- 您现在的位置：买卖IC网 > PDF目录17130 > AS5043 DB V2 (ams)BOARD DEMO AS5043 PDF资料下载
参数资料
| 型号： | AS5043 DB V2 |
| 厂商： | ams |
| 文件页数： | 13/37页 |
| 文件大小： | 0K |
| 描述： | BOARD DEMO AS5043 |
| 标准包装： | 1 |
| 传感器类型： | 磁性，旋转位置 |
| 传感范围： | 360° |
| 接口： | USB |
| 电源电压： | 5V USB 或 9V |
| 嵌入式： | 是，MCU，8 位 |
| 已供物品： | 板，线缆 |
| 已用 IC / 零件： | AS5043 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
AS5043
Data Sheet – Programming the AS5043
12 Programming the AS5043
After power-on, programming the AS5043 is enabled with the rising edge of CSn and Prog = logic high. 16 bit
configuration data must be serially shifted into the OTP register via the Prog-pin. The first “CCW” bit is followed by the
zero position data (MSB first) and the Analog Output Mode setting as shown in Table 5. Data must be valid at the rising
edge of CLK (see Figure 10). Following this sequence, the voltage at pin Prog must be raised to the programming voltage
V PROG (see Figure 10). 16 CLK pulses (t PROG ) must be applied to program the fuses. To exit the programming mode, the
chip must be reset by a power-on-reset. The programmed data is available after the next power-up.
Note: During the programming process, the transitions in the programming current may cause high voltage spikes
generated by the inductance of the connection cable. To avoid these spikes and possible damage to the IC, the
connection wires, especially the signals PROG and VSS must be kept as short as possible. The maximum wire length
between the V PROG switching transistor and pin PROG (see Figure 12) should not exceed 50mm (2 inches).
To suppress eventual voltage spikes, a 10nF ceramic capacitor should be connected close to pins PROG and VSS. This
capacitor is only required for programming, it is not required for normal operation. The clock timing t clk must be selected at
a proper rate to ensure that the signal PROG is stable at the rising edge of CLK (see Figure 10). Additionally, the
programming supply voltage should be buffered with a 10μF capacitor mounted close to the switching transistor. This
capacitor aids in providing peak currents during programming. The specified programming voltage at pin PROG is 7.3 –
7.5V (see section 19.7). To compensate for the voltage drop across the V PROG switching transistor, the applied
programming voltage may be set slightly higher (7.5 - 8.0V, see Figure 12).
OTP Register Contents:
CCW
Counter Clockwise Bit
ccw=0 – angular value increases with clockwise rotation
ccw=1 – angular value increases with counterclockwise rotation
Z [9:0]: Programmable Zero / Index Position
FB_intEN: OPAMP gain setting: 0=external, 1=internal
RefExtEN: DAC reference: 0=internal, 1=external
ClampMd EN:
Analog output span: 0=0-100%,
1=10-90%*VDD
Output Range (OR0, OR1):
Analog Output Range Selection
[1:0] 00 = 360° 01 = 180°
10 = 90° 11 = 45°
Figure 10: Programming Access – OTP Write Cycle (section of)
CSn
t Datain
Prog
CCW
Z9
Z8
Z7
Z6
Z5
Z4
Z3
Z2
Z1
Z0
FB_int
EN
RefExt
EN
Clamp
Md En
Output
Range1
Output
Range0
CLK PROG
t Prog enable
1
t Datain valid
t clk
see text
Zero Position
8
Analog Modes
16
www.austriamicrosystems.com
Revision 1.80
12 – 36
相关PDF资料 |
PDF描述 |
|---|---|
| 38H202C | INDUCTOR 2.00UH 6.5A SMD |
| AP432AWL-7 | IC VREF SHUNT PREC ADJ SC-59-3 |
| L04026R8BHNTR | INDUCTOR THIN FILM 6.8NH 0402 |
| AIRD-01-180K | INDUCTOR PWR DRUM CORE 18UH |
| MAX1811ESA | IC BATT CHRGR LI+ USB-PWR 8-SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AS5043TR | 制造商:AMSCO 制造商全称:austriamicrosystems AG 功能描述:PROGRAMMABLE 360° MAGNETIC ANGLE ENCODER WITH ABSOLUTE SSI AND ANALOG OUTPUTS |
| AS5045 | 制造商:AMSCO 制造商全称:austriamicrosystems AG 功能描述:12 BIT PROGRAMMABLE MAGNETIC ROTARY ENCODER |
| AS5045 AB | 功能描述:BOARD ADAPTER AS5045 RoHS:否 类别:编程器，开发系统 >> 评估板 - 传感器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- |
| AS5045 DB | 制造商:ams 功能描述:Demoboard for AS5045 Rotary Encoder, Bulk |
| AS5045 DB V2 | 功能描述:BOARD DEMO AS5045 RoHS:否 类别:编程器，开发系统 >> 评估板 - 传感器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS Obsolescence Mitigation Program 标准包装:1 系列:- |
发布紧急采购，3分钟左右您将得到回复。