- 您现在的位置：买卖IC网 > PDF目录20251 > AS1115-BQFT (ams)IC DVR LED 64LED/7SEG I2C 24UQFN PDF资料下载
参数资料
| 型号： | AS1115-BQFT |
| 厂商： | ams |
| 文件页数： | 16/26页 |
| 文件大小： | 0K |
| 描述： | IC DVR LED 64LED/7SEG I2C 24UQFN |
| 产品培训模块： | AS1115 Overview |
| 标准包装： | 1 |
| 显示器类型： | LED |
| 配置： | 8 x（7 段），64 LED |
| 接口： | I²C |
| 数字或字符： | 8 位数字 |
| 电流 - 电源： | 335mA |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-UFQFN 裸露焊盘 |
| 供应商设备封装： | 24-TQFN（4x4） |
| 包装： | 标准包装 |
| 其它名称： | AS1115-BQFTDKR |
AS1115
Datasheet - D e t a i l e d D e s c r i p t i o n
Table 11. No-Decode Mode Data Bits and Corresponding Segment Lines
D7
D6
D5
D4
D3
D2
D1
D0
Corresponding Segment Line
DP
A
B
C
D
E
F
G
I2C Self Addressing
If this feature is used, 2 of the 16 key readback nodes can be left open or shorted for self-addressing. This is done with KEYA together with
SEGG (A0) and SEGF (A1). This two nodes cannot be used for key-readback in this case. After startup all devices have the predefined address
0000000. A single command for self addressing will update all connected AS1115. This command has to be done after startup or every time the
AS1115 gets disconnected from the supply. The I2C address definition must be done with fixed connection, since I2C detection is excluded from
debounce time of key registers.geht
Note: A short writes a logical “0” whereas an open writes a logical “1” as address bit (see Figure 26) .
Table 12. Self Addressing Register (Address (HEX) = 0x2D))
D7
D6
D5
D4
D3
D2
D1
D0
Factory-set IC address
User-set IC address
X
X
X
X
X
X
X
X
X
X
X
X
X
X
0
1
Figure 26. Address Coding
Keyscan Register
These two registers contain the result of the keyscan input of the 16 keys. To ensure proper results the data in these registers are updated only
if the logic data scanned is stable for 20ms (debounce time). A change of the data stored within these two registers is indicated by a logic low on
the IRQ pin. The IRQ is high-impedance if a read operation on the key scan registers is started.
Table 13. LED Diagnostic Register Address
Register HEX Address
0x1C
0x1D
Key
KEYA
KEYB
D7
DP
D6
A
D5
B
Segment
D4
C
D3
D
D2
E
D1
F
D0
G
Note: If I2C self addressing is used segment G&F of KEYA is used for the two LSB of the I2C address. In this case these two nodes cannot be
used as a key. Additionally the debounce time is disabled for these two bits.
The data within the keyscan register is updated continuously during every cycle (1/10 of refresh rate). Therefore, to get a valid read-
back of keys it is recommended to read out the keyscan registers immediately after the IRQ is triggered. A short writes a logical “0”
whereas an open writes a logical “1” as keyscan register bit.
Note: If the blink_en bit (bit D4 in the Feature Register 0x0E) is set to ‘1’, the keyscan is not returning a valid value.
Revision 1.08
15 - 25
相关PDF资料 |
PDF描述 |
|---|---|
| VE-21L-EV-F1 | CONVERTER MOD DC/DC 28V 150W |
| ACM28DSEN-S243 | CONN EDGECARD 56POS .156 EYELET |
| VE-213-EV-F3 | CONVERTER MOD DC/DC 24V 150W |
| V375B36C300BF2 | CONVERTER MOD DC/DC 36V 300W |
| ABM28DSEN-S243 | CONN EDGECARD 56POS .156 EYELET |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AS1115BSST | 制造商:ams 功能描述:T&R / QSOP 24pin |
| AS1115-BSST | 功能描述:LED显示驱动器 RoHS:否 制造商:Micrel 数位数量:5 片段数量: 安装风格:SMD/SMT 封装 / 箱体:PLCC-44 工作电源电压:4.75 V to 11 V 最大电源电流:10 mA 最大工作温度:+ 85 C 最小工作温度:- 40 C 封装:Tube |
| AS1115-BSST-CUT TAPE | 制造商:AMS 功能描述:AS Series 5.5 V 3.4 MHz SMT I2C Interfaced LED Driver with Keyscan - QSOP-24 |
| AS1115DB | 制造商:AMS 功能描述:0 |
| AS1115-DB-Blue | 制造商:ams 功能描述:AS1115 Demo Brd w/blue LEDs |
发布紧急采购，3分钟左右您将得到回复。