参数资料
型号: AT89C51RC-24AU
厂商: Atmel
文件页数: 9/36页
文件大小: 0K
描述: MCU 8051 32K FLASH 5.5V 44-VQFP
产品培训模块: MCU Product Line Introduction
标准包装: 160
系列: 89C
核心处理器: 8051
芯体尺寸: 8-位
速度: 24MHz
连通性: SPI,UART/USART
外围设备: WDT
输入/输出数: 32
程序存储器容量: 32KB(32K x 8)
程序存储器类型: 闪存
RAM 容量: 512 x 8
电压 - 电源 (Vcc/Vdd): 4 V ~ 5.5 V
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 44-TQFP
包装: 托盘
配用: AT89STK-11-ND - KIT STARTER FOR AT89C51RX2
17
1920D–MICRO–6/08
AT89C51RC
rupt. Note too, that if EXEN2 is set, a 1-to-0 transition in T2EX will set EXF2 but will not cause a
reload from (RCAP2H, RCAP2L) to (TH2, TL2). Thus when Timer 2 is in use as a baud rate gen-
erator, T2EX can be used as an extra external interrupt.
Note that when Timer 2 is running (TR2 = 1) as a timer in the baud rate generator mode, TH2 or
TL2 should not be read from or written to. Under these conditions, the Timer is incremented
every state time, and the results of a read or write may not be accurate. The RCAP2 registers
may be read but should not be written to, because a write might overlap a reload and cause
write and/or reload errors. The timer should be turned off (clear TR2) before accessing the Timer
2 or RCAP2 registers.
15. Programmable Clock Out
A 50% duty cycle clock can be programmed to come out on P1.0, as shown in Figure 15-1. This
pin, besides being a regular I/O pin, has two alternate functions. It can be programmed to input
the external clock for Timer/Counter 2 or to output a 50% duty cycle clock ranging from 61 Hz to
4 MHz at a 16 MHz operating frequency.
To configure the Timer/Counter 2 as a clock generator, bit C/T2 (T2CON.1) must be cleared and
bit T2OE (T2MOD.1) must be set. Bit TR2 (T2CON.2) starts and stops the timer.
The clock-out frequency depends on the oscillator frequency and the reload value of Timer 2
capture registers (RCAP2H, RCAP2L), as shown in the following equation.
In the clock-out mode, Timer 2 roll-overs will not generate an interrupt. This behavior is similar to
when Timer 2 is used as a baud-rate generator. It is possible to use Timer 2 as a baud-rate gen-
erator and a clock generator simultaneously. Note, however, that the baud-rate and clock-out
frequencies cannot be determined independently from one another since they both use
RCAP2H and RCAP2L.
Figure 15-1. Timer 2 in Clock-Out Mode
Clock-Out Frequency
Oscillator Frequency
4 x [65536-(RCAP2H,RCAP2L)]
-------------------------------------------------------------------------------------
=
OSC
EXF2
P1.0
(T2)
P1.1
(T2EX)
TR2
EXEN2
C/T2 BIT
TRANSITION
DETECTOR
TIMER 2
INTERRUPT
T2OE (T2MOD.1)
÷2
TL2
(8-BITS)
RCAP2L RCAP2H
TH2
(8-BITS)
÷2
相关PDF资料
PDF描述
ATTINY28V-1AU IC MCU AVR 2K 1.2MHZ 1.8V 32TQFP
MB95F376EPMC2-G-SNE2 IC MCU 8BIT 36KB FLASH 64LQFP
VE-BT4-IW-F4 CONVERTER MOD DC/DC 48V 100W
D38999/24JD15HN CONN RCPT 15POS JAM NUT W/PINS
VE-BT3-IX-F2 CONVERTER MOD DC/DC 24V 75W
相关代理商/技术参数
参数描述
AT89C51RC-24JC 功能描述:8位微控制器 -MCU 32K FLASH 4.0 TO 5.5V - 24MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT89C51RC-24JI 功能描述:8位微控制器 -MCU 32K FLASH 4.0 TO 5.5V - 24MHZ RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT89C51RC-24JJ 功能描述:8位微控制器 -MCU Microcontroller RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT89C51RC-24JU 功能描述:8位微控制器 -MCU 32K FLASH 4.0 TO 5.5V - 24MHZ 5V RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
AT89C51RC-24JU SL383 制造商:Atmel Corporation 功能描述: