参数资料
| 型号： | AT88SC3216C-SU |
| 厂商： | Atmel |
| 文件页数： | 13/21页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM 32KBIT 1.5MHZ 8SOIC |
| 产品培训模块： | Crypto Products CryptoAuthentication™ Introduction |
| 标准包装： | 12,000 |
| 系列： | CryptoMemory® |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 32K (4K x 8) |
| 速度： | 5MHz |
| 接口： | I²C，2 线串口 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-SOIC（0.154"，3.90mm 宽） |
| 供应商设备封装： | 8-SOIC |
| 包装： | 管件 |
AT88SC3216C
11.
11.1.
11.2.
Security Options
Anti-tearing
In the event of a power loss during a write cycle, the integrity of the device’s stored data may be recovered. This
function is optional: the host may choose to activate the anti-tearing function, depending on application requirements.
When anti-tearing is active, write commands take longer to execute, since more write cycles are required to complete
them, and data are limited to eight bytes.
Data are written first to a buffer zone in EEPROM instead of the intended destination address, but with the same
access conditions. The data are then written in the required location. If this second write cycle is interrupted due to a
power loss, the device will automatically recover the data from the system buffer zone at the next power-up.
In 2-wire mode, the host is required to perform ACK polling for up to 8 ms after write commands when anti-tearing is
active. At power-up, the host is required to perform ACK polling, in some cases for up to 2 ms, in the event that the
device needs to carry out the data recovery process.
Write Lock
If a user zone is configured in the write lock mode, the lowest address byte of an 8-byte page constitutes a write access
byte for the bytes of that page.
Example
The write lock byte at $080 controls the bytes from $080 to $087.
Figure 12.
Write Lock Example
Address
$080
$0
11011001
$1
xxxx xxxx
$2
xxxx xxxx
$3
xxxx xxxx
$4
xxxx xxxx
$5
xxxx xxxx
$6
xxxx xxxx
$7
xxxx xxxx
locked
locked
locked
The write lock byte may also be locked by writing its least significant (rightmost) bit to “0”. Moreover, when write lock
mode is activated, the write lock byte can only be programmed – that is, bits written to “0” cannot return to “1”.
In the write lock configuration, only one byte can be written at a time. Even if several bytes are received, only the first
byte will be taken into account by the device.
13
5014KS–SMEM–08/09
相关PDF资料 |
PDF描述 |
|---|---|
| XC6VCX195T-1FFG1156C | IC FPGA VIRTEX 6 199K 1156FFGBGA |
| AT88SC12816C-MJTG | CRYPTOMEM 128KBIT 16ZONE MODJ TW |
| XC5VLX50T-3FFG1136C | IC FPGA VIRTEX-5 50K 1136FBGA |
| AT88SC25616C-PU | IC EEPROM 256BIT 1.5MHZ 8DIP |
| AT24C256C-XHL-T | IC EEPROM 256KBIT IND 8TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT88SC3216C-WI | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:CryptoMemory 32 Kbit |
| AT88SC3216C-Y4I | 制造商:Atmel Corporation 功能描述:CRYPTOMEMORY 8PIN SAP - Rail/Tube |
| AT88SC410 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:ASIC |
| AT88SC450 | 制造商:未知厂家 制造商全称:未知厂家 功能描述:ASIC |
| AT88SC54C | 制造商:未知厂家 制造商全称:未知厂家 功能描述:Microcontroller |
发布紧急采购，3分钟左右您将得到回复。