参数资料
| 型号： | AT91SAM9261-CJ |
| 厂商： | Atmel |
| 文件页数： | 13/44页 |
| 文件大小： | 0K |
| 描述： | IC ARM9 MPU 217BGA |
| 标准包装： | 126 |
| 系列： | AT91SAM |
| 核心处理器： | ARM9 |
| 芯体尺寸： | 16/32-位 |
| 速度： | 190MHz |
| 连通性： | EBI/EMI，I²C，MMC，SPI，SSC，UART/USART，USB |
| 外围设备： | DMA，LCD，POR，PWM，WDT |
| 输入/输出数： | 96 |
| 程序存储器容量： | 32KB（32K x 8） |
| 程序存储器类型： | ROM |
| RAM 容量： | 192K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 1.08 V ~ 1.32 V |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 217-LFBGA |
| 包装： | 托盘 |
| 配用： | AT91SAM9261-EK-ND - KIT EVAL FOR AT91SAM926EJ-S AT91SAM-ICE-ND - EMULATOR FOR AT91 ARM7/ARM9 |
| 其它名称： | AT91SAM9261B-CJ AT91SAM9261B-CJ-ND |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页当前第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页
20
6062LS–ATARM–23-Mar-09
AT91SAM9261
8.1.2
Boot Strategies
The system always boots at address 0x0. To ensure a maximum number of possibilities for boot,
the memory layout can be configured with two parameters.
REMAP allows the user to lay out the first internal SRAM bank to 0x0 to ease development. This
is done by software once the system has booted for each Master of the Bus Matrix. Refer to the
Bus Matrix Section for more details.
When REMAP = 0, BMS allows the user to lay out to 0x0, at his convenience, the ROM or an
external memory. This is done via hardware at reset.
Note:
Memory blocks not affected by these parameters can always be seen at their specified base
addresses. See the complete memory map presented in Figure 8-1 on page 16.
The AT91SAM9261 Bus Matrix manages a boot memory that depends on the level on the BMS
pin at reset. The internal memory area mapped between address 0x0 and 0x000F FFFF is
reserved for this purpose.
If BMS is detected at 1, the boot memory is the embedded ROM.
If BMS is detected at 0, the boot memory is the memory connected on the Chip Select 0 of the
External Bus Interface.
8.1.2.1
BMS = 1, Boot on Embedded ROM
The system boots using the Boot Program.
Downloads and runs an application from external storage media into internal SRAM
Downloaded code size depends on embedded SRAM size
Automatic detection of valid application
Bootloader on a non-volatile memory
–SDCard
–NAND Flash
– SPI DataFlash connected on NPCS0 of the SPI
SAM-BA boot in case no valid program is detected in external NVM, supporting:
– Serial communication on a DBGU
– USB Device HS Port
8.1.2.2
BMS = 0, Boot on External Memory
Boot on slow clock (32,768 Hz)
Boot with the default configuration for the Static Memory Controller, byte select mode, 16-bit
data bus, Read/Write controlled by Chip Select, allows boot on 16-bit non-volatile memory.
The customer-programmed software must perform a complete configuration.
To speed up the boot sequence when booting at 32 kHz EBI CS0 (BMS=0), the user must take
the following steps:
1.
Program the PMC (main oscillator enable or bypass mode).
2.
Program and start the PLL.
3.
Reprogram the SMC setup, cycle, hold, mode timings registers for CS0 to adapt them
to the new clock
4.
Switch the main clock to the new value.
相关PDF资料 |
PDF描述 |
|---|---|
| AT91SAM9261SB-CU-999 | IC MCU ARM9 ULTRA LP 217LFBGA |
| AT91SAM9261SB-CU | IC ARM9 MPU 217-LFBGA |
| AT91SAM9G10-CU | IC MCU ARM9 SAMPLING 217CBGA |
| AT91SAM9G20B-CFU | IC MCU ARM9 247-LFBGA |
| AT91SAM9N12-CU | IC MCU ARM9 217-LFBGA |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AT91SAM9261-CJ-999 | 功能描述:ARM微控制器 - MCU BGA Ind. Temp RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
| AT91SAM9261-EK | 功能描述:开发板和工具包 - ARM Supports AT91SAM9261 ARM926EJS dev & eval RoHS:否 制造商:Arduino 产品:Development Boards 工具用于评估:ATSAM3X8EA-AU 核心:ARM Cortex M3 接口类型:DAC, ICSP, JTAG, UART, USB 工作电源电压:3.3 V |
| AT91SAM9261S | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:AT91 ARM Thumb-based Microcontrollers |
| AT91SAM9261S_09 | 制造商:ATMEL 制造商全称:ATMEL Corporation 功能描述:AT91 ARM Thumb-based Microcontrollers |
| AT91SAM9261SB-CU | 功能描述:ARM微控制器 - MCU 32-bit RoHS:否 制造商:STMicroelectronics 核心:ARM Cortex M4F 处理器系列:STM32F373xx 数据总线宽度:32 bit 最大时钟频率:72 MHz 程序存储器大小:256 KB 数据 RAM 大小:32 KB 片上 ADC:Yes 工作电源电压:1.65 V to 3.6 V, 2 V to 3.6 V, 2.2 V to 3.6 V 工作温度范围:- 40 C to + 85 C 封装 / 箱体:LQFP-48 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。