation:
P D = (V IN – V OUT ) x I LIMIT
Layout Guidelines
Proper PCB layout is important for improving the thermal
and overall performance of the AOZ1341. To optimize the
switch response time to output short-circuit conditions
keep all traces as short as possible to reduce the effect of
unwanted parasitic inductance.
Place the input and output bypass capacitors as close as
possible to the IN and OUT pins. The input and output
PCB traces should be as wide as possible for the given
PCB space.
Use a ground plane to enhance the power dissipation
capability of the device.
Rev. 1.1 June 2011
www.aosmd.com
Page 10 of 16
相关PDF资料 |
PDF描述 |
|---|---|
| AOZ1342PI-1 | IC PWR DIST SW USB 2CH 8SO |
| AOZ1360DIL | IC LOAD SW HI-SIDE CC 10DFN |
| AOZ1401DI | IC LI+ CHARGER PROTECTION 8DFN |
| AOZ1605DI | IC REG BUCK SYNC ADJ 0.5A 8DFN |
| AOZ5006QI-01 | IC REG BUCK SYNC ADJ 35A 40QFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AOZ1342 | 制造商:AOSMD 制造商全称:Alpha & Omega Semiconductors 功能描述:Dual Channel USB Switch |
| AOZ1342PI | 功能描述:IC PWR DIST SW USB 2CH 8SO RoHS:是 类别:集成电路 (IC) >> PMIC - 电源分配开关 系列:EZPower™ 特色产品:XRP252 Switches 标准包装:1 系列:- 类型:高端开关 输出数:2 Rds（开）:140 毫欧 内部开关:是 电流限制:1.15A 输入电压:1.75 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN（3x3） 包装:Digi-Reel® 其它名称:1016-1691-6 |
| AOZ1342PI-1 | 功能描述:IC PWR DIST SW USB 2CH 8SO RoHS:是 类别:集成电路 (IC) >> PMIC - 电源分配开关 系列:EZPower™ 特色产品:XRP252 Switches 标准包装:1 系列:- 类型:高端开关 输出数:2 Rds（开）:140 毫欧 内部开关:是 电流限制:1.15A 输入电压:1.75 V ~ 5.5 V 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:10-WFDFN 裸露焊盘 供应商设备封装:10-TDFN（3x3） 包装:Digi-Reel® 其它名称:1016-1691-6 |
| AOZ1360 | 制造商:AOSMD 制造商全称:Alpha & Omega Semiconductors 功能描述:28V Programmable Current-Limited Load Switch |
| AOZ1360_12 | 制造商:AOSMD 制造商全称:Alpha & Omega Semiconductors 功能描述:28V Programmable Current-Limited Load Switch |
发布紧急采购，3分钟左右您将得到回复。