- 您现在的位置：买卖IC网 > PDF目录28816 > CPC1590PTR (CLARE INC) PDF资料下载
参数资料
| 型号： | CPC1590PTR |
| 厂商： | CLARE INC |
| 元件分类： | 光电耦合器 |
| 中文描述： | 1 CHANNEL FET OUTPUT OPTOCOUPLER |
| 封装： | ROHS COMPLIANT, FLATPACK-8 |
| 文件页数： | 8/10页 |
| 文件大小： | 372K |
| 代理商： | CPC1590PTR |
CPC1590
R00B
PRELIMINARY
7
4. Device Configuration
4.1 LED resistor
The input resistor is required to limit LED current to a
value set by Recommended Operating Conditions in
cases, higher LED operating current would improve
driver speed; however, this higher current could also
reduce LED lifespan, which would cause reliability
issues.
The general equation used to calculate the resistor
value is:
I
F = Input Control Current
V
OL = Low-level output of the driving logic gate or the
collector-emitter voltage of the driving logic transis-
tor. (This parameter is provided in the manufacturer’s
data sheet.)
V
IN = Input Power Source
V
F = Forward Voltage Drop of LED
R
LED = Input Resistor
When calculating the resistor value, the designer
should take into consideration power-supply
variations, which can range about ±10%, temperature
variations from -40°C to +85°C, LED forward voltage
drop over the temperature range, and the resistor’s
tolerance and temperature stability rating.
When the LED resistor value is selected by the above
formula, the RLED power dissipation, PD, can be
obtained from the following equation:
With power dissipation calculated, it is now possible to
select an appropriate resistor size that can be used in
the particular application circuit. It is recommended
that a resistor with at least twice the calculated power
rating should be selected.
4.2 Storage Capacitor
The storage capacitor (CST) enables the gate driver to
turn on a power MOSFET faster by delivering a
reservoir of charge to the gate. Selection of the
storage capacitor is given by the following equation:
This equation shows that the storage capacitor needs
to deliver enough charge to the gate while only
dropping 0.5V. The CPC1590 can deliver 32nC of
charge at rated operating speed, and will operate with
much larger loads, >4nF, with slower turn-on and
turn-off times.
The CPC1590 has an internal J-FET, which is used to
regulate the voltage applied to the storage capacitor.
The voltage applied to the storage capacitor will be
2
3
1
4
NC
8
5
6
7
CPC1590
V
CAP
+V
LOAD
V
G
-V
LOAD
C
ST
V
D
V
S
R
LED
V
IN
LOAD
RLED =
VIN - (VF + VOL)
IF
PD = IF
2 R
LED
CST > QG / 0.5V
相关PDF资料 |
PDF描述 |
|---|---|
| CPC1726Y | |
| CPC1788J | |
| CPC1961GSTR | |
| CPC1961GS | |
| CPC1963GSTR | |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CPC1593 | 制造商:IXYS 制造商全称:IXYS Corporation 功能描述:Single-Pole, Normally Open OptoMOS?? Relay Integrated Current Limit with Voltage and Thermal Protection |
| CPC1593G | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin DIP RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC1593GS | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin SM RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC1593GSTR | 功能描述:固态继电器-PCB安装 1-Form-A 600V 6-Pin SM T/R RoHS:否 制造商:Omron Electronics 控制电压范围: 负载电压额定值:40 V 负载电流额定值:120 mA 触点形式:1 Form A (SPST-NO) 输出设备:MOSFET 封装 / 箱体:USOP-4 安装风格:SMD/SMT |
| CPC15AC | 功能描述:板上安装压力/力传感器 ASG/SENSYM 130 - CPC,CPCL RoHS:否 制造商:Honeywell 工作压力:0 bar to 4 bar 压力类型:Gage 准确性:+ / - 0.25 % 输出类型:Digital 安装风格:Through Hole 工作电源电压:5 V 封装 / 箱体:SIP 端口类型:Dual Radial Barbed, Same sides |
发布紧急采购，3分钟左右您将得到回复。