- 您现在的位置：买卖IC网 > Datasheet目录961 > AS5245 DB (ams)BOARD DEMO AS5245 Datasheet资料下载
参数资料
| 型号： | AS5245 DB |
| 厂商： | ams |
| 文件页数： | 15/32页 |
| 文件大小： | 0K |
| 描述： | BOARD DEMO AS5245 |
| 标准包装： | 1 |
| 传感器类型： | 磁性，旋转位置 |
| 传感范围： | 360° |
| 接口： | USB |
| 电源电压： | 5V USB 或 9V |
| 嵌入式： | 是，MCU，8 位 |
| 已供物品： | 板，线缆 |
| 已用 IC / 零件： | AS5245 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页
AS5245
Data Sheet - D e t a i l e d D e s c r i p t i o n
Incremental Output Validity. During power on the incremental output is kept stable high until the offset compensation is finished and the
CSn is low (internal Pull Up) the first time. In quadrature mode A = B = Index = high indicates an invalid output. If the interpolator recognizes a
difference larger than 128 steps between two samples, it holds the last valid state. The interpolator synchronizes up again with the next valid
difference. This avoids undefined output burst, e.g. if no magnet is present.
8.2.4
Sync Mode
This mode is used to synchronize the external electronic with the AS5245. In this mode, two signals are provided at the pins DTEST1_A and
DTEST2_B. By setting of Md0=1 and Md1=1 in the OTP register, the Sync mode will be activated.
Figure 8. DTest1_A and DTest2_B
400μs (100μs)
DTest1_A
DTest1_B
Every rising edge at DTEST1_A indicates that new data in the device is available. With this signal it is possible to trigger an external customer
Microcontroller (interrupt) and start the SSI readout. DTEST2_B indicates the phase of available data.
8.2.5
Sine/Cosine Mode
This mode can be enabled by setting the OTP Factory-bit FS2. If this mode is activated, the 16 bit sinus and 16 bit cosines digital data of both
channels will be switched out. Due to the high resolution of 16 bits of the data stream, an accurate calculation can be done externally. In this
mode, the open drain outputs of DTEST1_A and DTEST2_B are switched to push-pull mode. At Pin MagDECn the clock impulse, at Pin
MagINCn the Enable pulse will be switched out. The pin PWM indicates, which phase of signal is being presented. The mode is not available in
the default mode.
Daisy Chain Mode
The Daisy Chain mode allows connection of several AS5245s in series, while still keeping just one digital input for data transfer (see “Data IN” in
Figure 9 ). This mode is accomplished by connecting the data output (DO; pin 9) to the data input (PDIO; pin 8) of the subsequent device. The
serial data of all connected devices is read from the DO pin of the first device in the chain. The length of the serial bit stream increases with every
connected device, it is n * (18+1) bits: n= number of devices. E.g. 38 bit for two devices, 57 bit for three devices, etc.
The last data bit of the first device (Parity) is followed by a dummy bit and the first data bit of the second device (D11), etc. (see Figure 10) .
Figure 9. Daisy Chain Hardware Configuration
μC
AS5245
Top Die
AS5245
Bottom Die
AS5245
Top Die
Data IN
DO
CSn
PDIO
CLK
DO
C Sn
PDIO
CLK
DO
CSn
PDIO
CLK
CLK
CSn
www.austriamicrosystems.com/AS5245
Revision 1.5
14 - 31
相关PDF资料 |
PDF描述 |
|---|---|
| AS5304-DK-1.0 | BOARD DEMO AS5304 |
| AS5311 DB | BOARD EVAL FOR AS5311 |
| ASEK712ELC-05B-T-DK | BOARD EVAL FOR ASEK712ELC-05B |
| ASPF240D3R | RELAY SSR 3A 240VAC SIP PHASE |
| ASX220A06 | RELAY TELECOM DPDT 10MA 6V |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AS5245-HMFM | 功能描述:IC ENCODER ROTARY 32-QFN 制造商:ams 系列:汽车级，AEC-Q100 零件状态:有效 编码器类型:磁性 输出类型:正交（增量） 每转脉冲数:- 电压 - 电源:3 V ~ 3.6 V，4.5 V ~ 5.5 V 致动器类型:外磁铁，不含 棘爪:无 内置开关:无 安装类型:表面贴装 朝向:- 端子类型:SMD（SMT）接片 旋转寿命（最少次数）:- 标准包装:1 |
| AS5245-HMFP | 功能描述:IC ENCODER ROTARY 32QFN 制造商:ams 系列:汽车级，AEC-Q100 零件状态:有效 编码器类型:磁性 输出类型:正交（增量） 每转脉冲数:- 电压 - 电源:3 V ~ 3.6 V，4.5 V ~ 5.5 V 致动器类型:外磁铁，不含 棘爪:无 内置开关:无 安装类型:表面贴装 朝向:- 端子类型:SMD（SMT）接片 旋转寿命（最少次数）:- 标准包装:4,000 |
| AS5245HQFT | 制造商:ams 功能描述:QFN 32 |
| AS5245-HQFT | 功能描述:IC ENCODER PROG 32-QFN RoHS:是 类别:传感器，转换器 >> 磁性 - 霍尔效应，数字式开关，线性，罗盘 (IC) 系列:- 标准包装:1 系列:- 传感范围:20mT ~ 80mT 类型:旋转 电源电压:4.5 V ~ 5.5 V 电流 - 电源:15mA 电流 - 输出（最大）:- 输出类型:数字式，PWM，8.5 位串行 特点:可编程 工作温度:-40°C ~ 150°C 封装/外壳:20-SSOP（0.209"，5.30mm 宽） 供应商设备封装:20-SSOP 包装:Digi-Reel® 其它名称:AS5132-HSST-500DKR |
| AS5245HQFT500 | 制造商:ams 功能描述:T&R / QFN 32 |
发布紧急采购，3分钟左右您将得到回复。