- 您现在的位置：买卖IC网 > PDF目录381454 > AT45DB081D-SSU (ATMEL CORP) 8-megabit 2.5-volt or 2.7-volt DataFlash PDF资料下载
参数资料
| 型号： | AT45DB081D-SSU |
| 厂商： | ATMEL CORP |
| 元件分类： | DRAM |
| 英文描述： | 8-megabit 2.5-volt or 2.7-volt DataFlash |
| 中文描述： | 8M X 1 FLASH 2.7V PROM, PDSO8 |
| 封装： | 0.150 INCH, GREEN, PLASTIC, MS-012AA, SOIC-8 |
| 文件页数： | 11/53页 |
| 文件大小： | 1105K |
| 代理商： | AT45DB081D-SSU |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页当前第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页
11
3596E–DFLASH–02/07
AT45DB081D
The
W
P pin can be asserted while the device is erasing, but protection will not be activated until
the internal erase cycle completes.
Figure 7-1.
Chip Erase
Note:
Refer to errata regarding Chip Erase on
page 52
.
7.8
Main Memory Page Program Through Buffer
This operation is a combination of the Buffer
W
rite and Buffer to Main Memory Page Program
with Built-in Erase operations. Data is first clocked into buffer 1 or buffer 2 from the input pin (SI)
and then programmed into a specified page in the main memory. To perform a main memory
page program through buffer for the DataFlash standard page size (264 bytes), a 1-byte opcode,
82H for buffer 1 or 85H for buffer 2, must first be clocked into the device, followed by three
address bytes. The address bytes are comprised of 3 don’t care bits, 12 page address bits,
(PA11 - PA0) that select the page in the main memory where data is to be written, and 9 buffer
address bits (BFA8 - BFA0) that select the first byte in the buffer to be written. To perform a
main memory page program through buffer for the binary page size (256 bytes), the opcode 82H
for buffer 1 or 85H for buffer 2, must be clocked into the device followed by three address bytes
consisting of 4 don’t care bits, 12 page address bits (A19 - A8) that specify the page in the main
memory to be written, and 8 buffer address bits (BFA7 - BFA0) that selects the first byte in the
buffer to be written. After all address bytes are clocked in, the part will take data from the input
pins and store it in the specified data buffer. If the end of the buffer is reached, the device will
wrap around back to the beginning of the buffer.
W
hen there is a low-to-high transition on the CS
pin, the part will first erase the selected page in main memory to all 1s and then program the
data stored in the buffer into that memory page. Both the erase and the programming of the
page are internally self-timed and should take place in a maximum time of t
EP
. During this time,
the status register will indicate that the part is busy.
8.
Sector Protection
Two protection methods, hardware and software controlled, are provided for protection against
inadvertent or erroneous program and erase cycles. The software controlled method relies on
the use of software commands to enable and disable sector protection while the hardware con-
trolled method employs the use of the
W
rite Protect (
W
P) pin. The selection of which sectors
that are to be protected or unprotected against program and erase operations is specified in the
nonvolatile Sector Protection Register. The status of whether or not sector protection has been
enabled or disabled by either the software or the hardware controlled methods can be deter-
mined by checking the Status Register.
Command
Byte 1
Byte 2
Byte 3
Byte 4
Chip Erase
C7H
94H
80H
9AH
Opcode
Byte 1
Opcode
Byte 2
Opcode
Byte 3
Opcode
Byte 4
CS
Each transition
represents 8 bits
SI
相关PDF资料 |
PDF描述 |
|---|---|
| AT45DB081D-SSU-2.5 | 8-megabit 2.5-volt or 2.7-volt DataFlash |
| AT45DB081D-SU | 8-megabit 2.5-volt or 2.7-volt DataFlash |
| AT45DB081D-SU-2.5 | 8-megabit 2.5-volt or 2.7-volt DataFlash |
| AT45DB081 | 8-Megabit 2.7-volt Only Serial DataFlash |
| AT45DB081-RC | 8-Megabit 2.7-volt Only Serial DataFlash |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT45DB081D-SSU SL383 | 制造商:Adesto Technologies 功能描述:Fuse Blade 4A 90V Slow Blow 2-Pin Lug Socket 制造商:Adesto Technologies Corporation 功能描述:DATAFLASH,8MBIT,SERIAL,2.7V,IND TEMP,GRN SOIC 150 - Tape and Reel |
| AT45DB081D-SSU SL383-AD | 功能描述:DATA FLASH 制造商:adesto technologies 系列:- 包装:剪切带（CT） 零件状态:停產 存储器类型:非易失 存储器格式:闪存 技术:FLASH 存储容量:8Mb （264 字节 x 4096 页） 时钟频率:66MHz 写周期时间 - 字，页:4ms 存储器接口:SPI 电压 - 电源:2.7 V ~ 3.6 V 工作温度:-40°C ~ 85°C（TC） 安装类型:表面贴装 封装/外壳:8-SOIC（0.154"，3.90mm 宽） 供应商器件封装:8-SOIC 标准包装:1 |
| AT45DB081D-SSU SL594 | 制造商:Adesto Technologies Corporation 功能描述: |
| AT45DB081D-SSU SL954 | 制造商:Adesto Technologies Corporation 功能描述:DATAFLASH,8MBIT,SERIAL,2.7V,IND TEMP,GRN SOIC 150 - Rail/Tube |
| AT45DB081D-SSU SL955 | 制造商:Adesto Technologies Corporation 功能描述:DATAFLASH - Rail/Tube |
发布紧急采购，3分钟左右您将得到回复。