- 您现在的位置：买卖IC网 > PDF目录381285 > APL5913-KAC-TRL (Anpec Electronics Corporation) 0.8V Reference Ultra Low Dropout (0.25V@3A) Linear Regulator PDF资料下载
参数资料
| 型号： | APL5913-KAC-TRL |
| 厂商： | Anpec Electronics Corporation |
| 英文描述： | 0.8V Reference Ultra Low Dropout (0.25V@3A) Linear Regulator |
| 中文描述： | 0.8V的参考超低压降（为0.25V @ 3A）条线性稳压器 |
| 文件页数： | 12/19页 |
| 文件大小： | 518K |
| 代理商： | APL5913-KAC-TRL |
Copyright
ANPEC Electronics Corp.
Rev. A.4 - May., 2005
APL5913
www.anpec.com.tw
12
Functional Description ( Cont.)
Application Information
Power Sequencing
The power sequencing of VIN and VCNTL is not necessary
to be concerned. But do not apply a voltage to VOUT
for a long time when the main voltage applied at VIN is
not present. The reason is the internal parasitic diode
from VOUT to VIN conducts and dissipates power
without protections due to the forward-voltage.
Output Capacitor
The APL5913 requires a proper output capacitor to
maintain stability and improve transient response over
temperature and current. The output capacitor selection
is to select proper ESR(equivalent series resistance)
and capacitance of the output capacitor for good stability
and load transient response.
provides very fast transient response and less load
regulation. It compares the reference with the feedback
voltage and amplifies the difference to drive the output
NMOS which provides load current from VIN to VOUT.
Current-Limit
The APL5913 monitors the current via the output
NMOS and limits the maximum current to prevent load
and APL5913 from damages during overload or short-
circuit conditions.
Under-Voltage Protection (UVP)
The APL5913 monitors the voltage on FB pin after
soft-start process is finished. Therefore the UVP is
disable during soft-start. When the voltage on FB pin
falls below the under-voltage threshold, the UVP
circuit shuts off the output immediately. After a while,
the APL5913 starts a new soft-start to regulate output.
Thermal Shutdown
A thermal shutdown circuit limits the junction temperature
of APL5913. When the junction temperature exceeds
+150°C, a thermal sensor turns off the output NMOS,
allowing the device to cool down. The regulator regulates
the output again through initiation of a new soft-start
cycle after the junction temperature cools by 50°C,
resulting in a pulsed output during continuous thermal
overload conditions. The thermal shutdown designed
Output Voltage Regulation (Cont.)
with a 50
o
C hysteresis lowers the average junction
temperature during continuous thermal overload
conditions, extending life time of the device.
For normal operation, device power dissipation should
be externally limited so that junction temperatures will
not exceed +125°C.
Enable Control
The APL5913 has a dedicated enable pin (EN). A logic
low signal (V
EN
< 0.3V) applied to this pin shuts down
the output. Following a shutdown, a logic high signal
re-enables the output through initiation of a new
softstart cycle. Left open, this pin is pulled up by an
internal current source (10
μ
A typical) to enable
operation. It’s not necessary to use an external transistor
to save cost.
Power-OK and Delay
The APL5913 indicates the status of the output voltage
by monitoring the feedback voltage (V
FB
) on FB pin.
As the V
FB
rises and reaches the rising Power-OK
threshold (V
POK
), an internal delay function starts to
perform a delay time. At the end of the delay time, the
IC turns off the internal NMOS of the POK to indicate
the output is OK. As the V
FB
falls and reaches the
falling Power-OK threshold (V
PNOK
), the IC immediately
turns on the NMOS of the POK to indicate the output
is not OK without a delay time.
相关PDF资料 |
PDF描述 |
|---|---|
| APL5913-KAC-TU | 0.8V Reference Ultra Low Dropout (0.25V@3A) Linear Regulator |
| APL5913-KAC-TUL | 0.8V Reference Ultra Low Dropout (0.25V@3A) Linear Regulator |
| APL6535 | Two-Channel Supervisory IC |
| APL6535BI-TR | Two-Channel Supervisory IC |
| APL6535BI-TRL | Two-Channel Supervisory IC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| APL6 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Analog IC |
| APL602B2 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Volts:600V RDS(ON)0.125Ohms ID(cont):49Amps|Linear MOSFETs |
| APL602B2G | 功能描述:MOSFET N-CH 600V 49A T-MAX RoHS:是 类别:分离式半导体产品 >> FET - 单 系列:- 标准包装:1,000 系列:MESH OVERLAY™ FET 型:MOSFET N 通道，金属氧化物 FET 特点:逻辑电平门 漏极至源极电压(Vdss):200V 电流 - 连续漏极(Id) @ 25° C:18A 开态Rds（最大）@ Id, Vgs @ 25° C:180 毫欧 @ 9A，10V Id 时的 Vgs(th)（最大）:4V @ 250µA 闸电荷(Qg) @ Vgs:72nC @ 10V 输入电容 (Ciss) @ Vds:1560pF @ 25V 功率 - 最大:40W 安装类型:通孔 封装/外壳:TO-220-3 整包 供应商设备封装:TO-220FP 包装:管件 |
| APL602J | 功能描述:MOSFET N-CH 600V 43A SOT-227 RoHS:是 类别:半导体模块 >> FET 系列:- 标准包装:10 系列:* |
| APL602L | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Volts:600V RDS(ON)0.125Ohms ID(cont):49Amps|Linear MOSFETs |
发布紧急采购，3分钟左右您将得到回复。