- 您现在的位置：买卖IC网 > PDF目录13808 > AS1335-BTDT-100 (ams)IC REG BUCK SYNC 1V 1.5A 10WFDFN PDF资料下载
参数资料
| 型号： | AS1335-BTDT-100 |
| 厂商： | ams |
| 文件页数： | 14/19页 |
| 文件大小： | 0K |
| 描述： | IC REG BUCK SYNC 1V 1.5A 10WFDFN |
| 标准包装： | 1,000 |
| 类型： | 降压（降压） |
| 输出类型： | 固定 |
| 输出数： | 1 |
| 输出电压： | 1V |
| 输入电压： | 2.6 V ~ 5.25 V |
| PWM 型： | 电压模式 |
| 频率 - 开关： | 1.5MHz |
| 电流 - 输出： | 1.5A |
| 同步整流器： | 是 |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 10-WFDFN 裸露焊盘 |
| 包装： | 带卷 (TR) |
| 供应商设备封装： | 10-TDFN（3x3） |
AS1335
Datasheet - A p p l i c a t i o n I n f o r m a t i o n
V OUT
= V OUT × ----------------------- × ? ? ? ?
V IN 1
8 × C OUT × f
L × f
Δ V OUT
1 – -------------
------------------------------- + ESR
(EQ 5)
Higher value, low cost ceramic capacitors are available in very small case sizes, and their high ripple current, high volt-
age rating, and low ESR make them ideal for switching regulator applications. Because the AS1335 control loop is not
dependant on the output capacitor ESR for stable operation, ceramic capacitors can be used to achieve very low out-
put ripple and accommodate small circuit size.
At light loads, the converter operates in powersave mode and the output voltage ripple is in direct relation to the output
capacitor and inductor value used. Larger output capacitor and inductor values minimize the voltage ripple in power-
save mode and tighten DC output accuracy in powersave mode.
Input Capacitor Selection
In continuous mode, the source current of the PMOS is a square wave of the duty cycle V OUT /V IN . To prevent large
voltage transients while minimizing the interference with other circuits caused by high input voltage spikes, a low ESR
input capacitor sized for the maximum RMS current must be used. The maximum RMS capacitor current is given as:
I RMS = I MAX × ----------------------------------------------------------
V OUT × ( V IN – V OUT )
V IN
(EQ 6)
where the maximum average output current I MAX equals the peak current minus half the peak-to-peak ripple current,
I MAX = I LIM - Δ I L /2
This formula has a maximum at V IN = 2V OUT where I RMS = I OUT /2. This simple worst-case condition is commonly used
for design because even significant deviations only provide negligible affects.
The input capacitor can be increased without any limit for better input voltage filtering. Take care when using small
ceramic input capacitors. When a small ceramic capacitor is used at the input, and the power is being supplied through
long wires, such as from a wall adapter, a load step at the output, or V IN step on the input, can induce ringing at the VIN
pin. This ringing can then couple to the output and be mistaken as loop instability, or could even damage the part by
exceeding the maximum ratings.
Ceramic Input and Output Capacitors
When choosing ceramic capacitors for C IN and C OUT , the X5R or X7R dielectric formulations are recommended.
These dielectrics have the best temperature and voltage characteristics for a given value and size. Y5V and Z5U
dielectric capacitors, aside from their wide variation in capacitance over temperature, become resistive at high frequen-
cies and therefore should not be used.
Table 4. Recommended External Components
Name
Part Number
Value
Rating
Type
Size
Manufacturer
C OUT
T520B107M006ATE040
100μF
6.3V
Tantal
B Kemet
(3.5x2.8x1.9mm) www.kemet.com
C IN , C OUT
L
GRM21BR60J226ME39
MOS6020-222ML
MOS6020-472ML
22μF
2.2μH
4.7μH
6.3V
3.26A
1.82A
X5R
35m Ω
50m Ω
0805
6.8x6.0x2.4mm
6.8x6.0x2.4mm
Murata
Coilcraft
Because ceramic capacitors lose a lot of their initial capacitance at their maximum rated voltage, it is recommended
that either a higher input capacity or a capacitance with a higher rated voltage is used.
Revision 1.03
13 - 18
相关PDF资料 |
PDF描述 |
|---|---|
| V72B5C150BG | CONVERTER MOD DC/DC 5V 150W |
| GMA15DTAH | CONN EDGECARD 30POS R/A .125 SLD |
| MAX6721AUTYVD1+T | IC SUPERVISOR MPU SOT23-6 |
| MAX6721AUTZED1+T | IC SUPERVISOR MPU SOT23-6 |
| V72B5C150B | CONVERTER MOD DC/DC 5V 150W |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AS1335-BTDT-AD | 功能描述:IC REG BUCK SYNC ADJ 10WFDFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:50 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:5 V ~ 25 V 输入电压:2.3 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:600kHz，1.2MHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 包装:管件 供应商设备封装:8-MSOP |
| AS1336A/B EB | 制造商:AMS 功能描述:BOARD EVAL FOR AS1336A/B |
| AS1336A/B-EB | 制造商:ams 功能描述:AS1336A/B Evaluation Board |
| AS1336A-BQFT | 功能描述:IC REG BST SYNC ADJ 75MA 16TQFN RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 标准包装:50 系列:- 类型:升压（升压） 输出类型:可调式 输出数:1 输出电压:5 V ~ 25 V 输入电压:2.3 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:600kHz，1.2MHz 电流 - 输出:1A 同步整流器:无 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:8-TSSOP，8-MSOP（0.118"，3.00mm 宽） 包装:管件 供应商设备封装:8-MSOP |
| AS1336A-BQFT-AD | 制造商:AMS 功能描述:0 |
发布紧急采购，3分钟左右您将得到回复。