- 您现在的位置：买卖IC网 > Datasheet目录396 > AWAC24U (Artaflex Inc)2.4GHZ WIRELESS USB DONGLE Datasheet资料下载
参数资料
| 型号： | AWAC24U |
| 厂商： | Artaflex Inc |
| 文件页数： | 3/11页 |
| 文件大小： | 0K |
| 描述： | 2.4GHZ WIRELESS USB DONGLE |
| 标准包装： | 100 |
| 频率： | 2.4GHz |
| 数据传输率 - 最大： | 1Mbps |
| 调制或协议： | DSSS，GFSK |
| 应用： | 通用 |
| 功率 - 输出： | 21dBm |
| 灵敏度： | -93dBm |
| 电源电压： | 5V |
| 电流 - 接收： | 48mA |
| 电流 - 传输： | 240mA |
| 数据接口： | 连接器，USB |
| 天线连接器： | 板载，跟踪 |
| 工作温度： | 0°C ~ 70°C |
| 包装： | 托盘 |
| 其它名称： | 748-1009 |
2.4GHz DSSS Wireless USB Dongle
AWAC24U
Data Sheet
4
Functional Overview
The AWAC24U Module provides a complete USB to RF antenna wireless MODEM. The module is designed to implement wireless
device links operating in the worldwide 2.4-GHz ISM frequency band. It is intended for systems compliant with world-wide
regulations covered by ETSI EN 301 489-1 V1.41, ETSI EN 300 328-1 V1.3.1 (Europe), FCC CFR 47 Part 15 (USA and Industry
Canada) and TELEC ARIB(Japan).
The module contains a 2.4-GHz 1-Mbps GFSK radio transceiver, packet data buffering, packet framer, DSSS baseband controller,
Received Signal Strength Indication (RSSI), and SPI interface for data transfer and device configuration.
The radio supports 98 discrete 1-MHz channels (regulations limit the use of some of these channels in certain jurisdictions, contact
Artaflex for more details). In DSSS modes the baseband performs DSSS spreading/de-spreading, while in GFSK Mode (1 Mb/s -
GFSK) the baseband performs Start of Frame (SOF), End of Frame (EOF) detection and CRC16 generation and checking. The
baseband may also be configured to automatically transmit Acknowledge (ACK) handshake packets whenever a valid packet is
received.
When in receive mode, with packet framing enabled, the device is always ready to receive data transmitted at any of the supported
bit rates, except SDR, enabling the implementation of mixed-rate systems in which different devices use different data rates. This
also enables the implementation of dynamic data rate systems, which use high data rates at shorter distances and/or in a low-
moderate interference environment, and change to lower data rates at longer distances and/or in high interference environments.
4.1
Link Layer Modes
The AWAC24U module supports the following data packet framing features:
SOP – Packets begin with a 2-symbol Start of Packet (SOP) marker. This is required in GFSK and 8DR modes, but is optional in
DDR mode and is not supported in SDR mode; if framing is disabled then an SOP event is inferred whenever two successive
correlations are detected. The SOP_CODE_ADR code used for the SOP is different from that used for the “body” of the packet and
if desired may be a different length. SOP must be configured to be the same length on both sides of the link.
EOP – There are two options for detecting the end of a packet. If SOP is enabled, then a packet length field may be enabled.
GFSK and 8DR must enable the length field. This is the first 8-bits after the SOP symbol, and is transmitted at the payload data
rate. If the length field is enabled, an End of Packet (EOP) condition is inferred after reception of the number of bytes defined in the
length field, plus two bytes for the CRC16 (if enabled—see below). The alternative to using the length field is to infer an EOP
condition from a configurable number of successive non-correlations; this option is not available in GFSK mode and is only
recommended to enable when using SDR mode.
CRC16 – The device may be configured to append a 16-bit CRC16 to each packet. The CRC16 uses the USB CRC polynomial
with the added programmability of the seed. If enabled, the receiver will verify the calculated CRC16 for the payload data against
the received value in the CRC16 field. The starting value for the CRC16 calculation is configurable, and the CRC16 transmitted
may be calculated using either the loaded seed value or a zero seed; the received data CRC16 will be checked against both the
configured and zero CRC16 seeds.
CRC16 detects the following errors:
?
?
?
?
4.2
Any one bit in error
Any two bits in error (no matter how far apart, which column, and so on)
Any odd number of bits in error (no matter where they are)
An error burst as wide as the checksum itself
Packet Buffers
All data transmission and reception utilizes the 16-byte packet buffers—one for transmission and one for reception.
The transmit buffer allows a complete packet of up to 16-bytes of payload data to be loaded in one burst SPI transaction, and then
transmitted with no further micro controller intervention. Similarly, the receive buffer allows an entire packet of payload data up to
16 bytes to be received with no firmware intervention required until packet reception is complete.
The AWAC24U module supports packet length of up to 40 bytes; interrupts are provided to allow a micro controller to use the
transmit and receive buffers as FIFOs. When transmitting a packet longer than 16 bytes, the micro controller can load 16-bytes
initially, and add further bytes to the transmit buffer as transmission of data creates space in the buffer. Similarly, when receiving
packets longer than 16 bytes, the micro controller must fetch received data from the FIFO periodically during packet reception to
prevent it from overflowing.
Artaflex Inc.
215 Konrad Crescent
Markham, Ontario, Canada
DSAWAC24U Rev 1v2
October 25, 2010
L3R8T9
(905) 479-0148
Page 3 of 11
http://www.artaflexmodules.com
相关PDF资料 |
PDF描述 |
|---|---|
| AWS24S | MODULE WIRELESS USB EXT ANT |
| B1A-10PK | LAMP INDICATOR T-3 1/4 120V 10PK |
| B2A | LAMP NEON T3-1/4 MINI BAYONT |
| B57261V2223J60 | THERMISTOR NTC 22K OHM 5% SMD |
| B57550G0104F000 | THERMISTOR NTC 100K OHM 1% RAD |
相关代理商/技术参数 |
参数描述 |
|---|---|
| AWA-DBR | 功能描述:音频指示器及警报器 RED BASE FOR XL-501 RoHS:否 制造商:PUI Audio 产品:Indicators 声压级:85 dB 音调:Continuous 频率:2300 Hz +/- 300 Hz 电压额定值:5 VDC 电流额定值:30 mA 端接类型: 直径:12 mm 安装:Through Hole |
| AWA-DBR-120 | 功能描述:音频指示器及警报器 120VAC DEEP BASE RoHS:否 制造商:PUI Audio 产品:Indicators 声压级:85 dB 音调:Continuous 频率:2300 Hz +/- 300 Hz 电压额定值:5 VDC 电流额定值:30 mA 端接类型: 直径:12 mm 安装:Through Hole |
| AWA-DBW | 功能描述:音频指示器及警报器 WHT BASE FOR XL-501 RoHS:否 制造商:PUI Audio 产品:Indicators 声压级:85 dB 音调:Continuous 频率:2300 Hz +/- 300 Hz 电压额定值:5 VDC 电流额定值:30 mA 端接类型: 直径:12 mm 安装:Through Hole |
| AWA-DBW-120 | 功能描述:POWERED DEEP BASE WHITE RoHS:是 类别:音频产品 >> 配件 系列:AW 标准包装:1 系列:- 附件类型:垫圈 材质:氯丁橡胶 颜色:黑 适用于相关产品:Sonalert? 信号设备 其它名称:458-1048 |
| AWAP00021 | 功能描述:SWITCH OPTICAL SC 1X2 1310NM RoHS:是 类别:光电元件 >> 光纤 - 开关，多路复用器，多路分解器 系列:* 标准包装:1 系列:P1S 连接器类型:* 类型:* 其它名称:P1S18BLD6S |
发布紧急采购，3分钟左右您将得到回复。