- 您现在的位置：买卖IC网 > PDF目录3791 > COP8CBR9KMT8 (National Semiconductor)IC MCU EEPROM 8BIT 32K 56-TSSOP PDF资料下载
参数资料
| 型号： | COP8CBR9KMT8 |
| 厂商： | National Semiconductor |
| 文件页数： | 77/111页 |
| 文件大小： | 0K |
| 描述： | IC MCU EEPROM 8BIT 32K 56-TSSOP |
| 标准包装： | 34 |
| 系列： | COP8™ 8C |
| 核心处理器： | COP8 |
| 芯体尺寸： | 8-位 |
| 速度： | 20MHz |
| 连通性： | Microwire/Plus（SPI），UART/USART |
| 外围设备： | 欠压检测/复位，POR，PWM，WDT |
| 输入/输出数： | 49 |
| 程序存储器容量： | 32KB（32K x 8） |
| 程序存储器类型： | 闪存 |
| RAM 容量： | 1K x 8 |
| 电压 - 电源 (Vcc/Vdd)： | 2.7 V ~ 5.5 V |
| 数据转换器： | A/D 16x10b |
| 振荡器型： | 内部 |
| 工作温度： | -40°C ~ 85°C |
| 封装/外壳： | 56-TFSOP（0.240"，6.10mm 宽） |
| 包装： | 管件 |
| 其它名称： | *COP8CBR9KMT8 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页第43页第44页第45页第46页第47页第48页第49页第50页第51页第52页第53页第54页第55页第56页第57页第58页第59页第60页第61页第62页第63页第64页第65页第66页第67页第68页第69页第70页第71页第72页第73页第74页第75页第76页当前第77页第78页第79页第80页第81页第82页第83页第84页第85页第86页第87页第88页第89页第90页第91页第92页第93页第94页第95页第96页第97页第98页第99页第100页第101页第102页第103页第104页第105页第106页第107页第108页第109页第110页第111页
SNOS535I – OCTOBER 2000 – REVISED MARCH 2013
5.13.9 DIAGNOSTIC
Bits CHL0 and CHL1 in the ENU register provide a loopback feature for diagnostic testing of the USART.
When both bits are set to one, the following occurs: The receiver input pin (RDX) is internally connected to
the transmitter output pin (TDX); the output of the Transmitter Shift Register is “looped back” into the
Receive Shift Register input. In this mode, data that is transmitted is immediately received. This feature
allows the processor to verify the transmit and receive data paths of the USART.
Note that the framing format for this mode is the nine bit format; one Start bit, nine data bits, and one or
two Stop bits. Parity is not generated or verified in this mode.
5.13.10 ATTENTION MODE
The USART Receiver section supports an alternate mode of operation, referred to as ATTENTION Mode.
This mode of operation is selected by the ATTN bit in the ENUR register. The data format for transmission
must also be selected as having nine Data bits and either one or two Stop bits.
The ATTENTION mode of operation is intended for use in networking the device with other processors.
Typically in such environments the messages consists of device addresses, indicating which of several
destinations should receive them, and the actual data. This Mode supports a scheme in which addresses
are flagged by having the ninth bit of the data field set to a 1. If the ninth bit is reset to a zero the byte is a
Data byte.
While in ATTENTION mode, the USART monitors the communication flow, but ignores all characters until
an address character is received. Upon receiving an address character, the USART signals that the
character is ready by setting the RBFL flag, which in turn interrupts the processor if USART Receiver
interrupts are enabled. The ATTN bit is also cleared automatically at this point, so that data characters as
well as address characters are recognized. Software examines the contents of the RBUF and responds by
deciding either to accept the subsequent data stream (by leaving the ATTN bit reset) or to wait until the
next address character is seen (by setting the ATTN bit again).
Operation of the USART Transmitter is not affected by selection of this Mode. The value of the ninth bit to
be transmitted is programmed by setting XBIT9 appropriately. The value of the ninth bit received is
obtained by reading RBIT9. Since this bit is located in ENUR register where the error flags reside, a bit
operation on it will reset the error flags.
5.13.11 BREAK GENERATION
To generate a line break, the user software should set the BRK bit in the ENUI register. This will force the
TDX pin to 0 and hold it there until the BRK bit is reset.
5.14 A/D Converter
This device contains a 16-channel, multiplexed input, successive approximation, 10 bit Analog-to-Digital
Converter. Pins AVCC and AGND are used for the voltage reference.
5.14.1 OPERATING MODES
It supports both Single Ended and Differential modes of operation.
Two specific analog channel selection modes are supported. These are as follows:
1. Allow any specific channel to be selected at one time. The A/D Converter performs the specific
conversion requested and stops.
2. Allow any differential channel pair to be selected at one time. The A/D Converter performs the specific
differential conversion requested and stops.
In both Single Ended and Differential modes, there is the capability to connect the analog multiplexor
output and A/D converter input to external pins. This provides the ability to externally connect a common
filter/signal conditioning circuit for the A/D Converter.
68
Functional Description
Copyright 2000–2013, Texas Instruments Incorporated
相关PDF资料 |
PDF描述 |
|---|---|
| COP8CBR9HLQ8 | IC MCU CMOS 8BIT 44LLP |
| MC9S08SH32VTJ | MCU 8BIT 32K FLASH 20-TSSOP |
| MC9S08SH32VTG | MCU 8BIT 32K FLASH 16-TSSOP |
| MC9S08SH16VWL | MCU 8BIT 16K FLASH 28-SOIC |
| MC9S08SH16VTL | MCU 8BIT 16K FLASH 28-TSSOP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| COP8CBR9LVA8 | 功能描述:IC MCU EEPROM 8BIT 32K 68PLCC RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:COP8™ 8C 其它有关文件:STM32F101T8 View All Specifications 特色产品:STM32 32-bit Cortex MCUs 标准包装:490 系列:STM32 F1 核心处理器:ARM? Cortex?-M3 芯体尺寸:32-位 速度:36MHz 连通性:I²C，IrDA，LIN，SPI，UART/USART 外围设备:DMA，PDR，POR，PVD，PWM，温度传感器，WDT 输入/输出数:26 程序存储器容量:64KB（64K x 8） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:10K x 8 电压 - 电源 (Vcc/Vdd):2 V ~ 3.6 V 数据转换器:A/D 10x12b 振荡器型:内部 工作温度:-40°C ~ 85°C 封装/外壳:36-VFQFN，36-VFQFPN 包装:托盘 配用:497-10030-ND - STARTER KIT FOR STM32497-8853-ND - BOARD DEMO STM32 UNIV USB-UUSCIKSDKSTM32-PL-ND - KIT IAR KICKSTART STM32 CORTEXM3497-8512-ND - KIT STARTER FOR STM32F10XE MCU497-8505-ND - KIT STARTER FOR STM32F10XE MCU497-8304-ND - KIT STM32 MOTOR DRIVER BLDC497-6438-ND - BOARD EVALUTION FOR STM32 512K497-6289-ND - KIT PERFORMANCE STICK FOR STM32MCBSTM32UME-ND - BOARD EVAL MCBSTM32 + ULINK-MEMCBSTM32U-ND - BOARD EVAL MCBSTM32 + ULINK2更多... 其它名称:497-9032STM32F101T8U6-ND |
| COP8CCE9 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:8-Bit CMOS Flash Microcontroller with 8k Memory, Virtual EEPROM, 10-Bit A/D and Brownout Reset |
| COP8CCE9HLQ7 | 制造商:NSC 制造商全称:National Semiconductor 功能描述:8-Bit CMOS Flash Microcontroller with 8k Memory, Virtual EEPROM, 10-Bit A/D and Brownout Reset |
| COP8CCE9HLQ9 | 功能描述:IC MCU FLASH 8BIT 8K A/D 44LLP RoHS:否 类别:集成电路 (IC) >> 嵌入式 - 微控制器， 系列:COP8™ 8C 标准包装:250 系列:56F8xxx 核心处理器:56800E 芯体尺寸:16-位 速度:60MHz 连通性:CAN，SCI，SPI 外围设备:POR，PWM，温度传感器，WDT 输入/输出数:21 程序存储器容量:40KB（20K x 16） 程序存储器类型:闪存 EEPROM 大小:- RAM 容量:6K x 16 电压 - 电源 (Vcc/Vdd):2.25 V ~ 3.6 V 数据转换器:A/D 6x12b 振荡器型:内部 工作温度:-40°C ~ 125°C 封装/外壳:48-LQFP 包装:托盘 配用:MC56F8323EVME-ND - BOARD EVALUATION MC56F8323 |
| COP8CCE9HVA7 | 功能描述:8位微控制器 -MCU RoHS:否 制造商:Silicon Labs 核心:8051 处理器系列:C8051F39x 数据总线宽度:8 bit 最大时钟频率:50 MHz 程序存储器大小:16 KB 数据 RAM 大小:1 KB 片上 ADC:Yes 工作电源电压:1.8 V to 3.6 V 工作温度范围:- 40 C to + 105 C 封装 / 箱体:QFN-20 安装风格:SMD/SMT |
发布紧急采购，3分钟左右您将得到回复。