参数资料
型号: CAT34TS02VP2IGT4
厂商: ON Semiconductor
文件页数: 15/21页
文件大小: 194K
描述: IC TEMP SENSOR WITH MEMORY 8TDFN
标准包装: 4,000
功能: 温度监控系统(传感器)
传感器类型: 内部
感应温度: -20°C ~ 125°C
精确度: ±3°C
拓扑: ADC,比较器,寄存器库
输出类型: 2 线串行,I²C?/SMBUS?
输出警报:
输出风扇:
电源电压: 3 V ~ 3.6 V
工作温度: -20°C ~ 125°C
安装类型: 表面贴装
封装/外壳: 8-WFDFN 裸露焊盘
供应商设备封装: 8-TDFN(2x3)
包装: 带卷 (TR)
CAT34TS02
http://onsemi.com
15
Table 11. CONFIGURATION REGISTER
B15
B14
B13
B12
B11
B10
B9
B8
RFU
RFU
RFU
RFU
RFU
HYST [1:0]
SHDN
B7
B6
B5
B4
B3
B2
B1
B0
TCRIT_LOCK
EVENT_LOCK
CLEAR
EVENT_STS
EVENT_CTRL
TCRIT_ONLY
EVENT_POL
EVENT_MODE
Bit
Description
B15:B11
Reserved for future use; can not be written; should be ignored; will read as 0
B10:B9 (Note 12)
00:
Disable hysteresis
01:
Set hysteresis at 1.5癈
10:
Set hysteresis at 3癈
11:
Set hysteresis at 6癈
B8 (Note 16)
0:
Thermal Sensor is enabled; temperature readings are updated at sampling rate
1:
Thermal Sensor is shut down; temperature reading is frozen to value recorded before SHDN
B7 (Note 15)
0:
Critical trip register can be updated
1:
Critical trip register cannot be modified; this bit can be cleared only at POR
B6 (Note 15)
0:
Alarm trip registers can be updated
1:
Alarm trip registers cannot be modified; this bit can be cleared only at POR
B5 (Note 14)
0:
Always reads as 0 (selfclearing)
1:
Writing a 1 to this position clears an event recording in interrupt mode only
B4 (Note 13)
0:
EVENT output pin is not being asserted
1:
EVENT output pin is being asserted
B3 (Note 12)
0:
EVENT output disabled; polarity dependent
: opendrain for B1 = 0; grounded for B1 = 1
1:
EVENT output enabled
B2 (Note 18)
0:
event condition triggered by alarm or critical temperature limit crossing
1:
event condition triggered by critical temperature limit crossing only
B1 (Notes 12, 17)
0:
EVENT output active low
1:
EVENT output active high
B0 (Note 12)
0:
Comparator mode
1:
Interrupt mode
12.Can not be altered (set or cleared) as long as either one of the two lock bits, B6 or B7 is set.
13.This bit is a polarity independent
 software copy of the EVENT
 pin, i.e. it is under the control of B3. This bit is readonly.
14.Writing a 1 to this bit clears an event condition in Interrupt mode, but has no effect in comparator mode. When read, this bit always returns
0. Once the measured temperature exceeds the critical limit, setting this bit has no effect (see Figure 33).
15.Cleared at power-on reset (POR). Once set, this bit can only be cleared by a POR condition.
16.The TS powers up into active mode, i.e. this bit is cleared at power-on reset (POR). When the TS is shut down the ADC is disabled and the
temperature reading is frozen to the most recently recorded value. The TS can not be shut down (B8 can not be set) as long as either one
of the two lock bits, B6 or B7 is set. However, the bit can be cleared at any time.
17.The EVENT
 output is open-drain and requires an external pull-up resistor for either polarity. The natural polarity is active low, as it allows
wired-or operation on the EVENT bus.
18.Can not be set as long as lock bit B6 is set.
相关PDF资料
PDF描述
NCP502SQ30T1G IC REG LDO 3V .18A SC70-5
HAZ151MBABRBKR CAP CER 150PF 1KV 20% RADIAL
NCP502SQ28T1G IC REG LDO 2.8V .18A SC70-5
TAP686K010SRW CAP TANT 68UF 10V 10% RADIAL
GEM10DRXH CONN EDGECARD 20POS DIP .156 SLD
相关代理商/技术参数
参数描述
CAT34TS04 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Digital Output Temperature Sensor with On-board SPD EEPROM
CAT34TS04EVP2GT4A 功能描述:TEMPERATURE SENSOR WITH 制造商:on semiconductor 系列:- 零件状态:在售 传感器类型:数字,本地 检测温度 - 本地:-20°C ~ 125°C 检测温度 - 远程:- 输出类型:I2C/SMBus 电压 - 电源:2.2 V ~ 5.5 V 分辨率:12 b 特性:输出开关,可编程极限,可编程分辨率,待机模式 精度 - 最高(最低):±1°C(±3°C) 测试条件:75°C ~ 95°C(-20°C ~ 125°C) 工作温度:-45°C ~ 130°C 安装类型:表面贴装 标准包装:4,000
CAT34TS04HU4GT4A 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Digital Output Temperature Sensor with On-board SPD EEPROM
CAT34TS04VP2GT4A 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:Digital Output Temperature Sensor with On-board SPD EEPROM
CAT34WC02 制造商:CATALYST 制造商全称:Catalyst Semiconductor 功能描述:2-kb I2C Serial EEPROM, Serial Presence Detect