- 您现在的位置：买卖IC网 > Datasheet目录218 > CUB4TC00 (Red Lion Controls)METER PANEL LCD THERMOCOUPLE Datasheet资料下载
参数资料
| 型号： | CUB4TC00 |
| 厂商： | Red Lion Controls |
| 文件页数： | 7/8页 |
| 文件大小： | 0K |
| 描述： | METER PANEL LCD THERMOCOUPLE |
| 标准包装： | 1 |
| 系列： | CUB4 |
| 类型： | 热电偶 |
| 显示器类型： | LCD |
| 显示器正面尺寸： | 2.95" L x 1.54" W（74.9 x 39.1mm） |
| 显示器位数： | 5 |
| 显示器位数 - 高度： | 0.480"（12.19mm） |
| 背光： | 无 |
| 安装类型： | 面板安装 |
| 端子： | 螺钉端子 |
| 电源电压： | 9 V ~ 26 V |
| 其它名称： | Q1421239 Q763911 |
INSTALLATION
The meter meets NEMA 4X/IP65 requirements for indoor use,
when properly installed. The units are intended to be mounted on an
enclosed panel. The viewing window and buttons are factory sealed
for a wash down environment. A sponge rubber gasket and
mounting clip are provided for sealing the unit in the panel cut-out.
Installation Environment
The unit should be installed in a location that does not
exceed the maximum operating temperature and
provides good air circulation. Placing the unit near
devices that generate excessive heat should be avoided.
The bezel should be cleaned only with a soft cloth and
neutral soap product. Do NOT use solvents.
Continuous exposure to direct sunlight may accelerate
the aging process of the bezel.
Do not use tools of any kind (screwdrivers, pens, pencils, etc.) to
operate the buttons of this unit.
The following procedure assures proper installation:
1. Cut the panel opening to the specified dimensions. Remove burrs and clean
around the panel opening.
2. Carefully slide the panel gasket over the rear of the unit to the back of the
bezel.
3. Assemble the nut fastener and mounting screw onto both sides of the
mounting clip. The tip of the screw should not project from the hole in the
mounting clip.
4. Install the unit through the panel cut-out until the front bezel flange contacts
the panel.
5. Slide the mounting clip over the rear of the unit until the mounting clip is
against the back of the panel. The mounting clip has latching features which
engage into mating features on the housing.
6. Alternately tighten each screw to ensure uniform gasket pressure. Visually
inspect the front panel gasket. The gasket should be compressed to about 75
to 80% of its original thickness. (Recommended torque is 28 to 36 in-oz.) If
not, gradually turn the mounting screws to further compress the gasket.
7. If the gasket is not adequately compressed, and the mounting screws can no
longer be turned, loosen the mounting screws and check that the mounting
clip is latched as close as possible to the panel.
Repeat the procedure for tightening the mounting screws.
APPLICATION FOR CUB4RT
Relative Temperature Error Display
A customer desires to display the difference between the actual
temperature of an oven and the desired temperature of 475.0°F. If the
temperature of the oven is 464.8°F, the display should read -10.2°F. A
Pt392 type RTD is used.
The user offset capability of the CUB4RT allows for this type of
temperature indication.
Desired oven temp = 475.0°F, set offset for -475.0. Unit will display
the temperature relative to 475.0°F.
Programming:
tYPE = pt392
dIsp = 0.0 ° F
FLtEr = 1
rANGE = 5 ° F
OFSEt = - 475.0 ° F
7
相关PDF资料 |
PDF描述 |
|---|---|
| CUB5COM1 | RS485 SERIAL COMMO CARD |
| CUB5IB00 | DC METER RED/GREEN BKLT |
| CUB5PB00 | PROCESS METER RED/GREEN BKLT |
| CUB5RTR0 | RTD METER REFLECTIVE |
| CUB5TCB0 | METER PANEL LCD THERMOCOUPLE RED |
相关代理商/技术参数 |
参数描述 |
|---|---|
| CUB4V000 | 功能描述:METER LCD DC VOLT 3.5DIG RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:CUB4 标准包装:12 系列:* 其它名称:Q7072030 |
| CUB4V-000 | 制造商:Red Lion Controls 功能描述:Voltage Meter 制造商:Red Lion Controls 功能描述:VOLTAGE METER; No. of Digits / Alpha:3-1/2; Meter Function:DC Millivolts / DC Volts; Meter Range:-199.9mV to +199.9mV / -1.999V to +1.999V / -19.99V to +19.99V / -199.9V to +199.9V; Digit Height:15.2mm; Panel Cutout Height:33.02mm ;RoHS Compliant: Yes |
| CUB4V010 | 功能描述:METER LCD DC VOLT 3.5DIG Y/G BCK RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:CUB4 标准包装:12 系列:* 其它名称:Q7072030 |
| CUB4V020 | 功能描述:METER LCD DC VOLT 3.5DIG RED BCK RoHS:是 类别:工业控制，仪表 >> 仪表 - 面板，数字 系列:CUB4 标准包装:12 系列:* 其它名称:Q7072030 |
| CUB-51-70010 | 功能描述:时间延迟和计时继电器 120VAC 1 - 10SEC 10AMP RoHS:否 制造商:Crydom 显示器类型:Hand Dial 电源电压:280 VAC 定时范围: 触点形式: 触点额定值:6 A 端接类型:DIN Rail |
发布紧急采购，3分钟左右您将得到回复。