- 您现在的位置：买卖IC网 > Datasheet目录39 > BD9153MUV-E2 (Rohm Semiconductor)IC REG TRPL BCK/LINEAR 24VQFN Datasheet资料下载
参数资料
| 型号： | BD9153MUV-E2 |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 12/21页 |
| 文件大小： | 630K |
| 描述： | IC REG TRPL BCK/LINEAR 24VQFN |
| 特色产品： | CMOS LDO Regulators |
| 标准包装： | 1 |
| 拓扑： | 降压（降压）同步（2），线性（LDO）（1） |
| 功能： | 任何功能 |
| 输出数： | 3 |
| 频率 - 开关： | 1MHz |
| 电压/电流 - 输出 1： | 1.8 V ~ 3.3 V，1.5A |
| 电压/电流 - 输出 2： | 0.8 V ~ 2.5 V，1.5A |
| 电压/电流 - 输出 3： | 控制器 |
| 带 LED 驱动器： | 无 |
| 带监控器： | 无 |
| 带序列发生器： | 无 |
| 电源电压： | 4.5 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 24-VFQFN 裸露焊盘 |
| 供应商设备封装： | 24-VQFN |
| 包装： | 标准包装 |
| 其它名称： | BD9153MUV-E2DKR |
Technical Note
12/18
www.rohm.com
2009.08 - Rev.A
?2009 ROHM Co., Ltd. All rights reserved.
BD9153MUV
?SPAN class="pst BD9153MUV-E2_2471427_7">Selection of components externally connected
1. Selection of inductor (L)
;Current exceeding the current rating of the inductor results in magnetic saturation of the inductor, which decreases efficiency.
The inductor must be selected allowing sufficient margin with which the peak current may not exceed its current rating.
If VCC=5.0V, VOUT=1.2V, f=1.0MHz, 擨L=0.3?.5A=0.45A, for example,(BD9153MUV)
;Select the inductor of low resistance component (such as DCR and ACR) to minimize dissipation in the inductor for
better efficiency.
2. Selection of output capacitor (CO)
The inductance significantly depends on output ripple current.
s seen in the equation (1), the ripple current decreases as the
inductor and/or switching frequency increases.
擨L=
(VCC-VOUT)譜OUT
L譜CC譮
A?
ppropriate ripple current at output should be 20% more or less of
the maximum output current.
擨L=0.2譏OUTmax. [A]?2)
L=
(VCC-VOUT)譜OUT
擨L譜CC譮
H?
(擨L: Output ripple current, and f: Switching frequency)
Output capacitor should be selected with the consideration on the stability region
and the equivalent series resistance required to smooth ripple voltage.
Output ripple voltage is determined by the equation (4)
擵OUT=擨L譋SR [V]?4)
(擨L: Output ripple current, ESR: Equivalent series resistance of output capacitor)
;Rating of the capacitor should be determined allowing sufficient margin against
output voltage. A 22礔 to 100糉 ceramic capacitor is recommended.
Less ESR allows reduction in output ripple voltage.
Fig.36 Output capacitor
5-1.2?.2
0.45??.0M
L=
=2.02??2.2[糎]
擨L
V
OUT
Fig.35 Output ripple current
IL
VCC
IL
L
Co
VCC
L
Co
VOUT
ESR
相关PDF资料 |
PDF描述 |
|---|---|
| CAT2300VP2-GT3 | IC SENSE FET CONTROLLER 8TDFN |
| CAT34TS02VP2GT4A | IC TEMP SENSOR 2K MEMORY 8TDFN |
| CAT6095VP2-GT4 | IC TEMP SENSOR STAND ALONE 8TDFN |
| DS1621S+ | IC THERMOMETER/STAT DIG 8-SOIC |
| DS1624S+T&R | IC THERM/EEPROM DIG 256BYT 8SOIC |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD9160FVM | 制造商:ROHM 制造商全称:Rohm 功能描述:1ch DC／DC Converter Controller IC with Built-in Synchronous Rectifier |
| BD9160FVM-TR | 制造商:ROHM Semiconductor 功能描述:Cut Tape |
| BD9161FVM | 制造商:ROHM 制造商全称:Rohm 功能描述:Output 1.5A or Less High-efficiency Step-down Switching Regulator with Built-in Power MOSFET |
| BD9161FVM_12 | 制造商:ROHM 制造商全称:Rohm 功能描述:2.5V to 4.5V, 0.6A 1ch Synchronous Buck Converter Integrated FET |
| BD9161FVM-LBTR | 功能描述:Buck Switching Regulator IC Positive Adjustable 1V 1 Output 600mA 8-VSSOP, 8-MSOP (0.110", 2.80mm Width) 制造商:rohm semiconductor 系列:- 包装:剪切带（CT） 零件状态:有效 功能:降压 输出配置:正 拓扑:降压 输出类型:可调式 输出数:1 电压 - 输入（最小值）:2.5V 电压 - 输入（最大值）:4.5V 电压 - 输出（最小值/固定）:1V 电压 - 输出（最大值）:3.3V 电流 - 输出:600mA 频率 - 开关:1MHz 同步整流器:是 工作温度:-25°C ~ 85°C（TA） 安装类型:表面贴装 封装/外壳:8-VSSOP，8-MSOP（0.110"，2.80mm 宽） 供应商器件封装:8-MSOP 标准包装:1 |
发布紧急采购，3分钟左右您将得到回复。