- 您现在的位置：买卖IC网 > PDF目录21928 > AS5163-HTST (ams)IC ENCODER ROTARY 14-TSSOP PDF资料下载
参数资料
| 型号： | AS5163-HTST |
| 厂商： | ams |
| 文件页数： | 9/37页 |
| 文件大小： | 0K |
| 描述： | IC ENCODER ROTARY 14-TSSOP |
| 应用说明： | AS5000 Series Magnet Selection Guide AS5000 Series Magnets for Extended Vertical Range |
| 标准包装： | 4,500 |
| 传感范围： | 30mT ~ 70mT |
| 类型： | 线性，旋转编码器 - 可编程 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 电流 - 电源： | 20mA |
| 输出类型： | 模拟，比率 |
| 特点： | 可编程 |
| 工作温度： | -40°C ~ 150°C |
| 封装/外壳： | 14-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 14-TSSOP |
| 包装： | 带卷 (TR) |
第1页第2页第3页第4页第5页第6页第7页第8页当前第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页
AS5163
Datasheet - D e t a i l e d D e s c r i p t i o n
7.1 Operation
The AS5163 operates at 5V ±10%, using two internal Low-Dropout (LDO) voltage regulators. For operation, the 5V supply is connected to pin
VDD . While VDD3 and VDD5 (LDO outputs) must be buffered by 2.2μF capacitors, the VDD requires a 1μF capacitor. All capacitors (low ESR
ceramic) are supposed to be placed close to the supply pins (see Figure 4) .
The VDD3 and VDD5 outputs are intended for internal use only. It must not be loaded with an external load.
Figure 4. Connections for 5V Supply Voltages
5V Operation
1 μ F
VDD 5
2.2μF
VDD 3
2.2 μF
VDD
LDO
Internal
VDD 4. 5 V
LDO
Internal
VDD 3.45V
4. 5 - 5.5V
GND
Notes:
1. The pins VDD3 and VDD5 must always be buffered by a capacitor. These pins must not be left floating, as this may
cause unstable internal supply voltages, which may lead to larger output jitter of the measured angle.
2. Only VDD is overvoltage protected up to 27V. In addition, the VDD has a reverse polarity protection.
7.1.1
VDD Voltage Monitor
VDD Overvoltage Management. If the voltage applied to the VDD pin exceeds the overvoltage upper threshold for longer than the detection
time, then the device enters a low power mode reducing the power consumption. When the overvoltage event has passed and the voltage
applied to the VDD pin falls below the overvoltage lower threshold for longer than the recovery time, then the device enters the normal mode.
VDD5 Undervoltage Management. When the voltage applied to the VDD5 pin falls below the undervoltage lower threshold for longer than
the VDD5_detection time, then the device stops the clock of the digital part and the output drivers are turned off to reduce the power
consumption. When the voltage applied to the VDD5 pin exceeds the VDD5 undervoltage upper threshold for longer than the VDD5_recovery
time, then the clock is restarted and the output drivers are turned on.
www.austriamicrosystems.com/AS5163
Revision 2.7
8 - 36
相关PDF资料 |
PDF描述 |
|---|---|
| D2VW-5L2A-1 | SWITCH 5A LEVER SPDT-NO SOLDER |
| D2VW-5-3MS | SWITCH 5A SPST-NO LEAD WIRE |
| ABJ363841 | SWITCH TURQ SPST LEAF SILV WIRE |
| D2FW-G083M | SWITCH LONGLEVER SPST-NO .1A SLD |
| 7488912455 | ANTENNA MULTILAYER 2.4-2.5GHZ |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AS5163HTSU | 制造商:AMSCO 制造商全称:austriamicrosystems AG 功能描述:12 BIT AUTOMOTIVE Angle Position Sensor |
| AS5163-HTSU | 功能描述:IC ENCODER PROG 12-BIT 14TSSOP RoHS:是 类别:传感器，转换器 >> 磁性 - 霍尔效应，数字式开关，线性，罗盘 (IC) 系列:- 标准包装:1 系列:- 传感范围:20mT ~ 80mT 类型:旋转 电源电压:4.5 V ~ 5.5 V 电流 - 电源:15mA 电流 - 输出（最大）:- 输出类型:数字式，PWM，8.5 位串行 特点:可编程 工作温度:-40°C ~ 150°C 封装/外壳:20-SSOP（0.209"，5.30mm 宽） 供应商设备封装:20-SSOP 包装:Digi-Reel® 其它名称:AS5132-HSST-500DKR |
| AS5163-HTSV | 制造商:AMSCO 制造商全称:austriamicrosystems AG 功能描述:12-Bit Automotive Angle Position Sensor |
| AS5163-TS_EK_AB | 功能描述:AS5163 - Magnetic, Rotary Position Sensor Evaluation Board 制造商:ams 系列:- 零件状态:有效 传感器类型:磁性，旋转位置 感应范围:360° 接口:模拟和数字 灵敏度:- 电压 - 电源:4.5 V ~ 5.5 V 嵌入式:否 所含物品:板 使用的 IC/零件:AS5163 标准包装:1 |
| AS5163-TS_EK_DB | 功能描述:AS5163 - Magnetic, Rotary Position Sensor Evaluation Board 制造商:ams 系列:- 零件状态:有效 传感器类型:磁性，旋转位置 感应范围:360° 接口:串行 灵敏度:- 电压 - 电源:9V 嵌入式:是，MCU，8 位 所含物品:板 使用的 IC/零件:AS5163 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。