参数资料
型号: APW7057KC-TU
厂商: Anpec Electronics Corporation
英文描述: High Power Step-Down Synchronous DC/DC Controller
中文描述: 高功率降压型同步DC / DC控制器
文件页数: 1/14页
文件大小: 154K
代理商: APW7057KC-TU
High Pow er Step-Dow n Synchronous DC/ DC Controller
Copyright
ANPEC Electronics Corp.
Rev. A.3 - Oct., 2003
APW 7057
www.anpec.com.tw
1
ANPEC reserves the right to make changes to improve reliability or manufacturability without notice, and
advise customers to obtain the latest version of relevant information to verify before placing orders.
Operates from +5V Input
0.8V Internal Reference Voltage
- ±1.5% Accuracy Over Line, Load and Temp.
0.8V to V
CC
Output Range
Full Duty Cycle Range
- 0% to 100%
Internal Loop Compensation
Internal Soft Start
- Typical 2ms
Programmable Over-Current Protection
- Lossless Sensing Using MOSFET R
DS (ON)
Under-Voltage Protection
Drives External N-Channel MOSFETs
Shutdown Control
Small SOP-8 Package
Features
Applications
Motherboard
Graphics Cards
Cable or DSL Modems, Set Top Boxes
DSP Supplies
Memory Supplies
5V Input DC-DC Regulators
Distributed Power Supplies
General Description
The APW7057 is a 300kHz constant frequency volt-
age mode synchronous switching controller that drives
external N-channel MOSFETs. When the input sup-
ply drops close to output, the upper MOSFET remains
on, achieving 100% duty cycle. Internal loop compen-
sation is optimized for fast transient response, elimi-
nating external compensation network. The precision
0.8V reference makes this part suitable for a wide va-
riety of low voltage applications. Soft start is internally
set to 2ms, limiting the input in-rush current and pre-
venting the output from overshoot during powering up.
The APW7057 has over current and short circuit
protections. Over current protection is achieved by
monitoring the voltage drop across the high side
MOSFET, eliminating the need for a current sens-
ing resistor and short circuit condition is detected
through the FB pin. If either fault conditions occur,
the APW7057 would initiate the soft start cycle. After
three cycles and if the fault condition persists, the
controller will be shut down.
To restart the controller,
either recycle the V
CC
supply or momentarily pull the
OSCSET pin below 1.25V.
The APW7057 can be shutdown by pulling the OCSET
pin below 1.25V. In shutdown, both gate drive signals
will be low. The controller is available in a small SOP-
8 package.
Pinouts
BOOT
UGATE
OCSET
GND
LGATE
FB
VCC
PHASE
1
2
3
4
8
6
7
5
SOP-8 (Top View )
相关PDF资料
PDF描述
APW7060 Dual Controllers - Step Down Synchronous PWM and Linear Controller
APW7060K Dual Controllers - Step Down Synchronous PWM and Linear Controller
APW7075KAC-TUL Step-Up Converter and LDO Combo
APW7075OC-TR Step-Up Converter and LDO Combo
APW7075OC-TRL Step-Up Converter and LDO Combo
相关代理商/技术参数
参数描述
APW7058 制造商:ANPEC 制造商全称:Anpec Electronics Coropration 功能描述:Synchronous Buck PWM and Linear Controllers
APW7058KC-TR 制造商:ANPEC 制造商全称:Anpec Electronics Coropration 功能描述:Synchronous Buck PWM and Linear Controllers
APW7058KC-TRL 制造商:ANPEC 制造商全称:Anpec Electronics Coropration 功能描述:Synchronous Buck PWM and Linear Controllers
APW7058KC-TU 制造商:ANPEC 制造商全称:Anpec Electronics Coropration 功能描述:Synchronous Buck PWM and Linear Controllers
APW7058KC-TUL 制造商:ANPEC 制造商全称:Anpec Electronics Coropration 功能描述:Synchronous Buck PWM and Linear Controllers