参数资料
| 型号： | AP2111MPG-13 |
| 厂商： | Diodes Inc |
| 文件页数： | 10/14页 |
| 文件大小： | 0K |
| 描述： | IC USB SWITCH 2.45A CURR 8MSOP |
| 标准包装： | 1 |
| 类型： | USB 开关 |
| 输出数： | 1 |
| Rds（开）： | 115 毫欧 |
| 内部开关： | 是 |
| 电流限制： | 2.45A |
| 输入电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -35°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-TSSOP，8-MSOP（0.118"，3.00mm 宽）裸露焊盘 |
| 供应商设备封装： | 8-MSOP-EP |
| 包装： | 标准包装 |
| 产品目录页面： | 1136 (CN2011-ZH PDF) |
| 其它名称： | AP2111MPG-13DIDKR |
AP2101/AP2111
Application Information (cont.)
Thermal Protection
Thermal protection prevents the IC from damage when heavy-overload or short-circuit faults are present for extended periods of time. The
AP2101/AP2111 implements a thermal sensing to monitor the operating junction temperature of the power distribution switch. Once the die
temperature rises to approximately 140°C due to excessive power dissipation in an over-current or short-circuit condition the internal thermal
sense circuitry turns the power switch off, thus preventing the power switch from damage. Hysteresis is built into the thermal sense circuit allowing
the device to cool down approximately 25°C before the switch turns back on. The switch continues to cycle in this manner until the load fault or
input power is removed. The FLG open-drain output is asserted when an over-temperature shutdown or over-current occurs with 7-ms deglitch.
Under-Voltage Lockout (UVLO)
Under-voltage lockout function (UVLO) keeps the internal power switch from being turned on until the power supply has reached at least 1.9V,
even if the switch is enabled. Whenever the input voltage falls below approximately 1.9V, the power switch is quickly turned off. This facilitates the
design of hot-insertion systems where it is not possible to turn off the power switch before input power is removed.
Host/Self-Powered HUBs
Hosts and self-powered hubs (SPH) have a local power supply that powers the embedded functions and the downstream ports. This power supply
must provide from 5.25V to 4.75V to the board side of the downstream connection under both full-load and no-load conditions. Hosts and SPHs
are required to have current-limit protection and must report over-current conditions to the USB controller. Typical SPHs are desktop PCs,
monitors, printers, and stand-alone hubs.
Generic Hot-Plug Applications
In many applications it may be necessary to remove modules or pc boards while the main unit is still operating. These are considered hot-plug
applications. Such implementations require the control of current surges seen by the main power supply and the card being inserted. The most
effective way to control these surges is to limit and slowly ramp the current and voltage being applied to the card, similar to the way in which a
power supply normally turns on. Due to the controlled rise times and fall times of the AP2101/AP2111, these devices can be used to provide a
softer start-up to devices being hot-plugged into a powered system. The UVLO feature of the AP2101/AP2111 also ensures that the switch is off
after the card has been removed, and that the switch is off during the next insertion.
By placing the AP2101/AP2111 between the VCC input and the rest of the circuitry, the input power reaches these devices first after insertion.
The typical rise time of the switch is approximately 1ms, providing a slow voltage ramp at the output of the device. This implementation controls
system surge current and provides a hot-plugging mechanism for any device.
AP2101/AP2111
Document number: DS32015 Rev. 3 - 2
10 of 14
January 2013
? Diodes Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| AP2141WG-7 | IC PWR SW USB 1CH 0.5A SOT-25-5 |
| AP2142ASG-13 | IC PWR SW USB 2CH 0.5A 8-SOIC |
| AP2152MPG-13 | IC PWR SW USB 2CH 0.5A 8-MSOP |
| AP2155MPG-13 | IC SINGLE USB SWITCH 800MA 8MSOP |
| AP2156MPG-13 | IC USB PWR SWITCH .5A DUAL 8MSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AP2111SG-13 | 功能描述:电源开关 IC - 配电 2A/5.5V SNGL CHANL CURRENT-LIMIT USB SW RoHS:否 制造商:Exar 输出端数量:1 开启电阻（最大值）:85 mOhms 开启时间（最大值）:400 us 关闭时间（最大值）:20 us 工作电源电压:3.2 V to 6.5 V 电源电流（最大值）: 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOT-23-5 |
| AP2112 | 制造商:BCDSEMI 制造商全称:BCD Semiconductor Manufacturing Limited 功能描述:600mA CMOS LDO REGULATOR WITH ENABLE |
| AP2112_12 | 制造商:BCDSEMI 制造商全称:BCD Semiconductor Manufacturing Limited 功能描述:600mA CMOS LDO REGULATOR WITH ENABLE |
| AP2112K-1.2TRG1 | 制造商:Diodes Incorporated 功能描述:LDO CMOS HICURR SOT25 T&R 3K - Tape and Reel |
| AP2112K-1.8TRG1 | 制造商:Diodes Incorporated 功能描述:LDO CMOS HICURR SOT25 T&R 3K - Tape and Reel 制造商:Diodes Incorporated 功能描述:IC REG LDO 1.8V 0.6A SOT25 |
发布紧急采购，3分钟左右您将得到回复。