参数资料
| 型号： | AT88SC3216C-SU |
| 厂商： | Atmel |
| 文件页数： | 11/21页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 32KBIT 1.5MHZ 8SOIC |
| 产品培训模块： | Crypto Products CryptoAuthentication™ Introduction |
| 标准包装： | 12,000 |
| 系列： | CryptoMemory® |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 32K (4K x 8) |
| 速度： | 5MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 管件 |
AT88SC3216C
8.
9.
9.1.
Security Fuses
There are three fuses on the device that must be blown during the device personalization process. Each fuse locks
certain portions of the configuration memory as OTP memory. Fuses are designed for the module manufacturer, card
manufacturer and card issuer and should be blown in sequence, although all programming of the device and blowing of
the fuses may be performed at one final step.
Protocol Selection
The AT88SC3216C supports two different communication protocols.
Smart Card Applications : The asynchronous T = 0 protocol defined by ISO 7816-3 is used for compatibility with the
industry’s standard smart card readers.
Embedded Applications : A 2-wire serial interface is used for fast and efficient communication with logic or controllers.
The power-up sequence determines which of the two communication protocols will be used.
Asynchronous T = 0 Protocol
This power-up sequence complies with ISO 7816-3 for a cold reset in smart card applications.
?
?
?
?
V CC goes high; RST, I/O-SDA and CLK-SCL are low.
Set I/O-SDA in receive mode.
Provide a clock signal to CLK-SCL.
RST goes high after 400 clock cycles.
The device will respond with a 64-bit ATR code, including historical bytes to indicate the memory density within the
CryptoMemory family. Once the asynchronous mode has been selected, it is not possible to switch to the synchronous
mode without powering off the device.
Figure 10.
Vcc
I/O-SDA
Asynchronous T = 0 Protocol (Gemplus Patent)
ATR
RST
CLK-SCL
After a successful ATR, the Protocol and Parameter Selection (PPS) protocol, as defined by ISO 7816-3, may be used
to negotiate the communications speed with CryptoMemory devices 32 Kbits and larger. CryptoMemory supports D
values of 1, 2, 4, 8, 12, and 16 for an F value of 372. Also supported are D values of 8 and 16 for F = 512. This allows
selection of 8 communications speeds ranging from 9600 baud to 153,600 baud.
11
5014KS–SMEM–08/09
相关PDF资料 |
PDF描述 |
|---|---|
| XC6VCX195T-1FFG1156C | IC FPGA VIRTEX 6 199K 1156FFGBGA |
| AT88SC12816C-MJTG | CRYPTOMEM 128KBIT 16ZONE MODJ TW |
| XC5VLX50T-3FFG1136C | IC FPGA VIRTEX-5 50K 1136FBGA |
| AT88SC25616C-PU | IC EEPROM 256BIT 1.5MHZ 8DIP |
| AT24C256C-XHL-T | IC EEPROM 256KBIT IND 8TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT88SC3216C-WI | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:CryptoMemory 32 Kbit |
| AT88SC3216C-Y4I | 制造商:Atmel Corporation 功能描述:CRYPTOMEMORY 8PIN SAP - Rail/Tube |
| AT88SC410 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:ASIC |
| AT88SC450 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:ASIC |
| AT88SC54C | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Microcontroller |
发布紧急采购，3分钟左右您将得到回复。