参数资料
型号: ATMEGA164A-CU
厂商: Atmel
文件页数: 102/160页
文件大小: 0K
描述: IC MCU AVR 16K 20MHZ 49VFBGA
产品培训模块: MCU Product Line Introduction
megaAVR Introduction
标准包装: 490
系列: AVR® ATmega
核心处理器: AVR
芯体尺寸: 8-位
速度: 20MHz
连通性: I²C,SPI,UART/USART
外围设备: 欠压检测/复位,POR,PWM,WDT
输入/输出数: 32
程序存储器容量: 16KB(8K x 16)
程序存储器类型: 闪存
EEPROM 大小: 512 x 8
RAM 容量: 1K x 8
电压 - 电源 (Vcc/Vdd): 1.8 V ~ 5.5 V
数据转换器: A/D 8x10b
振荡器型: 内部
工作温度: -40°C ~ 85°C
封装/外壳: 49-VFBGA
包装: 托盘
46
8272E–AVR–04/2013
ATmega164A/PA/324A/PA/644A/PA/1284/P
10.11.5
Watchdog Timer
If the Watchdog Timer is not needed in the application, the module should be turned off. If the
Watchdog Timer is enabled, it will be enabled in all sleep modes, and hence, always consume
power. In the deeper sleep modes, this will contribute significantly to the total current consump-
tion. Refer to ”Watchdog Timer” on page 55 for details on how to configure the Watchdog Timer.
10.11.6
Port Pins
When entering a sleep mode, all port pins should be configured to use minimum power. The
most important is then to ensure that no pins drive resistive loads. In sleep modes where both
the I/O clock (clk
I/O) and the ADC clock (clkADC) are stopped, the input buffers of the device will
be disabled. This ensures that no power is consumed by the input logic when not needed. In
some cases, the input logic is needed for detecting wake-up conditions, and it will then be
enabled. Refer to the section ”Digital Input Enable and Sleep Modes” on page 76 for details on
which pins are enabled. If the input buffer is enabled and the input signal is left floating or have
an analog signal level close to V
CC/2, the input buffer will use excessive power.
For analog input pins, the digital input buffer should be disabled at all times. An analog signal
level close to V
CC/2 on an input pin can cause significant current even in active mode. Digital
input buffers can be disabled by writing to the Digital Input Disable Registers (DIDR1 and
10.11.7
On-chip Debug System
If the On-chip debug system is enabled by the OCDEN Fuse and the chip enters sleep mode,
the main clock source is enabled, and hence, always consumes power. In the deeper sleep
modes, this will contribute significantly to the total current consumption.
There are three alternative ways to disable the OCD system:
Disable the OCDEN Fuse
Disable the JTAGEN Fuse
Write one to the JTD bit in MCUCR
相关PDF资料
PDF描述
VE-J0T-IY-F2 CONVERTER MOD DC/DC 6.5V 50W
VE-JW2-IX-B1 CONVERTER MOD DC/DC 15V 75W
VE-JW1-IX-B1 CONVERTER MOD DC/DC 12V 75W
VJ1825A102KBCAT4X CAP CER 1000PF 200V 10% NP0 1825
VE-J1W-IX-B1 CONVERTER MOD DC/DC 5.5V 75W
相关代理商/技术参数
参数描述
ATMEGA164A-CUR 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20 MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA164A-MCH 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20 MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA164A-MCHR 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20 MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA164A-MU 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20 MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT
ATMEGA164A-MUR 功能描述:8位微控制器 -MCU AVR 16KB FL 512B EE 1KB SRAM-20 MHz RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT