参数资料
| 型号： | CS8130-CS |
| 厂商： | Cirrus Logic Inc |
| 文件页数： | 19/28页 |
| 文件大小： | 0K |
| 描述： | IC IR TRANSCEIVER 2-5V 20-SSOP |
| 标准包装： | 66 |
| 类型： | 收发器 |
| 电源电压： | 2.7 V ~ 5.5 V |
| 安装类型： | 表面贴装 |
| 封装/外壳： | 20-SSOP（0.209"，5.30mm 宽） |
| 供应商设备封装： | 20-SSOP |
| 包装： | 管件 |
| 产品目录页面： | 758 (CN2011-ZH PDF) |
| 配用： | 598-1161-ND - BOARD EVAL FOR CS8130 |
| 其它名称： | 598-1203-5 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页第15页第16页第17页第18页当前第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页
Digital Pins
RXD - Receiver Data Output
Receiver output data. Normally connected to RxD on the UART.
TXD - Transmit Data Input
Transmitter input data. Normally connected to TxD on the UART.
D/C - Data/Control Mode Input
The D/C pin determines whether the input data on TXD is treated as data to be transmitted via
the LED, or as control information to set up the CS8130 internal registers. The D/C pin also
can act as a power down control.
FORM/BSY - Received Data Format Output/Busy Signal Output
If auto format detect mode is enabled, this pin indicates the format of the incoming data.
FORM is low for ASK format data, and high for IRDA/HPSIR format data.
In TV remote data mode (Mode 3), this pin becomes a handshake signal to the UART.
FORM/BSY low means OK to send a character. FORM/BSY high means "I am busy, do not
send another character".
PWRDN - Power Down Control Input
PWRDN low places the CS8130 into a very low power consumption "off" state.
RESET - Reset Input
RESET low places all the internal logic into a known state. All the control register bits are
forced high or low, as defined in the register definition section. If the crystal oscillator is in use,
then RESET must be held low for >25 ms, with PWRDN high and power applied. If an
external clock is used, then the RESET pulse can be short (>1
s).
XTALIN, XTALOUT - Crystal Connections
To use the internal oscillator, connect either a 3.6864 MHz or a 1.8432 MHz crystal between
XTALOUT and XTALIN. If using an external clock, connect XTALIN to DGND.
EXTCLK - External Clock Input or Output
If no crystal is present on XTALIN and XTALOUT, EXTCLK becomes an input. A
3.6864 MHz or 1.8432 MHz clock should be connected to EXTCLK. XTALIN should be
connected to DGND.
If a crystal is present on XTALIN and XTALOUT, EXTCLK becomes an output. EXTCLK will
output the same frequency as the crystal. The EXTCLK output driver may be disabled to
conserve power.
CLKFR - Clock Frequency Select Input
Tie CLKFR to ground to select a 3.6864 MHz clock. Connect CLKFR to the VD+ pin to select
a 1.8432 MHz clock.
CS8130
26
DS134PP2
CS8130
26
DS134F1
相关PDF资料 |
PDF描述 |
|---|---|
| CS8190EDWF20G | IC TACH/SPEEDO DRVR PREC 20SOICW |
| CS8191XNF16 | IC DRVR AIRCORE TACH/SPEED 16DIP |
| CS82C5296 | IC UART/BRG 5V 16MHZ 28-PLCC |
| CS82C59A-1296 | IC CTRL INTERRUPT 12.5MHZ 28PLCC |
| CS8900A-IQZ | IC LAN ETHERNET CTLR 5V 100LQFP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CS8130-CSR | 功能描述:红外收发器 IC Multi-Standard Infrared Transceiver RoHS:否 制造商:Vishay Semiconductors 波长:900 nm 连续数据传输:115.2 Kbit/s 传输距离:1 m 辐射强度:60 mW/sr 半强度角度:44 deg 脉冲宽度:2 us 最大上升时间:100 ns 最大下降时间:100 ns LED 电源电压:- 0.5 V to 6 V 最大正向电流:80 mA 工作电压:2.4 V to 5.5 V 最大工作温度:+ 85 C 最小工作温度:- 25 C 尺寸:6 mm x 3.1 mm x 1.9 mm 封装 / 箱体: 封装:Reel |
| CS8130-CSZ | 功能描述:红外收发器 IC Multi-Standard Infrared Transceiver RoHS:否 制造商:Vishay Semiconductors 波长:900 nm 连续数据传输:115.2 Kbit/s 传输距离:1 m 辐射强度:60 mW/sr 半强度角度:44 deg 脉冲宽度:2 us 最大上升时间:100 ns 最大下降时间:100 ns LED 电源电压:- 0.5 V to 6 V 最大正向电流:80 mA 工作电压:2.4 V to 5.5 V 最大工作温度:+ 85 C 最小工作温度:- 25 C 尺寸:6 mm x 3.1 mm x 1.9 mm 封装 / 箱体: 封装:Reel |
| CS8130-CSZR | 功能描述:红外收发器 IC Multi-Standard Infrared Transceiver RoHS:否 制造商:Vishay Semiconductors 波长:900 nm 连续数据传输:115.2 Kbit/s 传输距离:1 m 辐射强度:60 mW/sr 半强度角度:44 deg 脉冲宽度:2 us 最大上升时间:100 ns 最大下降时间:100 ns LED 电源电压:- 0.5 V to 6 V 最大正向电流:80 mA 工作电压:2.4 V to 5.5 V 最大工作温度:+ 85 C 最小工作温度:- 25 C 尺寸:6 mm x 3.1 mm x 1.9 mm 封装 / 箱体: 封装:Reel |
| CS8130-IS | 制造商:Cirrus Logic 功能描述:IRDA TX/RX 0.1152MBPS 2.7V TO 5.5V 20SSOP - Rail/Tube |
| CS8130-ISR | 制造商:Cirrus Logic 功能描述:IRDA TX/RX 0.1152MBPS 2.7V TO 5.5V 20SSOP - Tape and Reel |
发布紧急采购，3分钟左右您将得到回复。