参数资料
| 型号： | BD9305AFVM-TR |
| 厂商： | Rohm Semiconductor |
| 文件页数： | 9/15页 |
| 文件大小： | 0K |
| 描述： | IC REG CTRLR BUCK PWM 8-MSOP |
| 标准包装： | 1 |
| PWM 型： | 控制器 |
| 输出数： | 1 |
| 频率 - 最大： | 800kHz |
| 占空比： | 100% |
| 电源电压： | 4.2 V ~ 18 V |
| 降压： | 是 |
| 升压： | 无 |
| 回扫： | 无 |
| 反相： | 无 |
| 倍增器： | 无 |
| 除法器： | 无 |
| Cuk： | 无 |
| 隔离： | 无 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-VSSOP，8-MSOP（0.110"，2.80mm 宽） |
| 包装： | 标准包装 |
| 其它名称： | BD9305AFVM-DKR BD9305AFVM-DKR-ND BD9305AFVMDKR |
BD9306AFVM, BD9305AFVM
Technical Note
(5) Setting of oscillation frequency
The angular wave oscillation frequency can be set by respectively connecting resistor and condenser to RT (1 pin) and CT
(2 pins). The currents to charge and discharge the condenser of CT are determined by RT.
Please refer to the following drawing for setting the RT’s resistor and the CT’s condenser.
RT:5~50k Ω , CT:100~1000pF, and the frequency range of 100kHz~800kHz are recommended.
Please pay attention to that, the switching will stop if your setting is off this range.
10000
Ta=25 ℃
1000
100
10
1
CT=100pF
CT=200pF
CT=470pF
CT=1000pF
10
VCC=12V
100
RT [k ? ]
Fig.27 Frequency Setting
(6)Selection of input condenser
For DC/DC converter, the condenser at the input side is also necessary because peak current is flowing between input
and output. Therefore, we recommend the low ESR condenser with over 10 μ F and below 100m ? as the input condenser.
If a selected condenser is off this range, excessively large ripple voltage will overlaps with the input voltage, which may
cause IC malfunction.However, this condition varies with negative overcurrent, input voltage, output voltage, inductor ’s
value, and switching frequency, so please be sure to do the margin check with actual devices.
(7)Selection of output rectifier diode
We recommend the Schottky barrier diode as the diode for rectification at the output stage of DC/DC converter. Please be
careful to choose the maximum inductor current, the maximum output voltage and the power supply voltage.
＜ step-down DC/DC ＞
Maximum inductor current I OMAX ＋ ⊿ I L
2
＜
Diode’s rated current
Power supply voltage
＜ step-up DC/DC ＞
Maximum inductor current
VCC
I INMAX ＋ ⊿ I L
2
＜
＜
Diode’s rated voltage
Diode’s rated current
Maximum output voltage V OMAX
＜
Diode’s rated voltage
Furthermore, each parameter has a deviation of 30%~40%, so please design in such a way that you have left a
sufficient margin for deviation in your design.
(8)Setting of Power FET
If step-down DC/DC is configured by BD9305AFVM, Pch FET is necessary; if step-up DC/DC is configured by
BD9306AFVM, Nch FET is necessary.
Please pay attention to the following conditions when you choose.
＜ step-down DC/DC ＞
Maximum inductor current I OMAX ＋ ⊿ I L
2
＜
FET’s rated current
Power supply voltage VCC
＜
FET’s rated voltage
Power supply voltage
Gate capacity ( ※ )
＜ step-up DC/DC ＞
Maximum inductor current
Maximum output voltage
Power supply voltage
VCC
C GATE
I INMAX ＋ ⊿ I L
2
V OMAX
VCC
＞
＜
＜
＜
＞
FET’s gate ON voltage
2000pF
FET’s rated current
FET’s rated voltage
FET’s gate ON voltage
Gate capacity ( ※ ) C GATE
＜
2000pF
Furthermore, each parameter has a deviation of 30%~40%, so please design in such a way that you have left a sufficient
margin for deviation in your design.
( ※ ) If Gate capacity becomes large, the switch’s switching speed gets slow, which may cause generation of heat and breakdown,
so please check thoroughly with actual devices.
www.rohm.com
? 2009 ROHM Co., Ltd. All rights reserved.
9/14
2009.05 - Rev.A
相关PDF资料 |
PDF描述 |
|---|---|
| BD9328EFJ-E2 | IC REG BUCK SYNC ADJ 2A 8HTSOP |
| BD9329AEFJ-E2 | IC REG BUCK SYNC ADJ 3A 8HTSOP |
| BD9533EKN-E2 | IC REG SW VAR SOFT START 20-HQFN |
| BD95513MUV-E2 | IC REG BUCK ADJ 3A 32VQFN |
| BD9701T-V5 | IC REG BUCK ADJ 1.5A TO220FP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| BD9306AFVM | 制造商:ROHM 制造商全称:Rohm 功能描述:Single-output Step-up,High-efficiency Switching Regulator(Controller Type) |
| BD9306AFVM-TR | 功能描述:直流/直流开关调节器 4.2-18V 100-800kHz 1 Chan Step-Up RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| BD9322EFJ | 功能描述:IC REG BUCK SYNC ADJ 2A 8HTSOP RoHS:是 类别:集成电路 (IC) >> PMIC - 稳压器 - DC DC 开关稳压器 系列:- 产品培训模块:High Efficiency Current Mode Switching Regulators CMOS LDO Regulators 特色产品:BD91x Series Step-Down Regulators 标准包装:2,500 系列:- 类型:降压（降压） 输出类型:两者兼有 输出数:2 输出电压:3.3V，0.8 V ~ 2.5 V 输入电压:4.5 V ~ 5.5 V PWM 型:电流模式 频率 - 开关:1MHz 电流 - 输出:1.5A 同步整流器:是 工作温度:-40°C ~ 85°C 安装类型:表面贴装 封装/外壳:20-VFQFN 裸露焊盘 包装:带卷 (TR) 供应商设备封装:VQFN020V4040 产品目录页面:1373 (CN2011-ZH PDF) 其它名称:BD9152MUV-E2TR |
| BD9322EFJ-E2 | 功能描述:直流/直流开关调节器 4.75-18V; 380kHz; 2A 1Ch Stp-Dwn w/MOSFET RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
| BD9323EFJ-E2 | 功能描述:直流/直流开关调节器 4.75-18V; 380kHz; 3A 1Ch Stp-Dwn w/MOSFET RoHS:否 制造商:International Rectifier 最大输入电压:21 V 开关频率:1.5 MHz 输出电压:0.5 V to 0.86 V 输出电流:4 A 输出端数量: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:PQFN 4 x 5 |
发布紧急采购，3分钟左右您将得到回复。