- 您现在的位置：买卖IC网 > PDF目录170654 > DAC8554IPW (TEXAS INSTRUMENTS INC) SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 PDF资料下载
参数资料
| 型号： | DAC8554IPW |
| 厂商： | TEXAS INSTRUMENTS INC |
| 元件分类： | DAC |
| 英文描述： | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 |
| 封装： | GREEN, PLASTIC, TSSOP-16 |
| 文件页数： | 15/31页 |
| 文件大小： | 1039K |
| 代理商： | DAC8554IPW |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页
www.ti.com
DAC8554 to 68HC11 Interface
MICROPROCESSOR INTERFACING
DAC8554 to 8051 Interface
68HC11
(1)
PC7
SCK
MOSI
SYNC
SCLK
D
IN
(1)Additionalpinsomittedforclarity.
DAC8554
80C51/80L51
(1)
P3.3
TXD
RXD
SYNC
SCLK
D
IN
(1)Additionalpinsomittedforclarity.
DAC8554
DAC8554 to TMS320 DSP Interface
DAC8554 to Microwire Interface
Microwire
TM
CS
SK
SO
SYNC
SCLK
D
IN
(1)Additionalpinsomittedforclarity.
DAC8554
MicrowireisaregisteredtrademarkofNationalSemiconductor.
DAC8554
TMS320DSP
SYNC
D
IN
SCLK
0.1 F
m
10 F
m
0.1 F
m
1mFto10mF
PositiveSupply
FSX
DX
CLKX
AV
DD
OutputA
OutputD
V
D
OUT
V
A
OUT
V
H
REF
V
L
REF
GND
Reference
Input
SLAS431B – JUNE 2005 – REVISED OCTOBER 2006
Figure 52 shows a serial interface between the
DAC8554 and the 68HC11 microcontroller. SCK of
the 68HC11 drives the SCLK of the DAC8554, while
See Figure 50 for a serial interface between the
the MOSI output drives the serial data line of the
DAC8554 and a typical 8051-type microcontroller.
DAC. The SYNC signal is derived from a port line
The setup for the interface is as follows: TXD of the
(PC7), similar to the 8051 diagram.
8051 drives SCLK of the DAC8554, while RXD
drives the serial data line of the device. The SYNC
signal is derived from a bit-programmable pin on the
port of the 8051. In this case, port line P3.3 is used.
When data are to be transmitted to the DAC8554,
P3.3 is taken LOW. The 8051 transmits data in 8-bit
bytes; thus, only eight falling clock edges occur in
the transmit cycle. To load data to the DAC, P3.3 is
left LOW after the first eight bits are transmitted, then
a second and third write cycle are initiated to
Figure 52. DAC8554 to 68HC11 Interface
transmit the remaining data. P3.3 is taken HIGH
following the completion of the third write cycle. The
8051 outputs the serial data in a format that presents
The 68HC11 should be configured so that its CPOL
the LSB first, while the DAC8554 requires its data
bit is '0' and its CPHA bit is '1'. This configuration
with the MSB as the first bit received. The 8051
causes data appearing on the MOSI output to be
transmit routine must therefore take this into account,
valid on the falling edge of SCLK. When data are
and mirror the data as needed.
being transmitted to the DAC, the SYNC line is held
LOW (PC7). Serial data from the 68HC11 are
transmitted in 8-bit bytes with only eight falling clock
edges occurring in the transmit cycle. (Data are
transmitted MSB first.) In order to load data to the
DAC8554, PC7 is left LOW after the first eight bits
are transferred, then a second and third serial write
operation are performed to the DAC. PC7 is taken
HIGH at the end of this procedure.
Figure 50. DAC8554 to 80C51/80L51 Interface
Figure 53 shows the connections between the
DAC8554 and a TMS320 digital signal processor
(DSP). A single DSP can control up to four
Figure 51 shows an interface between the DAC8554
DAC8554s without any interface logic.
and any Microwire-compatible device. Serial data are
shifted out on the falling edge of the serial clock and
clocked into the DAC8554 on the rising edge of the
SK signal.
Figure 51. DAC8554 to Microwire Interface
Figure 53. DAC8554 to TMS320 DSP
22
相关PDF资料 |
PDF描述 |
|---|---|
| DAC8564IAPWR | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 |
| DAC8564IBPW | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 |
| DAC8564ICPWR | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 |
| DAC8564IDPW | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 |
| DAC8564IAPWG4 | SERIAL INPUT LOADING, 12 us SETTLING TIME, 16-BIT DAC, PDSO16 |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DAC8554IPWG4 | 功能描述:数模转换器- DAC 16-Bit Quad Ch UltLo Glitch Vltg Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| DAC8554IPWR | 功能描述:数模转换器- DAC 16-Bit Quad Ch UltLo Glitch Vltg Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| DAC8554IPWRG4 | 功能描述:数模转换器- DAC 16-Bit Quad Ch UltLo Glitch Vltg Output RoHS:否 制造商:Texas Instruments 转换器数量:1 DAC 输出端数量:1 转换速率:2 MSPs 分辨率:16 bit 接口类型:QSPI, SPI, Serial (3-Wire, Microwire) 稳定时间:1 us 最大工作温度:+ 85 C 安装风格:SMD/SMT 封装 / 箱体:SOIC-14 封装:Tube |
| DAC8555 | 制造商:BB 制造商全称:BB 功能描述:16-BIT, QUAD CHANNEL, ULTRALOW GLITCH, VOLTAGE OUTPUT DIGITAL-TO-ANALOG CONVERTER |
| DAC8555EVM | 功能描述:数据转换 IC 开发工具 QUAD CH. DAC RoHS:否 制造商:Texas Instruments 产品:Demonstration Kits 类型:ADC 工具用于评估:ADS130E08 接口类型:SPI 工作电源电压:- 6 V to + 6 V |
发布紧急采购，3分钟左右您将得到回复。