参数资料
| 型号： | BD8629FS-E2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 9/14页 |
| 文件大小： | 0K |
| 描述： | IC PWR SUPP 2A W/FET SSOP-A16 |
| 标准包装： | 2,500 |
| 应用： | 控制器，平面电视 |
| 输入电压： | 4.5 V ~ 6 V |
| 输出数： | 1 |
| 工作温度： | -10°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 16-LSOP（0.175"，4.40mm 宽） |
| 供应商设备封装： | 16-SSOPA |
| 包装： | 带卷 (TR) |
BD8629FS
Technical Note
● Protection function
Protection circuit is effective for destruction prevention due to accident so that avoid using under continuous protection
operation.
Low voltage protection function (LVP)
The voltage of the terminal FB (2 pins) is compared with internal reference voltage VREF.
If FB terminal voltage falls below V LVP (= VREF -60mV) and the state continues for 500us, output changes to low voltage and
the state is fixed. In that case , PDET (3pin) output changes to L.
Table 1 output low voltage protection function
EN terminal
>V IHEN
SS terminal
>1.4V(typ)
FB terminal
<V LVP
>V LVP
Low voltage protection
function
Effective
Low voltage protection
operation
ON
OFF
<1.4V(typ) - Invalidity OFF
<V ILEN
- - Invalidity OFF
＊ Low voltage protection function is available when SS terminal voltage becomes more than
1.4V (typ) in the transition to ON control (during soft start).
Over voltage protection function(OVP)
The voltage of the terminal FB is compared with internal reference voltage VREF.
If FB terminal voltage is over Vovp (=VREF +60mV) and the state is continues for 500usec, output changes to low voltage
and the state is fixed.
Table 2 output overvoltage protection function
EN terminal
>V IHEN
SS terminal
>1.4V(typ)
FB terminal
>V OVP
<V OVP
Over voltage
protection function
Effective
Over voltage
protection operation
ON
OFF
<1.4V(typ) - Invalidity OFF
<V ILEN
- - Invalidity OFF
＊ Over voltage protection function is available when SS terminal voltage becomes more than
1.4V (typ) in the transition to ON control (during soft start).
V FB
FB terminal
voltage
0
VREF ＋ 60 ｍ V
VREF
VREF-60 ｍ V
Protection
PDET terminal
ON
OFF
HIGH
500[us]
OVP
500[us]
LVP
LOW
Fig. 5 Output voltage error detection range
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
9/11
2009.05 - Rev.A
相关PDF资料 |
PDF描述 |
|---|---|
| BD8643FV-E2 | IC REG BUCK SYNC ADJ 3A 20SSOP |
| BD8649EFV-E2 | IC REG BUCK SYNC ADJ HTSSOPB20 |
| BD8963EFJ-E2 | IC REG BUCK SYNC ADJ 3A 8HTSOP |
| BD8964FVM-TR | IC REG BUCK SYNC ADJ 1.2A MSOP8 |
| BD8966FVM-TR | IC REG BUCK SYNC ADJ 0.8A MSOP8 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD863 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:NPN SILICON DARLINGTON TRANSISTORS |
| BD864 | 制造商:INFINEON 制造商全称:Infineon Technologies AG 功能描述:PNP SILICON DARLINGTON TRANSISTORS |
| BD8641EFV | 制造商:ROHM 制造商全称:Rohm 功能描述:Synchronous rectification with built-in FET type DC/DC converter IC |
| BD8641EFV-E2 | 制造商:ROHM Semiconductor 功能描述:CONV DC-DC SINGLE STEP DOWN 3V TO 5V 20-PIN HTSSOP T/R - Tape and Reel 制造商:ROHM Semiconductor 功能描述:IC REG BUCK SYNC ADJ 3A 20HTSSOP 制造商:ROHM Semiconductor 功能描述:IC POWER SUPPLY HTSSOP-B20 制造商:ROHM Semiconductor 功能描述:IC, POWER SUPPLY HTSSOP-B20 制造商:ROHM Semiconductor 功能描述:CONV DCDC STPDWN SNGL 3V-5V 20PIN |
| BD8643FV | 制造商:ROHM 制造商全称:Rohm 功能描述:Synchronous rectification with built-in FET type DC/DC converter IC |
发布紧急采购，3分钟左右您将得到回复。