参数资料
| 型号： | CAT25320YI-GT3 |
| 厂商： | ON Semiconductor |
| 文件页数： | 7/19页 |
| 文件大小： | 0K |
| 描述： | IC EEPROM SER 32KB 10MHZ 8TSSOP |
| 标准包装： | 1 |
| 格式 - 存储器： | EEPROMs - 串行 |
| 存储器类型： | EEPROM |
| 存储容量： | 32K (4K x 8) |
| 速度： | 10MHz |
| 接口： | SPI 3 线串行 |
| 电源电压： | 1.8 V ~ 5.5 V |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 8-TSSOP（0.173"，4.40mm 宽） |
| 供应商设备封装： | 8-TSSOP |
| 包装： | 标准包装 |
| 产品目录页面： | 808 (CN2011-ZH PDF) |
| 其它名称： | CAT25320YI-GT3DKR |
CAT25320
Status Register
The Status Register, as shown in Table 10, contains a
number of status and control bits.
The RDY (Ready) bit indicates whether the device is busy
with a write operation. This bit is automatically set to 1 during
an internal write cycle, and reset to 0 when the device is ready
to accept commands. For the host, this bit is read only.
The WEL (Write Enable Latch) bit is set/reset by the
WREN/WRDI commands. When set to 1, the device is in a
Write Enable state and when set to 0, the device is in a Write
Disable state.
The BP0 and BP1 (Block Protect) bits determine which
blocks are currently write protected. They are set by the user
with the WRSR command and are non ? volatile. The user is
Table 10. STATUS REGISTER
allowed to protect a quarter, one half or the entire memory,
by setting these bits according to Table 11. The protected
blocks then become read ? only.
The WPEN (Write Protect Enable) bit acts as an enable for
the WP pin. Hardware write protection is enabled when the
WP pin is low and the WPEN bit is 1. This condition
prevents writing to the status register and to the block
protected sections of memory. While hardware write
protection is active, only the non ? block protected memory
can be written. Hardware write protection is disabled when
the WP pin is high or the WPEN bit is 0. The WPEN bit, WP
pin and WEL bit combine to either permit or inhibit Write
operations, as detailed in Table 12.
7
WPEN
6
0
5
0
4
0
3
BP1
2
BP0
1
WEL
0
RDY
Table 11. BLOCK PROTECTION BITS
Status Register Bits
BP1
0
0
1
1
BP0
0
1
0
1
Array Address Protected
None
0C00 ? 0FFF
0800 ? 0FFF
0000 ? 0FFF
Protection
No Protection
Quarter Array Protection
Half Array Protection
Full Array Protection
Table 12. WRITE PROTECT CONDITIONS
WPEN
0
0
1
1
X
X
WP
X
X
Low
Low
High
High
WEL
0
1
0
1
0
1
Protected Blocks
Protected
Protected
Protected
Protected
Protected
Protected
Unprotected Blocks
Protected
Writable
Protected
Writable
Protected
Writable
Status Register
Protected
Writable
Protected
Protected
Protected
Writable
http://onsemi.com
7
相关PDF资料 |
PDF描述 |
|---|---|
| AX250-2FGG256I | IC FPGA AXCELERATOR 250K 256FBGA |
| M1AFS600-2FG256I | IC FPGA 4MB FLASH 600K 256-FBGA |
| 24VL024HT/SN | IC EEPROM 2KBIT 400KHZ 8SOIC |
| 24LC32AT-I/MNY | IC EEPROM 32KBIT 400KHZ 8TDFN |
| 93C86BT-I/OT | IC EEPROM 16KBIT 3MHZ SOT23-6 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT25-330JA | 功能描述:电阻器网络与阵列 33ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25-330JALF | 功能描述:电阻器网络与阵列 33ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25331JA | 制造商:Bourns Inc 功能描述: |
| CAT25-331JA | 功能描述:电阻器网络与阵列 330ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
| CAT25-331JALF | 功能描述:电阻器网络与阵列 330ohm 5% Concave 8resistors RoHS:否 制造商:Vishay/Thin Film 产品类型:Networks 电路类型:Divider 电阻器数量: 电阻数值:10 kOhms 容差:0.1 % 温度系数: 管脚数量:3 工作温度范围:- 55 C to + 155 C 尺寸:1.02 mm W x 3.05 mm L x 1.4 mm H 引线间隔: 端接类型:SMD/SMT 封装:Reel |
发布紧急采购，3分钟左右您将得到回复。