参数资料
| 型号： | AT88SC3216C-PU |
| 厂商： | Atmel |
| 文件页数： | 6/21页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 32KBIT 1.5MHZ 8DIP |
| 产品培训模块： | Crypto Products CryptoAuthentication™ Introduction |
| 标准包装： | 12,000 |
| 系列： | CryptoMemory® |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 32K (4K x 8) |
| 速度： | 5MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-DIP（0.300"，7.62mm） |
| 供应商设备封装： | 8-PDIP |
| 包装： | 管件 |
| 产品目录页面： | 1457 (CN2011-ZH PDF) |
Table 3.
AC Characteristics
Applicable over recommended operating range from V CC = +2.7 to 5.5V, T AC = -40°C to +85°C, CL = 30pF
( unless otherwise noted )
Symbol
f CLK
f CLK
f CLK
Parameter
Async Clock Frequency (V CC Range: +4.5 - 5.5V)
Async Clock Frequency (V CC Range: +2.7 - 3.3V)
Synch Clock Frequency
Clock Duty cycle
Min
1
1
0
40
Max
5
4
1
60
Units
MHZ
MHZ
MHZ
%
t R
t F
t R
t F
t AA
t HD.STA
t SU.STA
t HD.DAT
t SU.DAT
t SU.STO
t DH
t WR
t WR
Rise Time - I/O, RST
Fall Time - I/O, RST
Rise Time - CLK
Fall Time - CLK
Clock Low to Data Out Valid
Start Hold Time
Start Set-up Time
Data In Hold Time
Data In Set-up Time
Stop Set-up Time
Data Out Hold Time
Write Cycle Time (at 25 ° C)
Write Cycle Time (-40° to +85°C)
200
200
10
100
200
20
1
1
9% x period
9% x period
35
5
7
μ S
μ S
μ S
μ S
nS
nS
nS
nS
nS
nS
nS
mS
mS
4.
Device Operation for Synchronous Protocols
CLOCK and DATA TRANSITIONS : The SDA pin is normally pulled high with an external device. Data on the SDA pin
may change only during SCL low time periods (see Figure 5 on page 8). Data changes
during SCL high periods will indicate a start or stop condition as defined below.
START CONDITION :
STOP CONDITION :
ACKNOWLEDGE :
MEMORY RESET :
A high-to-low transition of SDA with SCL high is a start condition which must precede any
other command (see Figure 6 on page 8).
A low-to-high transition of SDA with SCL high is a stop condition. After a read sequence, the
stop command will place the EEPROM in a standby power mode (see Figure 6 on page 8).
All addresses and data words are serially transmitted to and from the EEPROM in 8-bit
words. The EEPROM sends a zero to acknowledge that it has received each word. This
happens during the ninth clock cycle.
After an interruption in protocol, power loss or system reset, any 2-wire part can be reset by
following these steps:
1.
Clock up to 9 cycles.
6
AT88SC3216C
5014KS–SMEM–08/09
相关PDF资料 |
PDF描述 |
|---|---|
| AT24C64B-10PU-2.7 | IC EEPROM 64KBIT 400KHZ 8DIP |
| BR93L76-W | IC EEPROM 8KBIT 2MHZ 8DIP |
| AT24C64BN-10SU-2.7 | IC EEPROM 64KBIT 400KHZ 8SOIC |
| BR24S256FJ-WE2 | IC EEPROM 256KBIT 400KHZ 8SOP |
| EP4CE15E22C8LN | IC CYCLONE IV FPGA 15K 144EQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT88SC3216CRF | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:CryptoRF Specification |
| AT88SC3216CRF_09 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:13.56 MHz CryptoRF? EEPROM Memory 32 Kbits |
| AT88SC3216CRF-L01B | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:13.56 MHz CryptoRF EEPROM Memory 32 Kbits |
| AT88SC3216CRF-MR1 | 功能描述:电可擦除可编程只读存储器 CRYPTORF 32K, 82pF RoHS:否 制造商:Atmel 存储容量:2 Kbit 组织:256 B x 8 数据保留:100 yr 最大时钟频率:1000 KHz 最大工作电流:6 uA 工作电源电压:1.7 V to 5.5 V 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-8 |
| AT88SC3216CRF-MS1 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:13.56 MHz CryptoRF EEPROM Memory 32 Kbits |
发布紧急采购，3分钟左右您将得到回复。