- 您现在的位置：买卖IC网 > Datasheet目录318 > CAT3614HV2-T2 (ON Semiconductor)IC LED DRVR WHITE BCKLGT 12-TDFN Datasheet资料下载
参数资料
| 型号： | CAT3614HV2-T2 |
| 厂商： | ON Semiconductor |
| 文件页数： | 10/12页 |
| 文件大小： | 0K |
| 描述： | IC LED DRVR WHITE BCKLGT 12-TDFN |
| 标准包装： | 1 |
| 拓扑： | 切换式电容器（充电泵） |
| 输出数： | 4 |
| 内部驱动器： | 是 |
| 类型 - 主要： | 背光 |
| 类型 - 次要： | 白色 LED |
| 频率： | 800kHz ~ 1.3MHz |
| 电源电压： | 3 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 12-WFDFN 裸露焊盘 |
| 供应商设备封装： | 12-TDFN（3x3） |
| 包装： | 标准包装 |
| 工作温度： | -40°C ~ 85°C |
| 产品目录页面： | 805 (CN2011-ZH PDF) |
| 其它名称： | CAT3614HV2-T2DKR |
CAT3614
LED Current Setting
Figure 2 shows the timing diagram necessary at the
EN/DIM input for setting the LED currents.
The EN/DIM set up time requires the signal to be held
high for 10 m s or longer to ensure the initialization of the
driver at power ? up. Each subsequent pulse on the EN/DIM
(300 ns to 200 m s pulse duration) steps down the LED
current from full scale of 31 mA to zero with a 1 mA
resolution. Consecutive pulses should be separated by
300 ns or longer. Pulsing beyond the 0 mA level restores the
current level back to full scale and the cycle repeats. Pulsing
frequencies from 5 kHz up to 1 MHz can be supported
during dimming operations. When the EN/DIM is held low
for 1.5 ms or more, the CAT3614 enters the shutdown mode
and draws “zero” current.
For applications with three LEDs or less, any unused LED
pins should be tied to VOUT, as shown on Figure 28.
Protection Mode
If an LED becomes open ? circuit, the output voltage
VOUT is internally limited to about 5.5 V. This is to prevent
the output pin from exceeding its absolute maximum rating.
The driver enters a thermal shutdown mode as soon as the
die temperature exceeds about +165 ° C. When the device
temperature drops down by about 20 ° C, the device resumes
normal operation.
External Components
The driver requires a total of four external 1 m F ceramic
capacitors: two for decoupling input and output, and two for
the charge pump. Both capacitor types X5R and X7R are
recommended for the LED driver application. In the 1.5x
charge pump mode, the input current ripple is kept very low
by design, and an input bypass capacitor of 1 m F is sufficient.
In 1x mode, the device operating in linear mode does not
introduce switching noise back onto the supply.
Recommended Layout
In 1.5x charge pump mode, the driver switches internally
at a high frequency of 1 MHz. It is recommended to
minimize trace length to all four capacitors. A ground plane
should cover the area under the driver IC as well as the
bypass capacitors. Short connection to ground on capacitors
Cin and Cout can be implemented with the use of multiple
vias. A copper area matching the TDFN exposed pad (GND)
must be connected to the ground plane underneath. The use
of multiple vias improves the package heat dissipation.
1 m F
1 m F
1 m F
1 m F
V IN
3 V to
5.5 V
C IN
1 m F
ENABLE/
DIMMING
C1+ C1 ? C2+
VIN
CAT3614
EN/DIM
GND
C2 ?
VOUT
LED1
LED2
LED3
LED4
C OUT
1 m F
V IN
3 V to
5.5 V
C IN
1 m F
ENABLE/
DIMMING
C1+ C1 ? C2+
VIN
CAT3614
EN/DIM
GND
C2 ?
VOUT
LED1
LED2
LED3
LED4
C OUT
1 m F
Flash
LED
120 mA
Figure 28. Three LED Application
Figure 29. Single Flash LED Application
http://onsemi.com
10
相关PDF资料 |
PDF描述 |
|---|---|
| CAT3616HV4-GT2 | IC LED DRVR WHITE BCKLGT 16-TQFN |
| CAT3636HV3-GT2 | IC LED DVR 6CH QUAD MODE 16TQFN |
| CAT3643HV2-T2 | IC LED DRVR WHITE BCKLGT 12-TDFN |
| CAT3644HV3-GT2 | IC LED DVR 4CH QUAD MODE 16TQFN |
| CAT3647HV3-GT2 | IC LED DRVR WHITE BCKLGT 16-TQFN |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CAT3616 | 制造商:ONSEMI 制造商全称:ON Semiconductor 功能描述:6-Channel Charge Pump LED Driver with EZDim |
| CAT3616_08 | 制造商:CATALYST 制造商全称:Catalyst Semiconductor 功能描述:6-Channel Charge Pump LED Driver with EZDimTM |
| CAT3616HV4 | 制造商:CATALYST 制造商全称:Catalyst Semiconductor 功能描述:6-Channel Charge Pump LED Driver with EZDimTM |
| CAT3616HV4-GT2 | 功能描述:LED照明驱动器 LED Driver,Charge pump,6 ch RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
| CAT3616HV4-T2 | 功能描述:LED照明驱动器 LED Driver,Charge pump,6 ch RoHS:否 制造商:STMicroelectronics 输入电压:11.5 V to 23 V 工作频率: 最大电源电流:1.7 mA 输出电流: 最大工作温度: 安装风格:SMD/SMT 封装 / 箱体:SO-16N |
发布紧急采购，3分钟左右您将得到回复。