参数资料
| 型号： | AT88SA102S-TSU-T |
| 厂商： | Atmel |
| 文件页数： | 9/25页 |
| 文件大小： | 0K |
| 描述： | IC PROD AUTHENTICATION SOT23-3 |
| 产品培训模块： | CryptoAuthentication™ Introduction |
| 标准包装： | 1 |
| 系列： | * |
| 其它名称： | AT88SA102S-TSU-TDKR |
17
6.3
BurnFuse
Burns a single one of the status fuse bits (Fuse[64] – Fuse[86]). No other fuses can be burned with this command – use
BurnSecure at personalization time to burn any of the first 88 fuses.
If the BurnFuse enable bit (Fuse 1) has been burned to a zero, then attempts to run this command will return an error.
The power supply pin must meet the VBURN specification during the entire BurnFuse command in order to burn fuses reliably. If
VCC is greater than or equal to 3.7V, then the BurnTime parameter should be set to 0x00 and the internal burn time will be up
to 250
s. If V
CC is less than 3.7V but greater than VBURN then the BurnTime parameter should be set to 0xFFFF and the
internal burn time will be up to 262ms. The chip does not internally check the supply voltage level.
There is a very small interval during tEXEC_BURN when the fuse element is actually being burned. During this interval the power
supply must not be removed and the watchdog timer must not be allowed to expire; or the fuse may end up in a state where it
reads as un-burned but cannot be burned.
Table 6-7.
Input Parameters
Name
Size
Notes
Opcode
BURNFUSE
1
0x04
Param1
FuseNum
1
Which bit within fuse array, minimum value is 64, and maximum value is 86
Param2
BurnTime
2
Must be 0x0000 if Vcc >+3.7 V; must be 0xFFFF otherwise
Data
Ignored
0
Table 6-8.
Output Parameters
Name
Size
Notes
Success
1
Upon successful execution, a value of zero will be returned by AT88SA102S
相关PDF资料 |
PDF描述 |
|---|---|
| AT88SA102S-SH-T | IC BATTERY AUTHENTICATION 8SOIC |
| LFXP6C-3TN144I | IC FPGA 5.8KLUTS 100I/O 144-TQFP |
| ABB66DHFT-S621 | EDGECARD 132PS .050 SMD W/O POST |
| MAX6495ATT+T | IC CNTRLR PROT SW 6TDFN |
| MAX4959ELB+T | IC CTLR HI VOLTAGE OVP 10-UDFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT88SA10HS | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:CryptoAuthentication? Host Security Chip |
| AT88SA10HS_10 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Atmel CryptoAuthentication Host Security Chip |
| AT88SA10HS_11 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:Atmel CryptoAuthentication Host Security Chip |
| AT88SA10HS-SH-T | 功能描述:序列号注册 58951-Eb CryptoAuth SHA-256 HST IC GRN RoHS:否 制造商:Maxim Integrated 数据总线宽度: 电源电压-最大: 电源电压-最小: 最大工作温度: 最小工作温度: 安装风格: 封装 / 箱体: |
| AT88SA10HS-TH-T | 功能描述:序列号注册 58951-Eb CryptoAuth SHA-256 HST IC GRN RoHS:否 制造商:Maxim Integrated 数据总线宽度: 电源电压-最大: 电源电压-最小: 最大工作温度: 最小工作温度: 安装风格: 封装 / 箱体: |
发布紧急采购，3分钟左右您将得到回复。