参数资料
| 型号： | ARXP1012 |
| 厂商： | Panasonic Electric Works |
| 文件页数： | 5/5页 |
| 文件大小： | 0K |
| 描述： | RELAY RF SPDT 500MA 12V |
| 其它有关文件： | Standards Chart |
| 产品变化通告： | RX, RX-P Relays Discontinuation Mar/2012 |
| 产品目录绘图： | ARX(P) Series ARX(P) Series Footprint ARX(P) Series Circuit |
| 标准包装： | 50 |
| 系列： | ARXP |
| 继电器类型： | RF |
| 线圈类型： | 无锁存 |
| 线圈电流： | 16.7mA |
| 线圈电压： | 12VDC |
| 触点形式： | SPDT（1 C 型） |
| 触点额定值（电流）： | 500mA |
| 切换电压： | 30VDC - 最小值 |
| 关闭电压（最大）： | 9 VDC |
| 关闭电压（最小）： | 1.2 VDC |
| 安装类型： | 通孔 |
| 端接类型： | PC 引脚 |
| 包装： | 管件 |
| 触点材料： | 镀金 |
| 操作时间： | 10ms |
| 释放时间： | 6ms |
| 线圈功率： | 200 mW |
| 线圈电阻： | 720 欧姆 |
| 工作温度： | -40°C ~ 70°C |
| 产品目录页面： | 2598 (CN2011-ZH PDF) |
| 其它名称： | 255-2719 |
RX-P (ARXP1)
PORT2
Agilent
7. Latching relay
1) To ensure accurate operation of the
latching type amidst surrounding
temperature changes and other factors
that might affect the set and reset pulse
times, we recommend a coil impress set
and reset pulse width of at least 30 ms at
the rated operation voltage.
2) The latching type relay is shipped in
the reset position. But jolts during
transport or impacts during installation
can change the reset position. It is,
therefore, advisable to build a circuit in
which the relay can be initialized (set and
reset) just after turning on the power.
8. Measuring method
50 ? type
1 2
Network
analyzer
1 2
Te c h n o l o g i e s
E8363B
PORT1
Connect connectors 1 and 2 respectively
to PORT 1 and PORT 2. Perform
calibration using the 3.5 mm calibration
kit (HP85052B).
No. Product name Contents
PC board for correction
Dimensions (mm inch )
8.57 (a+b)
.337 (a+b)
16
.630
2.0 6.0
.079 .236
8.57 (a+b)
.337 (a+b)
Solder surface-mount
(SMA) type connectors.
Material: Glass PTFE double-sided
through hole PC board R-4737
( Panasonic Corporation )
Board thickness: t = 0.8 mm .031 inch
Copper plating: 18 μ m
Connector (SMA type receptacle)
Product name: 01K1808-00 (Waka
Manufacturing Co., Ltd.)
Value has compensation PC board
subtracted only for insertion loss.
(Eliminate loss of connector and PC
board.)
9. Others
1) The switching lifetime is de?ned under
2) Use the relay within speci?cations
such as coil rating, contact rating and on/
off service life. If used beyond limits, the
relay may overheat, generate smoke or
catch ?re.
3) Be careful not to drop the relay. If
accidentally dropped, carefully check its
appearance and characteristics before
use.
4) Be careful to wire the relay correctly.
Otherwise, malfunction, overheat, ?re or
other trouble may occur.
5) If a relay stays on in a circuit for many
months or years at a time without being
activated, circuit design should be
reviewed so that the relay can remain
non-excited. A coil that receives current
all the time heats, which degrades
insulation earlier than expected. A
latching type relay is recommended for
such circuits.
6) If silicone materials (e.g., silicone
rubbers, silicone oils, silicone coating
agents, silicone sealers) are used in the
vicinity of the relay, the gas emitted from
the silicone may adhere to the contacts of
the relay during opening and closing and
lead to improper contact. If this is the
case, use a material other than silicone.
1
2
Agilent
85130-60011
SUHNER
SUCOFLEX104
Adapter
2.4mm-3.5mm female
.095inch-.138inch female
Cable
3.5mm-3.5mm male
.138inch-.138inch male
the standard test condition speci?ed in
the JIS C 5442 standard (temperature 15
to 35 ° C 59 to 95 ° F , humidity 25 to
85%R.H.). Check this with the real device
as it is affected by coil driving circuit, load
For general cautions for use, please
refer to the “General Application
Guidelines”.
After calibration, connect the D.U.T.
board and measure. However,
connectors other than those for
measurement should be connected with
a 50 ? termination resistor.
PC board
Dimensions (mm inch )
24
.945
16
.630
2.0 6.0
.079 .236
type, activation frequency, activation
phase, ambient conditions and other
factors.
Also, be especially careful of loads such
as those listed below.
? When used for AC load-operating and
the operating phase is synchronous,
rocking and fusing can easily occur due
to contact shifting.
? When high-frequency opening and
closing of the relay is performed with a
load that causes arcs at the contacts,
nitrogen and oxygen in the air is fused by
the arc energy and HNO 3 is formed. This
can corrode metal materials.
Three countermeasures for these are
listed here.
(1) Incorporate an arc-extinguishing
a
b
Solder surface-mount
(SMA) type connectors.
circuit.
(2) Lower the operating frequency
(3) Lower the ambient humidity
Panasonic Corporation
Automation Controls Business Unit
industrial.panasonic.com/ac/e
ASCTB75E 201201-T
相关PDF资料 |
PDF描述 |
|---|---|
| CFT-8 | TERM BARRIER 8CIRC SGL ROW .375 |
| ARXP1003 | RELAY RF SPDT 500MA 3V |
| 431001-22-0 | TERM BARRIER 22CIRC 1 ROW .4375 |
| OSTYK60320330 | CONN BARRIER STRIP 20CIRC 10MM |
| OSTYK44220030 | CONN BARRIER STRIP 20CIRC 9.50MM |
相关代理商/技术参数 |
参数描述 |
|---|---|
| ARXP1024 | 功能描述:通用继电器 RELAY SPDT 3GHZ 60W 24VDC RoHS:否 制造商:Omron Electronics 触点形式:1 Form A (SPST-NO) 触点电流额定值:150 A 线圈电压:24 VDC 线圈电阻:144 Ohms 线圈电流:167 mA 切换电压:400 V 安装风格:Chassis 触点材料: |
| ARXP104H | 功能描述:通用继电器 RELAY SPDT 3GHZ 60W 4.5VDC RoHS:否 制造商:Omron Electronics 触点形式:1 Form A (SPST-NO) 触点电流额定值:150 A 线圈电压:24 VDC 线圈电阻:144 Ohms 线圈电流:167 mA 切换电压:400 V 安装风格:Chassis 触点材料: |
| ARXP1103 | 功能描述:SM MCRWV RLY 3GHZ 3V 制造商:panasonic electric works 系列:* 零件状态:有效 标准包装:50 |
| ARXP1106 | 功能描述:SM MCRWV RLY 3GHZ 6V 制造商:panasonic electric works 系列:* 零件状态:有效 标准包装:50 |
| ARXP1109 | 制造商:Panasonic Electric Works 功能描述:Electromechanical Relay SPDT 0.5A 9VDC 405Ohm Through Hole |
发布紧急采购，3分钟左右您将得到回复。