- 您现在的位置：买卖IC网 > PDF目录170654 > DAC7625U/1KG4 (TEXAS INSTRUMENTS INC) PARALLEL, WORD INPUT LOADING, 5 us SETTLING TIME, 12-BIT DAC, PDSO28 PDF资料下载
参数资料
| 型号： | DAC7625U/1KG4 |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | DAC |
| 英文描述： | PARALLEL, WORD INPUT LOADING, 5 us SETTLING TIME, 12-BIT DAC, PDSO28 |
| 封装： | GREEN, SOIC-28 |
| 文件页数： | 5/19页 |
| 文件大小： | 473K |
| 代理商： | DAC7625U/1KG4 |
13
DAC7724, 7725
ANALOG OUTPUTS
When VSS = –15V (dual supply operation), the output
amplifier can swing to within 4V of the supply rails, guar-
anteed over the –40
°C to +85°C temperature range. With
VSS = 0V (single-supply operation) and RLOAD connected to
ground, the output can swing to ground. Note that the
settling time of the output op-amp will be longer with
voltages very near ground. Additionally, care must be taken
when measuring the zero-scale error when VSS = 0V. Since
the output voltage cannot swing below ground, the output
voltage may not change for the first few digital input codes
(000H, 001H, 002H, etc.) if the output amplifier has a nega-
tive offset. At the negative offset limit of –4 LSB (-9.76mV),
for the single-supply case, the first specified output starts at
code 004H.
REFERENCE INPUTS
For dual-supply operation, the reference inputs, VREFL and
VREFH, can be any voltage between VSS + 4V and VCC – 4V
provided that VREFH is at least 1.25V greater than VREFL.
For single-supply operation (VSS = 0V), VREFL value can be
above 0V, with the same provision that VREFH is at least
1.25V greater than VREFL. The minimum output of each
DAC is equal to VREFL plus a small offset voltage (essen-
tially, the offset of the output op-amp). The maximum
output is equal to VREFH plus a similar offset voltage. Note
that VSS (the negative power supply) must either be con-
nected to ground or must be in the range of –14.25V to
–15.75V. The voltage on VSS sets several bias points within
the converter, if VSS is not in one of these two configura-
tions, the bias values may be in error and proper operation
of the device is not guaranteed.
The current into the VREFH input and out of VREFL depends
on the DAC output voltages and can vary from a few
microamps to approximately 0.3mA. The reference input
appears as a varying load to the reference. If the reference
can sink or source the required current, a reference buffer is
not required. See “Reference Current vs Code” in the Typi-
cal Performance Curves.
The analog supplies (or the analog supplies and the refer-
ence power supplies) have to come up first. If the power
supplies for the references come up first, then the VCC and
VSS supplies will be “powered from the reference via the
ESD protection diodes” (see page 4).
Bypassing the reference voltage or voltages with at least a
0.1uF capacitor placed as close to the DAC7724/25 package
is strongly recommended.
FIGURE 3. Basic Dual-Supply Operation of the DAC7724/25.
1
2
3
4
V
REFH
V
OUTB
Load DAC Registers
Reset DACs(1)
V
OUTA
V
SS
5
GND
6
RESET
7
8
9
10
11
12
13
14
LDAC
DB0
DB1
DB2
DB3
DB4
DB5
DB6
V
REFL
V
OUTC
DAC7724
DAC7725
V
OUTD
V
CC
28
27
26
25
V
DD
24
CS
23
A0
A1
R/W
DB11
DB10
DB9
DB8
DB7
22
21
20
19
18
17
16
15
Chip Select
–10V to +10V
Read/Write
Data Bus
Address Bus
or Decoder
NOTE: (1) Reset LOW sets all DACs to code 800
H on the DAC7724 and to code 000H on the DAC7725.
–10.000V
0.1
F
–10V to +10V
–15V
+10.000V
0.1
F
0.1
F
1
F to 10F
+
Data Bus
+15V
0.1
F
1
F to 10F
+
+5V
0.1
F
1
F to 10F
+
相关PDF资料 |
PDF描述 |
|---|---|
| DAC7643VFBTG4 | PARALLEL, WORD INPUT LOADING, 8 us SETTLING TIME, 16-BIT DAC, PQFP32 |
| DAC7654YTG4 | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PQFP64 |
| DAC7714U | QUAD, SERIAL INPUT LOADING, 8 us SETTLING TIME, 12-BIT DAC, PDSO16 |
| DAC7801LUG4 | PARALLEL, 8 BITS INPUT LOADING, 0.4 us SETTLING TIME, 12-BIT DAC, PDSO24 |
| DAC7800LU | SERIAL INPUT LOADING, 0.4 us SETTLING TIME, 12-BIT DAC, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DAC7625UB | 功能描述:数模转换器- DAC 12-Bit Quad Voltage Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| DAC7625UB | 制造商:Texas Instruments 功能描述:Digital/Analog Converter IC Interface Ty |
| DAC7625UB/1K | 功能描述:数模转换器- DAC 12-Bit Quad Voltage Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| DAC7625UB/1KG4 | 功能描述:数模转换器- DAC 12-Bit Quad Voltage Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| DAC7625UBG4 | 功能描述:数模转换器- DAC 12-Bit Quad Voltage Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
发布紧急采购，3分钟左右您将得到回复。