- 您现在的位置：买卖IC网 > PDF目录16612 > DC1561A (Linear Technology)EVAL BOARD FOR LTC4278 PDF资料下载
参数资料
| 型号： | DC1561A |
| 厂商： | Linear Technology |
| 文件页数： | 15/42页 |
| 文件大小： | 0K |
| 描述： | EVAL BOARD FOR LTC4278 |
| 设计资源： | DC1561A Design Files |
| 标准包装： | 1 |
| 主要目的： | 电源管理，以太网供电（POE） |
| 嵌入式： | 否 |
| 已用 IC / 零件： | LTC4278 |
| 已供物品： | 板 |
第1页第2页第3页第4页第5页第6页第7页第8页第9页第10页第11页第12页第13页第14页当前第15页第16页第17页第18页第19页第20页第21页第22页第23页第24页第25页第26页第27页第28页第29页第30页第31页第32页第33页第34页第35页第36页第37页第38页第39页第40页第41页第42页
LTC4278
22
4278fc
compensation circuitry. The logic block also contains
circuitry to control the special dynamic requirements of
flyback control. For more information on the basics of
current mode switcher/controllers and isolated flyback
converters see Application Note 19.
Feedback Amplifier—Pseudo DC Theory
For the following discussion, refer to the simplified
Switching Regulator Feedback Amplifier diagram (Figure
10A).Whentheprimary-sideMOSFETswitchMPturnsoff,
itsdrainvoltagerisesabovetheVPORTPrail.Flybackoccurs
when the primary MOSFET is off and the synchronous
secondary MOSFET is on. During flyback the voltage on
nondriventransformerpinsisdeterminedbythesecondary
voltage. The amplitude of this flyback pulse, as seen on
the third winding, is given as:
VFLBK =
VOUT + ISEC ESR + RDS(ON)
(
)
NSF
RDS(ON) = on-resistance of the synchronous MOSFET MS
ISEC = transformer secondary current
ESR = impedance of secondary circuit capacitor, winding
and traces
NSF = transformer effective secondary-to-flyback winding
turns ratio (i.e., NS/NFLBK)
The flyback voltage is scaled by an external resistive
divider R1/R2 and presented at the FB pin. The feedback
amplifier compares the voltage to the internal bandgap
reference.Thefeedbackampisactuallyatransconductance
amplifier whose output is connected to VCMP only during
a period in the flyback time. An external capacitor on
the VCMP pin integrates the net feedback amp current to
provide the control voltage to set the current mode trip
point. The regulation voltage at the FB pin is nearly equal
to the bandgap reference VFB because of the high gain in
the overall loop. The relationship between VFLBK and VFB
is expressed as:
VFLBK =
R1
+R2
R2
VFB
APPLICATIONS INFORMATION
Combining this with the previous VFLBK expression yields
an expression for VOUT in terms of the internal reference,
programming resistors and secondary resistances:
VOUT =
R1+R2
R2
VFB NSF
ISEC ESR+RDS(ON)
(
)
The effect of nonzero secondary output impedance is
discussed in further detail (see Load Compensation
Theory).Thepracticalaspectsofapplyingthisequationfor
VOUT are found in subsequent sections of the Applications
Information.
Feedback Amplifier Dynamic Theory
So far, this has been a pseudo-DC treatment of flyback
feedback amplifier operation. But the flyback signal is a
pulse, not a DC level. Provision is made to turn on the
flyback amplifier only when the flyback pulse is present,
using the enable signal as shown in the timing diagram
(Figure 10b).
Minimum Output Switch On Time (tON(MIN))
The LTC4278 affects output voltage regulation via flyback
pulse action. If the output switch is not turned on, there
is no flyback pulse and output voltage information is
not available. This causes irregular loop response and
start-up/latchup problems. The solution is to require the
primary switch to be on for an absolute minimum time per
each oscillator cycle. To accomplish this the current limit
feedbackisblankedeachcyclefortON(MIN).Iftheoutputload
is less than that developed under these conditions, forced
continuous operation normally occurs. See subsequent
discussions in the Applications Information section for
further details.
Enable Delay Time (ENDLY)
The flyback pulse appears when the primary-side switch
shutsoff.However,ittakesafinitetimeuntilthetransformer
primary-side voltage waveform represents the output
voltage. This is partly due to rise time on the primary-
side MOSFET drain node, but, more importantly, is due
相关PDF资料 |
PDF描述 |
|---|---|
| VE-B32-EW | CONVERTER MOD DC/DC 15V 100W |
| H3AAH-6406M | IDC CABLE - HSC64H/AE64M/HSC64H |
| L-07C43NKV6T | CER INDUCTOR 43NH 0402 |
| EBC22DREI-S13 | CONN EDGECARD 44POS .100 EXTEND |
| ECO-S1EA562BA | CAP ALUM 5600UF 25V 20% SNAP |
相关代理商/技术参数 |
参数描述 |
|---|---|
| DC1561B | 功能描述:EVAL BOARD FOR LTC4278 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:- 标准包装:1 系列:- 主要目的:数字电位器 嵌入式:- 已用 IC / 零件:AD5258 主要属性:- 次要属性:- 已供物品:板 相关产品:AD5258BRMZ1-ND - IC POT DGTL I2C1K 64P 10MSOPAD5258BRMZ10-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ100-ND - IC POT DGTL I2C 100K 64P 10MSOPAD5258BRMZ50-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ1-R7-ND - IC POT DGTL I2C 1K 64P 10MSOPAD5258BRMZ10-R7-ND - IC POT DGTL I2C 10K 64P 10MSOPAD5258BRMZ50-R7-ND - IC POT DGTL I2C 50K 64P 10MSOPAD5258BRMZ100-R7-ND - IC POT DGTL I2C 100K 64P 10MSOP |
| DC1561W | 制造商:Aleph America Corporation 功能描述: |
| DC1561W-COM | 制造商:Aleph America Corporation 功能描述: |
| DC1562A-A | 功能描述:BOARD EVAL LTC6990 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:TimerBlox® 标准包装:1 系列:- 主要目的:电信，线路接口单元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要属性:T1/J1/E1 LIU 次要属性:- 已供物品:板，电源，线缆，CD 其它名称:82EBV2081 |
| DC1562A-B | 功能描述:BOARD EVAL LTC6991 RoHS:是 类别:编程器，开发系统 >> 评估演示板和套件 系列:TimerBlox® 标准包装:1 系列:- 主要目的:电信，线路接口单元（LIU） 嵌入式:- 已用 IC / 零件:IDT82V2081 主要属性:T1/J1/E1 LIU 次要属性:- 已供物品:板，电源，线缆，CD 其它名称:82EBV2081 |
发布紧急采购，3分钟左右您将得到回复。