参数资料
型号: DS1388Z-3+
厂商: Maxim Integrated Products
文件页数: 16/19页
文件大小: 0K
描述: IC RTC I2C W/CHARGER 8-SOIC
产品培训模块: Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program
标准包装: 48
类型: 时钟/日历
特点: EEPROM,闰年,监控器,涓流充电器,监视计时器
存储容量: 512B
时间格式: HH:MM:SS:hh(12/24 小时)
数据格式: YY-MM-DD-dd
接口: I²C,2 线串口
电源电压: 2.7 V ~ 3.3 V
电压 - 电源,电池: 1.3 V ~ 5.5 V
工作温度: -40°C ~ 85°C
安装类型: 表面贴装
封装/外壳: 8-SOIC(0.154",3.90mm 宽)
供应商设备封装: 8-SOIC
包装: 管件
产品目录页面: 1434 (CN2011-ZH PDF)
I2C RTC/Supervisor with Trickle Charger
and 512 Bytes EEPROM
6
Maxim Integrated
DS1388
WARNING: Under no circumstances are negative undershoots, of any
amplitude, allowed when device is in write protection.
Note 2:
Limits at -40°C are guaranteed by design and are not production tested.
Note 3:
All voltages are referenced to ground.
Note 4:
Measured at VCC = typ, VBACKUP = 0V, register 0Ah, block 0h = A5h.
Note 5:
The use of the 250
Ω trickle-charge resistor is not allowed at VCC > 3.63V and should not be enabled.
Note 6:
Measured at VCC = typ, VBACKUP = 0V, register 0Ah, block 0h = A6h.
Note 7:
Measured at VCC = typ, VBACKUP = 0V, register 0Ah, block 0h = A7h.
Note 8:
The RST pin has an internal 50k
Ω pullup resistor to VCC.
Note 9:
ICCA—SCL clocking at max frequency = 400kHz.
Note 10: Specified with I2C bus inactive.
Note 11: Measured with a 32.768kHz crystal attached to X1 and X2.
Note 12: After this period, the first clock pulse is generated.
Note 13: A device must internally provide a hold time of at least 300ns for the SDA signal (referred to the VIHMIN of the SCL signal)
to bridge the undefined region of the falling edge of SCL.
Note 14: The maximum tHD:DAT need only be met if the device does not stretch the LOW period (tLOW) of the SCL signal.
Note 15: A fast-mode device can be used in a standard-mode system, but the requirement tSU:DAT ≥ 250ns must then be met. This
is automatically the case if the device does not stretch the LOW period of the SCL signal. If such a device does stretch the
LOW period of the SCL signal, it must output the next data bit to the SDA line tR(MAX) + tSU:DAT = 1000 + 250 = 1250ns
before the SCL line is released.
Note 16: CB—total capacitance of one bus line in pF.
Note 17: The parameter tOSF is the period of time that the oscillator must be stopped for the OSF flag to be set over the voltage
range of 0V
≤ VCC ≤ VCC(MAX) and 1.3V ≤ VBACKUP ≤ 3.7V.
Note 18: If the oscillator is disabled or stopped, RST goes inactive after tRST plus the startup time of the oscillator.
相关PDF资料
PDF描述
DS1388Z-33+ IC RTC I2C W/CHARGER 8-SOIC
MCP4632T-104E/MF IC DGTL POT 100K 128TAPS 10-DFN
DS1307N+ IC RTC SERIAL 512K IND 8-DIP
DS1302N+ IC TIMEKEEPER T-CHARGE IND 8-DIP
MCP4552T-502E/MF IC DGTL POT 5K 256TAPS 8-DFN
相关代理商/技术参数
参数描述
DS1388Z-3+ 功能描述:实时时钟 I2C RTC/Supervisor w/Trickle Charger RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1388Z-3+T&R 制造商:Maxim Integrated Products 功能描述:2WIRE RTC 3V,SUPRVSR &EPROM PB-F TR - Tape and Reel 制造商:Maxim Integrated Products 功能描述:IC RTC I2C W/CHARGER 8-SOIC
DS1388Z-3+T&R 功能描述:实时时钟 I2C RTC/Supervisor w/Trickle Charger RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1388Z-33 功能描述:实时时钟 RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube
DS1388Z-33+ 功能描述:实时时钟 I2C RTC/Supervisor w/Trickle Charger RoHS:否 制造商:Microchip Technology 功能:Clock, Calendar. Alarm RTC 总线接口:I2C 日期格式:DW:DM:M:Y 时间格式:HH:MM:SS RTC 存储容量:64 B 电源电压-最大:5.5 V 电源电压-最小:1.8 V 最大工作温度:+ 85 C 最小工作温度: 安装风格:Through Hole 封装 / 箱体:PDIP-8 封装:Tube