- 您现在的位置：买卖IC网 > PDF目录373007 > BASTSERIES 5V, 3.3V, ISR™ High-Performance CPLDs PDF资料下载
参数资料
| 型号： | BASTSERIES |
| 英文描述： | 5V, 3.3V, ISR™ High-Performance CPLDs |
| 中文描述： | 稳压器大规模集成电路 |
| 文件页数： | 8/11页 |
| 文件大小： | 127K |
| 代理商： | BASTSERIES |
BA
ΟΟ
ST / BA
ΟΟ
SFP series
Regulator ICs
!
Operation notes
(1) Operating power supply voltage
When operating within the normal voltage range and within the ambient operating temperature range, most circuit
functions are guaranteed. The rated values cannot be guaranteed for the electrical characteristics, but there are no
sudden changes of the characteristics within these ranges.
(2) Power dissipation
Heat attenuation characteristics are noted on a separate page and can be used as a guide in judging power dissipation.
If these ICs are used in such a way that the allowable power dissipation level is exceeded, an increase in the chip
temperature could cause a reduction in the current capability or could otherwise adversely affect the performance of the
IC. Make sure a sufficient margin is allowed so that the allowable power dissipation value is not exceeded.
(3) Output oscillation prevention and bypass capacitor
Be sure to connect a capacitor between the output pin and GND to prevent oscillation. Since fluctuations in the valve of
the capacitor due to temperature changes may cause oscillations, a tantalum electrolytic capacitor with a small internal
series resistance (ESR) is recommended.
A 22
μ
F capacitor is recommended; however, be aware that if an extremely large capacitance is used (1000
μ
F or greater),
then oscillations may occur at low frequencies. Therefore, be sure to perform the appropriate verifications before selecting
the capacitor.
Also, we recommend connecting a 0.33
μ
F bypass capacitor as close as possible between the input pin and GND.
(4) Current overload protection circuit
A current overload protection circuit is built into the outputs, to prevent IC destruction if the load is shorted.
This protection circuit limits the current in the shape of a fall back characteristics. It is designed with a high margin, so that
even if a large current suddenly flows through the large capacitor in the IC, the current is restricted and latching is
prevented.
However, these protection circuits are only good for pre-venting damage from sudden accidents. The design should take
this into consideration, so that the protection circuit is not made to operate continuously (for instance, clamping at an
output of 1V
F
or greater; below 1V
F
, the short mode circuit operates). Note that the capacitor has negative temperature
characteristics, and the design should take this into consideration.
(5) Thermal overload circuit
A built-in thermal overload circuit prevents damage from overheating. When the thermal circuit is activated, the various
outputs are in the OFF state. When the temperature drops back to a constant level, the circuit is restored.
(6) Internal circuits could be damaged if there are modes in which the electric potential of the application’s input (V
CC
) and
GND are the opposite of the electric potential of the various outputs. Use of a diode or other such bypass path is
recommended.
(7) Although the manufacture of this product includes rigorous quality assurance procedures, the product may be
damaged if absolute maximum ratings for voltage or operating temperature are exceeded. If damage has occurred,
special modes (such as short circuit mode or open circuit mode) cannot be specified. If it is possible that such special
modes may be needed, please consider using a fuse or some other mechanical safety measure.
(8) When used within a strong magnetic field, be aware that there is a slight possibility of malfunction.
8/11
相关PDF资料 |
PDF描述 |
|---|---|
| BAT.CHARGER | CY7C68013A, CY7C68014A, CY7C68015A, CY7C68016A: EZ-USB FX2LP™ USB Microcontroller High-Speed USB Peripheral Controller |
| BAT160SERIES | CY8C24123A CY8C24223A, CY8C24423A PSoC® Mixed-Signal Array |
| BAT165Q62702A1190 | CY8C24123A CY8C24223A, CY8C24423A PSoC® Mixed-Signal Array |
| BAT18-04S | CY8C24123A CY8C24223A, CY8C24423A PSoC® Mixed-Signal Array |
| BAT46ACJW | SMALL SIGNAL SCHOTTKY DIODE |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BASU-MAD | 制造商:Crouzet 功能描述: |
| BASY20 | 制造商:Thomas & Betts 功能描述:Y CONN FOR BTRY CA 制造商:Thomas & Betts 功能描述:Battery Terminal (2/0)AWG Electro-Tin |
| BASY30 | 制造商:Thomas & Betts 功能描述:Y CONN FOR BTRY CA |
| BASY40 | 制造商:Thomas & Betts 功能描述:Battery Terminal (4/0)-2AWG Electro-Tin |
| BAT 15-02LRH E6327 | 功能描述:肖特基二极管与整流器 Silicon Schottky Diodes 4V 110mA RoHS:否 制造商:Skyworks Solutions, Inc. 产品:Schottky Diodes 峰值反向电压:2 V 正向连续电流:50 mA 最大浪涌电流: 配置:Crossover Quad 恢复时间: 正向电压下降:370 mV 最大反向漏泄电流: 最大功率耗散:75 mW 工作温度范围:- 65 C to + 150 C 安装风格:SMD/SMT 封装 / 箱体:SOT-143 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。