- 您现在的位置：买卖IC网 > PDF目录17067 > AP2172SG-13 (Diodes Inc)IC PWR SWITCH DUAL USB 1A 8-SOIC PDF资料下载
参数资料
| 型号： | AP2172SG-13 |
| 厂商： | Diodes Inc |
| 文件页数： | 14/17页 |
| 文件大小： | 0K |
| 描述： | IC PWR SWITCH DUAL USB 1A 8-SOIC |
| 产品变化通告： | Copper Bond Wire Change 13/Jan/2012 |
| 标准包装： | 1 |
| 类型： | USB 开关 |
| 输出数： | 2 |
| Rds（开）： | 160 毫欧 |
| 内部开关： | 是 |
| 电流限制： | 1.5A |
| 输入电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOP |
| 包装： | 标准包装 |
| 产品目录页面： | 1137 (CN2011-ZH PDF) |
| 其它名称： | AP2172SGDIDKR |
AP2162/AP2172
1A DUAL CHANNEL CURRENT-LIMITED POWER
SWITCH
Application Note
(Continued)
Thermal Protection
Thermal protection prevents the IC from damage when heavy-overload or short-circuit faults are present for
extended periods of time. The AP2162/AP2172 implements a thermal sensing to monitor the operating
junction temperature of the power distribution switch. Once the die temperature rises to approximately 140°C
due to excessive power dissipation in an over-current or short-circuit condition the internal thermal sense
circuitry turns the power switch off, thus preventing the power switch from damage. Hysteresis is built into
the thermal sense circuit allowing the device to cool down approximately 25°C before the switch turns back
on. The switch continues to cycle in this manner until the load fault or input power is removed. The
FLG open-drain output is asserted when an over-temperature shutdown or over-current occurs with 7-ms
deglitch.
Under-voltage Lockout (UVLO)
Under-voltage lockout function (UVLO) keeps the internal power switch from being turned on until the power
supply has reached at least 1.9V, even if the switch is enabled. Whenever the input voltage falls below
approximately 1.9V, the power switch is quickly turned off. This facilitates the design of hot-insertion systems
where it is not possible to turn off the power switch before input power is removed.
Host/Self-Powered HUBs
Hosts and self-powered hubs (SPH) have a local power supply that powers the embedded functions and the
downstream ports (see Figure 2). This power supply must provide from 5.25V to 4.75V to the board side of
the downstream connection under both full-load and no-load conditions. Hosts and SPHs are required to
have current-limit protection and must report over-current conditions to the USB controller. Typical SPHs are
desktop PCs, monitors, printers, and stand-alone hubs.
Figure 2. Typical Two-Port USB Host / Self-Powered Hub
Generic Hot-Plug Applications
In many applications it may be necessary to remove modules or pc boards while the main unit is still
operating. These are considered hot-plug applications. Such implementations require the control of current
surges seen by the main power supply and the card being inserted. The most effective way to control these
surges is to limit and slowly ramp the current and voltage being applied to the card, similar to the way in
which a power supply normally turns on. Due to the controlled rise times and fall times of the
AP2162/AP2172, these devices can be used to provide a softer start-up to devices being hot-plugged into a
powered system. The UVLO feature of the AP2162/AP2172 also ensures that the switch is off after the card
has been removed, and that the switch is off during the next insertion.
By placing the AP2162/AP2172 between the V CC input and the rest of the circuitry, the input power reaches
these devices first after insertion. The typical rise time of the switch is approximately 1ms, providing a slow
voltage ramp at the output of the device. This implementation controls system surge current and provides a
hot-plugging mechanism for any device.
AP2162/AP2172 Rev. 5
14 of 17
FEBRUARY 2009
? Diodes Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| MIC2005-0.8LYM5 TR | IC DISTRIBUTION SW 0.8A SOT23-5 |
| GBC08DREN-S93 | CONN EDGECARD 16POS .100 EYELET |
| RCA18DTKN | CONN EDGECARD 36POS DIP .125 SLD |
| GCM25DCSD | CONN EDGECARD 50POS DIP .156 SLD |
| RP40-4815DGW/N | CONV DC/DC 40W 18-75VIN +/-15V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AP2176 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:1A DUAL CHANNEL CURRENT-LIMITED POWER SWITCH |
| AP2176MPG-13 | 功能描述:电源开关 IC - USB INTRFCE EN ACTIVE HI DUAL CHN 1A 2.7-5.5V RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube |
| AP2176SG-13 | 功能描述:电源开关 IC - USB INTRFCE EN ACTIVE HI DUAL CHN 1A 2.7-5.5V RoHS:否 制造商:Micrel 电源电压-最小:2.7 V 电源电压-最大:5.5 V 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装 / 箱体:SOIC-8 封装:Tube |
| AP2181 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:1.5A SINGLE CHANNEL CURRENT-LIMITED POWER |
| AP2181_0906 | 制造商:DIODES 制造商全称:Diodes Incorporated 功能描述:1.5A SINGLE CHANNEL CURRENT-LIMITED POWER |
发布紧急采购，3分钟左右您将得到回复。