参数资料
型号: DPZ128X16IHY-17M
厂商: TWILIGHT TECHNOLOGY INC
元件分类: PROM
英文描述: 128K X 16 FLASH 12V PROM MODULE, 170 ns, QFP48
封装: HERMETIC SEALED, CERAMIC, GULLWING, MODULE, SLCC-48
文件页数: 15/16页
文件大小: 1082K
代理商: DPZ128X16IHY-17M
DPZ128X16IY/IIY/IJY/IHY/IA3
Dense-Pac Microsystems, Inc.
PROGRAMMING CYCLE 9
ADDRESS
CE
OE
WE
DATA I/O
5.0V
VDD
0V
VPPH
VPP
VPPL
Alternative
Write Timing
CE
WE
NOTES:
1. Each SLCC contains two FLASH memory devices enabled by
separate chip enables. Typically this module would be used as a
x16 device with CE0 and CE1 tied together. When writing
commands to the Command Register under these conditions, the
command shown in the Command Definition Table should be
duplicated to each byte (I/O0 - I/O7, I/O8 - I/O15) of the module.
If the command to be written is 40H like that for Setup
Program/Program, 4040H would be written to the module followed
by the 16 bit data. A single device can be programmed or erased
by writing the appropriate command to the device the operation is
to be performed on while 00H is written to the other devices that
are enabled at the same time.
Care must be taken when doing Program Verify on a single device.
Make certain that no other devices are driving the data bus of the
devices that are not being verified but are enabled along with the
device that is being verified. Any device that is enabled during
Program Verify will be driving the data bus with the data that is
programmed at that address.
2. All voltages are with respect to VSS.
3. -2.0V min. for pulse width less than 20ns (VIL min. = -0.5V at DC
level).
4. Maximum DC voltage on VPP or A9 may over shoot to +14.0V for
periods less than 20ns.
5. Output shorted for no more than 1 second. No more than one
output shorted at a time.
6. Stresses greater than those under
ABSOLUTE MAXIMUM
RATINGS may cause permanent damage to the device. This is a
stress rating only and functional operation of the device at these or
any other conditions above those indicated in the operational
sections of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
reliability.
7. This parameter is guaranteed and not 100% tested.
8. Transition is measured at the point of ±500mV from steady state
voltage.
9. Chip Enable Controlled Writes: Write operations are driven by
the valid combination of Chip Enable and Write Enable. In systems
where Chip Enable defines the write pulse width (within a longer
Write Enable timing waveform)
all Set-up, Hold, and inactive Write
Enable times should be measured relative to the Chip Enable
waveform.
30A071-13
REV. D
8
相关PDF资料
PDF描述
DPZ128X32VI-25M 512K X 8 FLASH 12V PROM MODULE, 250 ns, CPGA66
DQ1260-680M-B 1 ELEMENT, 68 uH, GENERAL PURPOSE INDUCTOR, SMD
DQ1280-4R7M-B 1 ELEMENT, 4.7 uH, GENERAL PURPOSE INDUCTOR, SMD
DQ6530-150M 1 ELEMENT, 15 uH, GENERAL PURPOSE INDUCTOR, SMD
DQ6530-221M-B 1 ELEMENT, 220 uH, GENERAL PURPOSE INDUCTOR, SMD
相关代理商/技术参数
参数描述
DQ1001-7R 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 5.1V 20A 102W - Bulk
DQ1001-9R 功能描述:EURO-CASSETTE 82W 5.1V RoHS:否 类别:电源 - 外部/内部(非板载) >> DC DC Converters 系列:* 标准包装:1 系列:Quint 类型:隔离 输入电压:24V 输出:24V 输出数:1 输出 - 1 @ 电流(最大):24 VDC @ 50A 输出 - 2 @ 电流(最大):- 输出 - 3 @ 电流(最大):- 输出 - 4 @ 电流(最大):- 功率(瓦特):1200W 安装类型:底座安装 工作温度:0°C ~ 40°C 效率:- 封装/外壳:模块 尺寸/尺寸:4.33" L x 9.09" W x 6.14" H(110mm x 231mm x 156mm) 包装:散装 电源(瓦特)- 最大:1200W 批准:- 其它名称:277-69722866365-NDQUINT-BAT/24DC/12AH
DQ1101-7 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 3.3V 25A 82W - Bulk
DQ1101-9 功能描述:EURO-CASSETTE 66W 3.3V RoHS:否 类别:电源 - 外部/内部(非板载) >> DC DC Converters 系列:* 标准包装:1 系列:Quint 类型:隔离 输入电压:24V 输出:24V 输出数:1 输出 - 1 @ 电流(最大):24 VDC @ 50A 输出 - 2 @ 电流(最大):- 输出 - 3 @ 电流(最大):- 输出 - 4 @ 电流(最大):- 功率(瓦特):1200W 安装类型:底座安装 工作温度:0°C ~ 40°C 效率:- 封装/外壳:模块 尺寸/尺寸:4.33" L x 9.09" W x 6.14" H(110mm x 231mm x 156mm) 包装:散装 电源(瓦特)- 最大:1200W 批准:- 其它名称:277-69722866365-NDQUINT-BAT/24DC/12AH
DQ1260 制造商:MA-COM 制造商全称:M/A-COM Technology Solutions, Inc. 功能描述:SMD Shielded Base Plate Power Inductor Series